Page 1
Heat Shade
Instruction manual
Model • Modèle • Modell • Modello • Modelo • Malli:
DR755/DR756/DR757/DR758/DR759/DY460/DY461/
DY462
DR755-DR759_DY460-DY462_UK_A5_v2_20190628.indb 1 2019/6/28 17:20
Page 2
UK
Telephone Helpline: 0845 146 2887
Safety Tips
Electrical requirements:
This appliance should only be connected to the
mains electricity supply by a qualified electrician.
Hardwire the Heat Shade into a suitable power
supply with correct voltage and sufficient power
capacity. Refer to the product label (serial
plate) on the warmer for voltage and wattage
requirements.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• Caution! Hot surface!
• Always switch off and disconnect the power supply
to the appliance when not in use, before cleaning and any
maintaining/service procedure.
• This appliance is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials, such
as drapes and other furnishings, away from appliance.
• Extreme caution is necessary when any appliance is used by or
near children and whenever the appliance is left unattended.
• This appliance has electrical parts. Do not use it in areas
where gasoline, paint, or flammable liquids are used or stored.
• DO NOT obstruct or cover the appliance in any way when in
use.
2
DR755-DR759_DY460-DY462_UK_A5_v2_20190628.indb 2 2019/6/28 17:20
Page 3
UK
Telephone Helpline: 0845 146 2887
• Do not operate any appliance with a damaged cord if the
appliance malfunctions or has been dropped / damaged.
Return appliance to an authorised service facility for
examination, electrical or mechanical adjustment, or repair.
• Do not use outdoors. This appliance is not intended for wet or
moist locations. Never locate appliance where it may fall into
water.
• For indoor use only.
• Avoid the use of extension cords. Do not run cord
under carpeting, runners, or the like. Arrange cord away from
traffic area and where it will not create a trip hazard.
• Clean the appliance thoroughly before and after each use
following the cleaning instructions provided in this manual.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an
BUFFALO agent or a recommended qualified technician in
order to avoid a hazard.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience or knowledge, unless they have been
given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
• Buffalo recommend that this appliance is PAT tested on an
annual basis to ensure the product remains safe.
Warming:
This unit is only suitable for R40 or BR40 type
incandescent lamps.
The lamp is excluded from the warranty.
3
DR755-DR759_DY460-DY462_UK_A5_v2_20190628.indb 3 2019/6/28 17:20
Page 4
UK
Telephone Helpline: 0845 146 2887
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.
Pack Contents
The following is included:
• DR755 - Standard Heat Shade (Brass Finish)
• DR756 - Standard Heat Shade (Silver Finish)
• DR757 - Retractable Heat Shades (Copper
Finish)
• DR758 - Retractable Heat Shades (Silver Finish)
• DR759 - Retractable Heat Shades (Matte Black
Finish)
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
• DY460 - Retractable Dome Heat Shades
(Copper Finish)
• DY461 - Retractable Dome Heat Shades
(Silver Finish)
• DY462 - Retractable Dome Heat Shades
(Pale Gold)
• Instruction manual
Preparation
1. Remove the Heat Shade assembly from the carton.
2. Remove tape and protective packaging from all surfaces of unit.
3. Make sure the installation site provides the proper installation clearances for the unit.
Installation
1. Drill a 7/16” (11mm) hole through mounting fixture.
2. Pass wires from the shade through hole in fixture.
3. Secure the shade to the fixture with nut.
NOTE! Fixings not included.
4. You may unscrew the threaded nuts to adjust the length to fit your requirements.
5. The wires in this product are brown – live, blue – neutral and green/yellow for earth.
Operation
• Turn the appliance On/Off using the power switch (I/O) located on the top of the lamp shade.
The appliance only maintains temperature. It does NOT continue to cook food.
4
DR755-DR759_DY460-DY462_UK_A5_v2_20190628.indb 4 2019/6/28 17:20
Page 5
UK
Telephone Helpline: 0845 146 2887
Cleaning, Care & Maintenance
• Proper maintenance plays an important part in the life span and functioning
of the shade.
• The heat lamp must not be cleaned by a water jet.
• Disconnect the heat shade from the power source prior to cleaning and ensure the surface is cool.
• This unit can be cleaned with a damp sponge and mild soap. Rinse with clean water and wipe dry.
• Do not immerse in water or other liquid.
Heat bulb replacement
Each standard Heat Shade is suitable for a clear or infrared heat bulb rated at or
below 250 watts.
1. To replace a bulb, place the power switch (I/O) in the OFF position (O) and allow the bulb and shade
to cool completely.
2. Bulbs have a threaded base. Unscrew the bulb counter-clockwise from the unit and replace with a
new bulb.
Troubleshooting
Fault Probable Cause Solution
Appliance not
working
The unit is not switched on Check the unit is hardwired correctly and
switched on
Lead is damaged Call BUFFALO agent or qualified Technician
Power supply Check power supply
Internal wiring fault Call BUFFALO agent or qualified technician
Lamp expired Replace lamp of the same type
Technical Specifications
Model Voltage Power
DR755 220-240V 50/60Hz 250W 1500 284 x 186 x 186 0.7kg
DR756 220-240V 50/60Hz 250W 1500 284 x 186 x 186 0.7kg
DR757 220-240V 50/60Hz 250W 280 - 1520 310 x 177 x 177 1.05kg
DR758 220-240V 50/60Hz 250W 280 - 1520 310 x 177 x 177 1.05kg
DR759 220-240V 50/60Hz 250W 280 - 1520 310 x 177 x 177 1.05kg
DY460 220-240V 50/60Hz 250W 280 - 1520 295 x 292 x 292 1.36kg
DY461 220-240V 50/60Hz 250W 280 - 1520 295 x 292 x 292 1.36kg
DY462 220-240V 50/60Hz 250W 280 - 1520 295 x 292 x 292 1.36kg
DR755-DR759_DY460-DY462_UK_A5_v2_20190628.indb 5 2019/6/28 17:20
Range of cord
(mm)
Dimensions
h x w x d mm
Weight
5
Page 6
UK
Telephone Helpline: 0845 146 2887
Electrical Wiring
This appliance is supplied unplugged and requires hardwiring to a suitable electrical power supply.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Connection to a suitable power supply should only be carried out by a qualified and
competent electrical engineer.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to
mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
change specifications without notice.
6
DR755-DR759_DY460-DY462_UK_A5_v2_20190628.indb 6 2019/6/28 17:20
Page 7
DECLARATION OF CONFORMITY
Equipment Type • Uitrustingstype • Type d'équipement •
Rise & Fall Heat Shade
(Matte Black)
Rise & Fall Heat Shade
(Copper)
Rise & Fall Dome Heat
Shade (Silver)
Rise & Fall Heat Shade
(Brushed Aluminium)
Rise & Fall Dome Heat
Shade (Copper)
Aluminium Heat Shade
(Brass)
Rise & Fall Dome Heat
Aluminium Heat Shade
Model • Modèle • Modell • Modello • Modelo • Malli
1. DR759
2. DR757
3. DY461
4. DR758
5. DY460
6. DR755
DY4628.DR756
Application of Council Directives(s)
Low Voltage Directive (LVD) 2014/35/EU
Producer Name • Naam fabrikant • Nom du producteur •
Buffalo
Producer Address • Adres fabrikant • Adresse du
Fourth Way,
United Kingdom
42 North Point Business
Ireland
Date • Data • Date • Datum • Data • Fecha • Data
24thJune 2019
Signature • Handtekening • Signature • Unterschrift
Full Name • Volledige naam • Nom et prénom • Vollständiger Name •
Ashley Hooper
Position • Functie • Fonction • Position • Qualifica • Posición • Função
Technical & Quality Manager
• Conformiteitsverklaring • Déclaration de conformité • Konformitätserklärung • Dichiarazione di conformità •
Gerätetyp •
Tipo di apparecchiatura • Tipo de equipo • Tipo de
equipamento
• Declaración de conformidad • Declaração de conformidade
1.
3.
5.
7.
Shade (Pale Gold)
7.
2.
4.
6.
8.
(Brushed Silver)
Toepassing van Europese Richtlijn(en) • Application de
la/des directive(s) du Conseil • Anwendbare EURichtlinie(n) • Applicazione delle Direttive • Aplicación de
la(s) directiva(s) del consejo • Aplicação de directiva(s)
do Conselho
Name des Herstellers • Nome del produttore • Nombre
del fabricante • Nome do fabricante
producteur • Anschrift des Herstellers • Indirizzo del
produttore • Dirección del fabricante • Morada do fabricante
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande Richtlijn(en)
en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und Norm(en)
entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati .
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y estándar(es) arriba
mencionadas.
Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade com a(s) anterior(es) Directiva(s) e
Norma(s)
EN 60598-1:2015 + AC:2015 + AC:2016
EN 60598-2-1:1989
EN 60598-2-4:1997
Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU
EN 55015:2013 + A1:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
EN 61547:2009
Restriction of Hazardous Substances Directive (RoHS)
2015/863 amending Annex II to Directive 2011/65/EU
Avonmouth,
Bristol,
BS11 8TB
Park
New Mallow Road
Cork
Firma • Firma • Assinatura
Nome completo • Nombre completo • Nome por extenso
DR755-DR759_DY460-DY462_UK_A5_v2_20190628.indb 7 2019/6/28 17:20
Page 8
http://www.buffalo-appliances.com/
DR755-DR759_DY460-DY462_UK_A5_v2_20190628
DR755-DR759_DY460-DY462_UK_A5_v2_20190628.indb 8 2019/6/28 17:20
Loading...