Bunn BT10 User Manual

RI IM M* Protective Shield Installation Instructions

BUNN Home Coffee Brewer Models GR10, B10 and BT10

Before attempting to perform any of the following steps,

Warning!

The parts pictured below are included in your Installation Kit.

If your kit does not contain all these parts or if you have any questions about installing the shield, please call 1-800-385-2652.

UNPLUG YOUR BREWER FROM THE ELECTRICAL OUTLET !

Toolsrequired: (1) Phillipsscrewdriver

Protective Cover

(1)

*Seven screws are included as extra in case you misplace the screws from yourmachine while installing the shield

Screw*

(7)

Perform the following steps to install the protective shield:

Unplug the brewer from

the electrical outlet and allow
the brewer to cool for at least
two hours.

NOTE: It is not necessary to empty
the water in the brewer to install the
protective shield.

Using a Phillips screwdriver, remove the 2 screws from the top
lid of the brewer.

NOTE: The two screws are under the ^ip lid as shown.

O

Remove the top lid by
grasping the ^ip lid and
pullingup. Setthetoplidand
the 2 screws aside.

NOTE: you may notice a build-up
of lime residue in the pour-in bowl
when you remove the lid. This
is perfectly safe & normal, and it
comes from your water source.

Remove the pour-in bowl and set it aside.

NOTE: Save your screws, in case you misplace any of the seven included in

the kit.

Please call

1-800-385-2652

should you have any

questions about the

installation of your

Protective Shield.

A. Gently move the wires and silicone tube aside before putting the Protective Shield in place.

B. Set the Protective Shield over the top of the heater terminals and sprayhead tube and gently push

into place.

C. Make sure the silicone tube is not under the edge of the shield.