Bunn-O-Matic Corp. (“Bunn”) warrants the equipment manufactured by it to be commercially free from defects
in material and workmanship existing at the time of manufacture and appearing within one year from the date of
installation. In addition:
1.) Bunn warrants electronic circuit and/or control boards to be commercially free from defects in material and
workmanship for two years from the date of installation.
2.) Bunn warrants the compressor on refrigeration equipment to be commercially free from defects in material
and workmanship for two years from the date of installation.
3.) Bunn warrants that the grinding burrs on coffee grinding equipment will grind coffee to meet original factory
screen sieve analysis for three years from date of installation or for 30,000 pounds of coffee, whichever comes
first.
This warranty does not apply to any equipment, component or part that was not manufactured by Bunn or that,
in Bunn’s judgement, has been affected by misuse, neglect, alteration, improper installation or operation, improper
maintenance or repair, damage or casualty.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY OTHER WARRANTY, WRITTEN OR
ORAL, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF EITHER
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. The agents, dealers or employees of Bunn are
not authorized to make modifications to this warranty or to make additional warranties that are binding on Bunn.
Accordingly, statements by such individuals, whether oral or written, do not constitute warranties and should not
be relied upon.
The Buyer shall give Bunn prompt notice of any claim to be made under this warranty by telephone at (217)
529-6601 or by writing to Post Office Box 3227, Springfield, Illinois, 62708-3227. If requested by Bunn, the Buyer
shall ship the defective equipment prepaid to an authorized Bunn service location. If Bunn determines, in its sole
discretion, that the equipment does not conform to the warranty, Bunn shall repair the equipment with no charge
for parts during the warranty period and no charge for labor by a Bunn Authorized Service Representative during
the warranty period. If Bunn determines that repair is not feasible, Bunn shall, at its sole option, replace the
equipment or refund the purchase price for the equipment.
THE BUYER’S REMEDY AGAINST BUNN FOR THE BREACH OF ANY OBLIGATION ARISING OUT OF THE SALE
OF THIS EQUIPMENT, WHETHER DERIVED FROM WARRANTY OR OTHERWISE, SHALL BE LIMITED, AS
SPECIFIED HEREIN, TO REPAIR OR, AT BUNN’S SOLE OPTION, REPLACEMENT OR REFUND.
In no event shall Bunn be liable for any other damage or loss, including, but not limited to, lost profits, lost sales,
loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute
equipment, facilities or services, or any other special, incidental or consequential damages.
2
26937 022900
TABLE OF CONTENTS
TITLEPAGE NO.
Electrical and Operating Controls ................................................................................................................................................18
Faucet and Tubing .......................................................................................................................................................................16
Funnel and Filter Basket...............................................................................................................................................................24
Hood, Trunk and Panels ................................................................................................................................................................4
Motor/Sprayhead Assy and Funnel Switch/Lever Assy ..................................................................................................................6
Numerical Index ..........................................................................................................................................................................26
Strainer/Flow Control, Solenoid and Lines...................................................................................................................................14
Tank and Components.................................................................................................................................................................10
24806.00051Housing, Base (BLK)(Also order items 14 & 15)
02308.00009Screw, Pan Head-Serrated #8-32 x .375"
1412364.00001Decal, Caution - Warmers And Surfaces Are Hot
1522306.00001Decal, Red Decorative Stripe
1624805.00001Plate, Base
02332.00026Screw, Hex-Crimptite #6 x .375"
1725137.00004Foot, Black W/.250"-20
1801593.00001Bushing, Snap 1.5" Dia
1926073.10001Gasket, W/Adhesive - 21" Lg
2025309.00011Cover, Top (For shipping only)
02332.00011Screw, Hex-Crimptite #6 -.25"
5
26937 022900
BUNN
25417.0000
01370.0000
®
MOTOR/SPRAYHEAD ASSY AND FUNNEL SWITCH/ LEVER ASSY
COMBO
BREWER
10
29
4 5
3
2
1
9
6
7
8
9
10
11
12
13
14
15
16
17
28
27
30
26
18
19
20
21
25 24 23 22
P727
6
26937 022900
MOTOR/SPRAYHEAD ASSY AND FUNNEL SWITCH/ LEVER ASSY
ITEMPART NO.QTY.DESCRIPTION
125938.00001Lever, Index Motor
26458.00001Screw, Button Head #8-32 x .375"
225939.00001Shutter, Position Sensor
02361.00002Screw, Pan Head Phillips #4-40 x .25"
325949.00011Swivel, Quick Disconnect
425936.00001Link, Adjuster
02328.00042Screw, Locking Pan Head #6-32 x .312"
625424.00001Fitting Assy, Sprayhead
725940.00001Guide, Sprayhead
825440.00001Rod End W/Stud, Spherical Female #10-32
925934.00004Screw, Shoulder #10-32 x .189"
20941.10001Tank Heater, 3500W 200V (Includes item 8)
712688.00002Gasket, Water Coil
800943.00002Gasket, Tank Heater
925481.00001Tank Lid
00908.00008Nut, Hex #8-32
1029329.10001Thermostat, Limit
1100942.00002Nut, Hex .50"-20 (Tank Heater)
1202536.00001Grommet, Fill Tube
1312687.00002Nut, Hex Brass .562"-24 (Water Coil)
1400465.00011Elbow, 125" MPT x .250" Compression
1500400.00011Elbow, Male .250" Flare x .125" MPT
1625628.00001Tube Assy, Tank Fill
1720211.01001Thermal Cut-Off Assy (Thermostat to Tank Heater)
1812570.00001Grommet, Temperature Probe
1925477.00001Sprayhead Tube
00908.00003Nut, Hex #8-32
2005515.00001Gasket, Sprayhead tube
2105518.00001Hub, Syphon
2212568.00061Sensor, Temperature
2312422.00012Clamp, Hose-Snap Type .59/.66" I.D.
24--------------1Tube, Silicone .375" I.D. x .625" O.D. x 11" (Order item 32)
25--------------1Fitting Assy, Sprayhead (See Motor/Sprayhead Assy & Funnel Switch/Lever Assy)
(Continued)
11
26937 022900
BUNN
®
TANK AND COMPONENTS
COMBO
BREWER
17
16
15
14
13
12
11
10
(Continued)
22
18
19
20
23
24
9
8
7
6
23
25
26
27
5
21 29 30
4
31
6
2
1
3
28
12
P726
26937 022900
TANK AND COMPONENTS
ITEMPART NO.QTY.DESCRIPTION
2625626.00001Tube, Vent .250" O.D.
27--------------1Tube, Silicone. 250" I.D. x 2.0" (Order item 33)
2822397.00011Fitting, .25" Barb x .125" MPT
29--------------1Tube, Silicone .250" I.D. x 7.25" (Order item 33)
3012422.00003Clamp, Hose-Snap Type .47" x .54" I.D.
3100620.00001Clamp, .687" I.D.
3220976.1000-Tube, Silicone .375" I.D. x .625" O.D. x 12"
20976.1001-Tube, Silicone .375" I.D. x .625" O.D. x 36"
20976.1002-Tube, Silicone .375" I.D. x .625" O.D. x 120"
3311707.1000-Tube, Silicone .250" I.D. x 12"
11707.1001-Tube, Silicone .250" I.D. x 36"
11707.1002-Tube, Silicone .250" I.D. x 120"
13
26937 022900
BUNN
®
STRAINER - FLOW CONTROL, SOLENOID AND LINES
COMBO
BREWER
13 14 15 16
2
3
1
4
5
6
7
8
9
10
11
12
25 23
22 24
SOLENOID W/1.0" DIA COIL
14
21 20 18 19 18 17
22 23
25 24
SOLENOID W/1.48" DIA COIL
SOLENOID REPAIR PARTS
P728
26937 022900
STRAINER - FLOW CONTROL, SOLENOID AND LINES
ITEMPART NO.QTY.DESCRIPTION
124394.01951Strainer/Flow Control Assembly (.195 GPM) (Includes items 2 thru 6)
226216.00001Tube Assembly, Flow Control to Tee
320577.00011Tee, .250" Flare
421814.00161Tube Assembly, Tee to Bulkhead
526217.00001Tube Assembly, Flow Control to Bulkhead
622300.01951Strainer/Flow Control Assembly (.195 GPM)(Includes items 7 thru 12)
722249.00001Fitting, Flow Control Inlet
823721.00001Screen
9-------------1Body (Not Available. Order Item 6)
1020526.11951Flow Washer/Gasket Set (.195 GPM) (Includes item 11)
1101155.00001Gasket, Flow Control
1201154.00001Fitting, Flow Control Outlet
1300459.00002Fitting, Bulkhead .250" Flare
1401532.00002Lockwasher, Internal Tooth .438"
1500463.00002Nut, Hex .438"-20
1620690.00021Tube Assembly, Bulkhead to Coil
1712645.00021Tube Assembly, Bulkhead to Solenoid
1800402.00012Connector, Male .250" Flare x .125" MPT
19- - - - - - - -1Solenoid Valve, 120V-1.48" Dia Coil (Not available, order 01085.0002)
01085.00021Solenoid Valve, 120V-1.0" Dia Coil (Includes O-ring)
21180.00001Solenoid Valve, 200V
01327.00002Screw, Pan Head #10-32 x .375"
01502.00002Lockwasher, Split #10
2007441.00001Bracket, Solenoid Mounting
02308.00002Screw,Pan Head Serrated #8-32 x .375"
2112914.00051Tube Assembly, Solenoid to Tank
2201079.00001Solenoid Valve Base - 1.48" Dia Coil (Not available, order 01085.0002)
28479.00001Solenoid Valve Base Kit - 1.0" Dia Coil (Includes O-ring)
2301101.00001Solenoid Valve Coil, 120V (1.48" Dia Coil)
28480.00001Solenoid Valve Coil, 120V (1.0" Dia Coil)
21181.00001Solenoid Valve Coil, 200V
2401116.00001Guide - 1.48" Dia Coil
28481.00001Guide Kit - 1.0" Dia Coil (Includes Washer & O-ring)
2501111.00001Solenoid Valve Repair Kit - 1.48" Dia Coil (Includes Plunger, Seal and Spring)
01111.00021Solenoid Valve Repair Kit - 1.0" Dia Coil (Includes Plunger, Spring & O-ring)
15
26937 022900
BUNN
®
FAUCET AND TUBING
1
COMBO
BREWER
5
11 10 9 8 7 6
12
13
14
4
2 3
16
N
N
U
B
P729
26937 022900
FAUCET AND TUBING
ITEMPART NO.QTY.DESCRIPTION
125665.00001Tube Assy, Tank Coil to Faucet
213059.00001Faucet Jam Nut
301532.00001Lockwasher, Internal Tooth .438" I.D.
412915.00001Faucet Assy, Hot Water (Includes items 5 thru 14)
513061.00001Faucet Handle/Stem Assembly (Includes items 6 thru 11)
613053.00001Faucet Handle Kit (Includes item 7)
702858.00001Pin, Spring .125" Dia x .50"
813060.00001Faucet Bonnet Nut
913055.00001Faucet Spring
1013054.00001Faucet Stem
1113056.00001Faucet Seat Cup
12-------------1Body, Faucet (Not Available. Order item 4)
1313057.00001Faucet, Safety Clip
1413058.00001Faucet Aerator Kit
11438.00011Warmer Element 100W 200V
413042.00011Spacer, .174" I.D. x .188"
505212.00001Plate, Element Retaining
00970.00002Nut, Keps #8-32
6--------------2Tube, Silicone .250" Dia x 1.88" LG. (Order Item 7)
704828.1001-Tube, Silicone .250" Dia. x 24" LG (Use as required)