The Bunn logo is a registered trademark of Bunn-O-Matic Corporation.
My Café is a registered trademark of Bunn-O-Matic Corporation.
Model MCP
RECORD MODEL & SERIAL NUMBER
In order to receive accurate and timely warranty assistance, it is important to
record the Model and Serial Number information located on the bottom of the
brewer. A space is provided below for this information.
USER SERVICEABLE PARTS ................................................................................ 22
This symbol alerts you
to the risk of fire or
electrical shock in the
accompanying message.
Repair Should Be Done By Authorized Service Personnel!
WARNING
RISK OF FIRE OR ELECTRICAL SHOCK
Hazardous Voltage!
Can Cause Fire Or Electrical Shock!
Do Not Disassemble The Brewer!
There Are No User Serviceable Parts Inside!
Keep this booklet for future reference.
2
This symbol alerts
you to important
operating and service
instructions.
USER NOTICES
HOT LIQUIDS
Carefully read and follow all notices on the equipment and in this manual. They
were written for your protection. All notices on the equipment should be kept in
good condition. Replace any unreadable or damaged labels by visiting our web site
at www.bunn.com.
Risk of fire or
electrical shock.
Do not open.
No user serviceable
parts inside.
Do not immerse.
Household and
commercial type.
Repair should be done
by authorized Service
Personnel only.
AVERTISSEMENT
Risque d'incendie ou
d'électrocution.
Ne pas ouvrir.
Aucune pièce réparable
par l'utilisateur à
l'intérieur.
Ne pas immerger.
Type ménager et
commercial.
Les réparations doivent être
confiées aux personnes
qualifiées.
# 37267.0000
WARNING:
# 37280.0000
HOT LIQUIDS
Make certain the pod drawer is
securely locked into the brewer.
Failure to do so can result in a
# 37281.0000
burn hazard.
# 41936.0000
As directed in the International Plumbing Code of the
International Code Council and the Food Code
Manual of the Food and Drug Administration (FDA),
# 37282.0000
this equipment must be installed with adequate
backflow prevention to comply with federal, state
and local codes. For models installed outside the
U.S.A., you must comply with the applicable Plumbing /Sanitation Code for your area.
# 00656.0001
INTRODUCTION
The BUNN® My Café® Automatic and Pourover Tea & Coffee Pod Brewer is
designed to personalize your brewing experience by allowing a single cup brew of
perfectly balanced coffee or tea.
BUNN® brewers are recognized in homes, offices and restaurants throughout
the world as the very finest.
IMPORTANT HANDLING INFORMATION
To avoid dropping and damaging the brewer or reservoir, do not attempt to pick
the brewer up by the reservoir or lid. Always grasp the brewer by the sides, bottom,
or top and bottom of the brewer.
P3027
3
SPECIFICATIONS
Electrical (MCA/MCP)- This brewer has an attached, 3-prong grounded cord set
and requires 2-wire service with ground, rated 120 volts ac, 12 amps, single phase,
60 Hz. Components include a 1450-watt tank heater.
NOTE: Do not operate brewer on the same outlet as other electrical appliances.
Electrical (MCAA/MCPA)- This brewer has an attached, grounded cord set and
requires 2-wire service with ground, rated 220-240 volts ac, 6 amps, single phase,
50/60 Hz. Components include a 1450-watt (max.) tank heater.
NOTE: Do not operate brewer on the same outlet as other electrical appliances.
CE REQUIREMENTS
• This appliance must be installed in locations where it can be overseen by trained
personnel.
• For proper operation, this appliance must be installed where the temperature is
between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specied in conformance with all
local and national codes.
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of this appliance by a person
responsible for its safety.
• Children should be supervised to ensure they do not play with the appliance.
• If the power cord is ever damaged, it must be replaced by the manufacturer or
authorized service personnel with a special cord available from the manufacturer or
its authorized service personnel in order to avoid a hazard.
• Machine must not be immersed for cleaning.
Dimensions:
MCA/MCAA/MCPA - 13 9⁄16 in. (34.4 cm) High; 7 13⁄16 in. (19.8 cm) Wide;11
1
⁄16 in. (28 cm) Deep.
MCP - 12 7⁄16 in. (31.6 cm) High; 7 3⁄4 in. (19.7 cm) Wide;10 5⁄8 in. (27 cm) Deep.
Brew Capacity:
MCA/MCAA and MCP/MCPA - Approx. 4 to 12 oz. (118 to 355 ml) serving in one
ounce increments. Reservoir holds 46 oz. (1.7 L) of water.
Weight : Each includes pod brewer, pod holder, lid, reservoir, drip tray and drip tray grate.
Follow these basic safety precautions when using electrical appliances
to reduce the risk of fire, electric shock, and/or personal injury:
• Read all instructions.
• Do not touch hot surfaces. Use
handles or knobs.
• To protect against electric shock, do
not place cord, plug, or brewer in
water or liquid.
• Close supervision is necessary
when the brewer is used by or near
children.
• Unplug from outlet when not in use
for extended periods of time and
before cleaning. Allow to cool before
putting on or taking off parts, and
before cleaning.
• Do not operate the brewer with a
damaged cord or plug, or after the
brewer malfunctions or has been
damaged in any manner. Return the
brewer to an Authorized Service
Facility for examination, adjustment,
or repair.
• The use of an accessory not evaluated
for use with this brewer may cause
injuries and is not authorized.
• For indoor use only.
• Do not let the power cord hang over
edge of table or counter, or touch hot
surfaces.
• Do not place the brewer on or near
a hot gas or electric burner, or in a
heated oven.
• Do not use brewer for other than its
• Do not insert or remove pod holder
while brewing. Press the coffee or tea
button to stop or cancel a brew cycle.
• A canceled brew cycle is not held in
memory. The next brew cycle will
dispense full volume based on the
volume setting.
• To avoid container overow, empty
mug before each brew cycle.
• Never place hands directly under the
pod holder. Hot water and steam can
be present.
• Do not place brewer in a sink or near
other water source. Remove reservoir
and fill separately or use the slide lid.
• When the brewer is idle, the lid
should be in the closed position.
• Always use a mug or bowl that is
larger than the brew volume selected.
• Keep hands away if container
overows. Wait until brew nishes,
let liquid cool, then lower volume
setting or use a larger mug.
• Never brew without the pod holder
insert in place. Excessive pressure
on the pod could result in coffee or
tea escaping from the holder and into
the container. Hot liquid splash and
burns could occur.
• Use cold water only.
• Do not place torn pods or use ground
coffee in pod holder.
intended use.
SAVE THESE INSTRUCTIONS
• A short power-supply cord is used to reduce the risks resulting from becoming
entangled in or tripping over a longer cord.
• If an extension cord is used, the marked electrical rating of the extension cord
should be at least as great as the electrical rating of the brewer, and the cord
should be arranged so that it will not hang over the edge of the table or counter
where it can be pulled on by children or tripped over.
• The extension cord must be of the 3-pronged, 3-socketed, grounding type,
3-wire cord. (Including grounding conductor).
• If the power cord is ever damaged, it must be replaced by the manufacturer
or authorized service personnel with a special cord available form the
manufacturer or its authorized service personnel in order to avoid a hazard.
Improper electrical installation will damage electronic components. Damage
caused by incorrect electrical connections is not covered by warranty.
5
GENERAL INFORMATION
Improper installation could result in permanent damage and void the
limited warranty. Read & follow instructions on pages 10-11.
• Use CAUTION when dispensing hot water from the brewer. The water
from your BUNN® Pod brewer is approximately 200°F (93°C). This is
approximately 50°F (10°C) hotter than the hot water from your faucet and
must be handled with care.
• This brewer is designed to remain plugged in at all times (except during initial
installation, cleaning, or when brewer will not be used for an extended period of
time).
• A power switch is provided on the lower left side to completely shut off all
electrical components when your plans take you away from the brewer for three
or more days. Safety features, designed into the BUNN® Pod brewer, make the
daily use of this switch unnecessary.
• Whenever the brewer has been shut off or unplugged for an extended period of
time, rinse the reservoir and refill with fresh cold water before using. It is also
recommended that the brewer be cycled. (See page 15)
• Your BUNN® Pod brewer has a specially designed tank to keep the water inside
at the proper temperature. This constant supply of hot water assures the correct
method of brewing in less than one minute.
• When inserting a pod into the pod holder, it is important to seat the pod all the
way into the holder cavity. Leaks could occur if the pod is too large, or does not
seat completely into the holder cavity. Ensure that all of the paper edge and any
tabs of the pod are inserted into the holder cavity.
• Prior to brewing, make certain pod holder is securely locked into the brewer.
Failure to do so can result in a burn hazard.
• While brewing, the incoming water in the tank is also being heated to the proper
temperature and held until needed.
• The brewer is equipped with a 120 volt, 3-prong grounded cord set. The plug is
provided with a round grounding pin. (International brewers are equipped with
a 230 volt, grounded cord set. The plug is provided with a grounding circuit
in compliance with local requirements) This is a safety feature and allows the
plug to fit into a properly grounded outlet. If the plug does not fit into the outlet,
contact an electrician to update your outlet. Attempting to bypass the safety
aspect of this plug will void the warranty.
• The sprayhead may become loose over time. Unplug the machine and allow it
to cool down before tightening or removing the sprayhead. Use extreme caution
not to burn yourself. Tighten or remove the sprayhead with your fingertips.
CONTINUED
6
GENERAL INFORMATION (Cont.)
• CAUTION: Never apply force to remove the pod holder. If the holder does not
slide out easily, wait 10 minutes and try again. Burns resulting from hot water
splash could occur if the holder is forcibly removed from the brewer.
• Use CAUTION to avoid burns during consumption of any freshly brewed
beverage. Servings are extremely hot.
7
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.