Buffalo Technology HD-HSU2 User Manual

TurboUSB Utility
for DriveStation HD-HSU2 Series
www.buffalotech.com
The Bualo TurboUSB utility can greatly improve the data transfer rates to and from your Bualo USB hard drive. Other USB devices are not aected by TurboUSB software.
To install TurboUSB on your computer, insert your DriveNavigator CD in your computer’s CD drive. Click on TurboUSB Utility.
Follow the wizard to complete the installation.
Using TurboUSB
To use TurboUSB, you must rst enable it. From the Start menu, choose Programs > BUFFALO > TurboUSB > TurboUSB for HD-HSU2.
Click Enable and follow the directions to start TurboUSB.
When the wizard instructs you to disconnect and then reconnect the USB cable, click on the ‘Safely Remove Hardware’ icon in the systray and release the device before unplugging it.
You may also turn TurboUSB o from the same window by clicking Disable and following the steps. You will have to unplug and reconnect the USB hard drive to complete disabling TurboUSB. Use the ‘Safely Remove Hardware’ wizard to release the drive before unplugging it.
Is TurboUSB enabled?
To check whether TurboUSB is enabled, right-click on My Computer and choose Properties > Hardware > Device Manager > Universal Serial Bus controllers. If TurboUSB is enabled, your USB storage device will have “(TurboUSB)” added to its name.
Uninstalling
To remove the Bualo TurboUSB utility from your computer, click Start > Programs > BUFFALO > TurboUSB > Uninstaller. This will launch an uninstall screen. Click on Start to run the uninstallation.
Notes
www.buffalotech.com
USA/Canada Technical Support is available 24 hours a day, 7 days a week
toll-free: 866-752-6210
email: info@buffalotech.com
Europe Technical Support is available between
9am-6pm (Monday-Thursday) (GMT)
and 9am-4:30pm on Fridays.
email: helpdesk@buffalo-technology.ie
phone (UK only): 087 12 50 12 60*
phone: +353 61 70 80 50
*Calls cost 8.5p per minute
©2005-2007, Buffalo Inc.
v1.4
Loading...