Bunn Coffee Maker FMDA-5 User Manual
INTERNATIONAL
Steam Collector
Mixing Chamber
Whipper Chamber
Receptacle
Whipper
Chamber
O-ring
Frother
Dispense
Tip
R
E
L
E
A
S
E
B
U
T
T
O
N
W
H
E
N
C
U
P
I
S
2
/
3
F
U
L
L
P
L
A
C
E
C
U
P
H
E
R
E
ITE M#
Fresh Mix Dispenser
with 5 Hoppers
Features
Fresh Mix Dispensers with 5 Hoppers
• Capacity: Five, 4-pound hoppers
• Large, lighted front graphics for merchandising
• 6.4 gallon (24.2 litres) hot water tank to meet peak serving times
• Cup clearance at 7” (17.8 cm) to accommodate common cup sizes
• Electrical and plumbing components easily accessible through front and top
• Variable speed motors allow control of product consistency in mixing
chamber (.75 to 6.6 grams of powder per second)
• High speed, heavy-duty whipper for complete product mixing
• Front of machine access to tank drain for easy service
• Key lock on the door prevents tampering
PROJECT
DATE
Dimensions: 29.3”H x 18.6”W x 21.2”D
(74.4 cm H x 47.2 cm W x 53.8 cm D)
For current specification sheets and other information, go to www.bunn.com.
Related Products
FMD-5
Easy Clear® EQ-11-TL
Product No. : 30344.1001
Easy Clear® ED-11-TL
Product No. : 30244.1001
Features deluxe whipper chambers:
1. Robust whipper to ensure full flavor yield.
2. Specially designed self cleaning mixing
chamber.
3. Exhaust fan to siphon off moisture that
can cause powder buildup.
4. Hot water dispense for easy clean-out.
5. Quick disconnecting parts for thorough
sanitizing.
International models may vary in appearance.
Single hopper
model shown.
Patents Apply
12/06
D4.1
Dimensions & Specifications
Model Product # Volts Amps Tank Heater Total Capacity Shipping Cord Agency
Watts Watts Weight Attached
FMDA-5 34900.0010 230 15 3500 3600 4.2 gal/hr.** 118 lbs. Yes
(15.9 L/hr.) (53.5 kg)
**Based on incoming water temperature of 50
Electrical: Model requires 2-wires plus ground service rated 220-240V, single phase, 50/60 hz.
Plumbing: 20-100 psi (138-690 kPa) from a 3⁄8” or larger supply line. A shut-off valve should be installed in the line
before the unit. Install a regulator in line when pressure is greater than 90 psi to reduce it to 50 psi. Supplied
with 3⁄8” male flare fitting.
o
F /10˚C
BUNN Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • USA • +1-217-529-6601 • Fax +1-217-529-2827 • www.bunn.com
BUNN® practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in centimeters. Bunn Corporation owns all copyrights relating to materials in this publication. Please contact Bunn Corporation to request permission to reproduce any portion of this publication.
Loading...