Buffalo DW464 Instruction Manual

Glass Washer
Instruction manual
DW464
Safety Tips
Position on a flat, stable surface. A service agent/qualified technician should carry out installation and
any repairs if required. Do not remove any components on this product.
Consult Local and National Standards to comply with the following:
Health and Safety at Work Legislation
BS EN Codes of Practice
Fire Precautions
IEE Wiring Regulations
Building Regulations
DO NOT immerse the appliance in water. Always switch off and disconnect the power supply to the appliance
when not in use.
Not suitable for outdoor use. Keep all packaging away from children. Dispose of the packaging in
accordance to the regulations of local authorities.
Children should be supervised to ensure they do not play with, or
operate the Glass Washer
The function of this Glass Washer is the washing of Glasses and similar
ONLY.
Do not use cleaning agents that contain Chlorine, Bleach or
Hypochlorite
Only use commercial grade detergents and rinse aids in your Glass
Washer
Wear the correct personal protective equipment when handling
chemicals and observe all safety notes
Damage to the Glass Washer caused by lime scale or poor water
quality will NOT be covered by the manufacturers warranty – fitting of a water softener is recommended
The installer and user are responsible for ensuring the installation and
operation of this Glass Washer
Ensure the base of the unit is never submerged or standing in water
when operating the Glass Washer
Do not use electrical extension lead(s) to supply power to your Glass
Washer
If the power cord is damaged, it must be replaced by a BUFFALO agent
or a recommended qualified technician in order to avoid a hazard.
This appliance can be used by children aged from 8 years and persons
with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.
Pack Contents
The following is included:
BUFFALO Glass Washer Glass Basket x 2 Water Inlet Hose Water Drain Hose Instruction Manual
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately
Installation
Levelling
Install the leveling feet, following the below instructions.
Chemical Feeder Tubes
Before placing the Glass Washer in its permanent position extend the chemicals feeder tubes making sure not to kink.
Chemical Feeder Tubes
R: Rinse Aid – Blue Pipe
D: Detergent – Clear Pipe
Note - Do not add extensions to chemical feeder tubes
Note - Chemical supply containers must be placed as close to the machine as possible and must NOT be elevated
Note - Reposition the chemical tubing at the back of the machine, ensuring there are no kinks, before placing the machine in its permanent position
Plumbing Connection
Water Connection
Note - Plumbing connections must be made in such way that will allow the machine to be removed for service and cleaning.
1. Connect the hose supplied with the machine to the inlet at the rear of the machine and
the ¾” NPT fitting on the water supply line.
2. Check the water inlet pressure is between 2-4 bar (29-58 psi) (not static). If it is more a
PRV (pressure reducing valve) must be installed. If it is less a booster pump will be required
Drain Connection
Note - This machine drains by gravity so the drain pipe MUST be lower than the machine. Ensure drain hose has no bends/constrictions in it.
1. Connect the drain hose supplied to the main drainage pipe work.
Loading...
+ 11 hidden pages