ITE M#
PROJECT
5 Gallon Iced Tea Brewer
Features
Iced Tea Brewer
Large-capacity fresh iced tea brewing solution with simple operation
• Brews 28.5 gallons (107.9 litres) per hour from real tea leaves.
• Patented iced tea brewers generate top profits through large volume sales.
• Brews directly into any style portable server.
• Meet your volume needs; brew either 3 or 5 gallons (11.36 to 18.93 litres) of iced tea
at a time.
• Can be set up to brew concentrate only for easier transport.
• SplashGard® funnel deflects hot liquids away from the hand.
• Quickbrew (Q) model for shorter brewing cycles.
Model TU5Q
(shown with TDO-5 Dispenser)
(dispensers sold separately)
Dimensions: 38.5”H x 11.5”W x 24”D
(97.8cm H x 29.2cm W x 60.96cm D)
DATE
For current specification sheets and other information, go to www.bunn.com.
Related Products
Easy Clear® EQHP-TEA
Product No. : 39000.0007
Easy Clear® EQHP-TEACRTG
Replacement Cartridge
Product No. : 39000.1007
Single/Dual Filter Pack
Product No. : 20100.0000
Packed per case: 500
Dimensions:
51⁄4" Base x
(13.34 cm Base x 9.52 cm Sidewall)
33⁄4" Sidewall
Model Agency Listing
TU5Q
TDO-5 – Tea Dispenser
Product No. : 34100.0003
Capacity: 5 gallons (18.9 L)
Weight: 14 lbs. (6.35 kg)
Dimensions:
22.1”H x 10.6”W x 13.6”D
(56.13 cm H x 26.92 cm W x 34.5 cm D)
TD4T – Tea Dispenser
Product No. : 03250.0004
Capacity: 4 gallons (15.1 L)
Weight: 14 lbs. (6.8 kg)
Dimensions:
21.9” H x 9” W x 13” D
(
55.63 cm H x 22.86 cm W x 33.02 cm D)
U
L
LISTED
TDS-5 – Tea Dispenser
Product No. : 33000.0001
Capacity: 5 gallons (18.9 L)
Weight: 12 lbs. (5.4 kg)
Dimensions:
25.6”H x 9.8”W x 14.8”D
(65cm H x 37.8cm W x 37.6cm D)
9/10
B2
Dimensions & Specifications
Model Product # Volts Amps Tank Heater Total Brewing Cu. Shipping Cord
Watts Watts Capacity Ft. Weight Attached
TU5Q 24400.0000 120 15 1800 1800 28.5 gal./hr. 8.8 ft3 51 lbs. Yes*
*
Power cord (NEMA 5-15P) 15 Amp-120V machine only.
Electrical: Model requires 2-wires plus ground service rated at 120V, single phase, 60 Hz.
Plumbing: 20-90 psi (138-621 kPa). Machine supplied with 1⁄4" OD male flare fitting. Requires minimum 1.25GPM water flow.
8.4
19.4
9.6
ON
DILUTION
3 GALLON
OFF
NO DILUTION
START
5 GALLON
READY
.2
WARNING
Fill water tank before turning-on
thermostat or connecting appliance
to power source.
Use only on a properly protected
circuit capable of the rated load.
Electrically ground the chassis.
Follow national/local electrical codes.
Do not use near combustibles.
FAILURE TO COMPLY RISKS EQUIPMENT
DAMAGE, FIRE, OR SHOCK HAZARD
READ THE ENTIRE OPERATING MANUAL
BEFORE USING THIS PRODUCT
THIS APPLIANCE IS HEATED WHENEVER
CONNECTED TO A POWER SOURCE
00831.0000F 03/98 1988 BUNN-O-MATIC CORPORATION
This equipment is to be installed to
comply with the Basic Plumbing Code of
the Building Officials and Code
Administrators International, Inc. (BOCA)
and the Food Service Sanitation Manual
of the Food and Drug Administration (FDA)
2.5
WATER SUPPLY
CONNECTION
(.250 OD TUBE
X 45• FLARE)
c
2.1
9.5
FUNNEL TIP
OUTLET
TDS5
DISPENSER
SHOWN
38.5
26.4
14.6
WARNING
*FILL WATER TANK
BEFORE ENERGIZING
*DO NOT OVERLOAD
CIRCUIT
*KEEP AWAY FROM
8.06
12.1
1.10
15.62
DISPENSER
STOP
7.621.94
11.50
4.8
POWER SUPPLY
CONNECTION
7.50
1.19
21.00
Bunn-O-Matic® Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax 217-529-6644 • www.bunn.com
BUNN® practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches.
9/10 © Bunn-O-Matic Corporation