Bunn Coffee Maker ThermalServer Installation Manual

Thermal Server Cleaning Instructions
Clean once per month or as needed
1. Open the server by turning the cover counterclockwise.
4. Hold the dispenser valve with both hands and pull it out, discon­necting it from the rubber tube.
2. Disassemble the cover by remov­ing the coffee inlet and outlet retainers and balls and the air vent retainer and ball, by turning counterclockwise.
5. Completely wash all parts using a mild detergent and rinse thor­oughly. Reassemble in reverse order.
3. Turn the server upside down and place it on a solid, flat surface. Remove the two screws on the bottom cover and remove the cover.
6. Squeeze together the center sec­tion of the sight guage cover to disengage the clips and remove by lifting up and out.
7. Disconnect the sight gauge tube from the transparent elbow and remove the tube by lifting up and out. Take care not to pull the elbow away from the server.
32330.0000B 09/06 © 1999 Bunn-O-Matic Corporation
8. Insert the cleaning brush (#26367.0000) using a mild de­tergent into the tube and clean.
9. Clean all other surfaces with a damp disposable paper towel using a mild detergent and rinse thoroughly. NOTE - DO NOT im­merse the body of the Thermal Server in water nor clean in a dish washing machine.
Loading...