Buffalo CE223 Instruction Manual

Page 1
Fryer
Instruction manual
Friteuse
NL
Handleiding
Friteuse
FR
Mode d'emploi
Fritteuse
DE
Bedienungsanleitung
Friggitrice
IT
Manuale di istruzioni
Freidora
ES
Fritadeira
PT
Manual de instruções
Model Modèle Modell Modello Modelo Malli:
CE223
Page 2
UK

Safety Tips

Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
ALWAYS ensure oil levels are within the ‘MIN’ and ‘MAX’ levels. Failure to do so could result in fire.
ALWAYS use a suitable cooking oil.
ALWAYS remove excess moisture/water from food before frying to avoid excess foaming and spitting of the oil.
Change oil regularly. The flashpoint of oil (the point at which it ignites) gradually reduces the more it is used.
DO NOT immerse the appliance in water.
Some surfaces become hot during operation - take care when using the appliance.
Always switch off and disconnect the power supply to the appliance when not in use.
Not suitable for outdoor use.
This appliance must only be used in accordance with these instructions and by persons competent to do so.
This appliance is not suitable for use by children.
Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety

Product Description

CE223 - Fryer

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.

Pack Contents

The following is included:
•BUFFALO Fryer
•Basket
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
1
Instruction manual
•Lid
Page 3
Telephone Helpline: 0845 146 2887 (United Kingdom)
UK

Operation

Power indicator light
Thermostat
Element Safety switch
Tab
Slot
Body

Connecting the Element/Control Panel

The Element and Control Panel are supplied as a single detachable part to aid in cleaning the appliance.
To connect to the body of the appliance:

1. Locate the tabs on the front of the control panel with the slots on the rear of the body.

2. Ensure the safety switch is aligned with the centre slot.

3. Lower the unit onto the appliance, ensuring the tabs are located inside the slots.

Connecting the Basket Handle

Ca re m ust b e ta ken to en sur e tha t th e han dle is corre ctly assembled before being used.

1. Squeeze the two ends of the handle together.

2. Slot the ends of the handle into the holes on the
mounting plate of the basket.
3. Pull the handle back so that the handle is located
behind the clips on the mounting plate.
Clips
Holes
Mounting
plate
2
Page 4
UK

Cooking

1. Connect the appliance to the mains power supply.

2. Set the thermostat to the desired temperature. The amber power indicator light turns On.

Note: 170°C to 180°C is suitable for general cooking.

3. The appliance begins to heat the oil.

Note: The red Heat indicator light turns On during heat-up. When the oil is at the set temperatures the light turns Off.

4. Once the oil is at the set temperature lower the food into the oil using the basket supplied.

5. Remove the basket from the oil once the food is cooked. Shake gently above the oil pan to remove
any excess oil.
WARNING: The food and oil are very hot! Take care when removing the basket as oil may drip.

Cleaning, Care & Maintenance

Always turn Off the appliance and disconnect from the power supply before cleaning.
Always allow the oil to cool before cleaning, ideally for at least 6 hours.
Check the temperature with a suitable probe thermometer; 40ºC is the MAXIMUM temperature at which oil should be removed.
For best performance, BUFFALO recommend that the appliance is cleaned after each day of operation.
Note: Failure to clean the appliance regularly may result in premature activation of the thermal cut-out switch.
Remove the Element/Control Panel for ease of cleaning.
Empty the oil to clean the appliance thoroughly.
WARNING: DO NOT remove the oil pan until AFTER it has been emptied.
If the oil is to be reused then filtering it before refilling the pan will extend the oils cooking life.
Use a suitable detergent to clean the interior of the appliance.
Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
Dry thoroughly after cleaning, ensure there is no water left in the fryer.
A BUFFALO dealer or qualified technician should carry out repairs if required.
3
Page 5
Telephone Helpline: 0845 146 2887 (United Kingdom)
UK

Tr ou b le s h oo ti n g

If your BUFFALO appliance develops a fault, please check the following table before making a call to the Helpline.
Fault Probable Cause Action
The appliance is not working The appliance is not switched on Check the appliance is plugged in correctly
Plug and lead are damaged Call BUFFALO agent or qualified technician
Fuse in the plug has blown Replace the plug fuse
Power supply Check power supply
Internal wiring fault Call BUFFALO agent or qualified technician
Thermal cut-out activated Call BUFFALO agent or qualified technician
Safety switch not located properly Refit control/element unit
Appliance does not reach set temperature
Appliance heats up but indicator light does not come on
Power indicator light comes on but appliance does not heat up
Appliance slow to heat up
Faulty thermostat Call BUFFALO agent or qualified technician
Faulty element Call BUFFALO agent or qualified technician
Build-up of fat on the element Clean the appliance
Indicator light has expired Call BUFFALO agent or qualified technician
Faulty element Call BUFFALO agent or qualified technician
Faulty thermostat Call BUFFALO agent or qualified technician
Thermostat set incorrectly Check thermostat
Build-up of fat on the element Clean the appliance
and switched on

Technical Specifications

Model Voltage Power Current
CE223 230V 50Hz 2000W 7.8A 3 240 x 540 x 220 2.75
Capacity
(litres)
Dimensions
h x w x d (mm)
Weight
(kg)

Electrical Wiring

The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
Live wire (coloured brown) to terminal marked L
Neutral wire (coloured blue) to terminal marked N
Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.
4
Page 6
Telephone Helpline: 0845 146 2887 (United Kingdom)

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:
UK
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the
right to change specifications without notice.
5
Page 7
DECLARATION OF CONFORMITY
• Conformiteitsverklaring • Déclaration de conformité • Konformitätserklärung • Dichiarazione di conformità •
• Declaración de conformidad • Declaração de conformidade •
Equipment Type • Uitrustingstype • Type d'équipement • Gerätetyp • Tipo di apparecchiatura • Tipo de equipo • Tipo de equipamento:
Model • Modèle • Modell • Modello • Modelo:
Serial Number • Serienummer • Numéro de série • Seriennummer
Numero di serie • Número de serie • Número serial :
Year of Manufacture • Fabricagejaar • Date de fabrication • Herstellungsjahr • Anno di produzione • Año de fabricación • Ano de fabricação:
Application of Council Directives(s)Toepassing van Europese Richtlijn(en) • EMC Directive 2004/108/EC
Application de la / des directive(s) du Conseil: • Anwendbare EU-Richtlinie(n) • LVD Directive 2006/95/EC Applicazione delle Direttive: • Aplicación de la(s) directiva(s) del consejo • WEEE Directive 2002/96/EC Aplicação de directiva(s) do Conselho :
Standards • Standaarden • Normes • Normen • Standard • Estándares • Normas:
Producers Name
Nome del produttore • Nombre del fabricante • Nome do fabricante:
Producers Address • Adres fabrikant • Adresse du prodocteur • Anschrift des Herstellers • Indirizzo del produttore • Dirección del fabricante • Endereço do fabricante:
• Naam fabrikant • Nom du prodocteur • Name des Herstellers •
Fryer
CE223
EN61000-3-2:2005, EN 61000-3-3:1995 + A1:01 +A2:05 EN 55014-1:2006 EN 55014-2:1997 + A1:01 EN 60335-1:2002 +A11,A1:04 + A12,A2:06, EN 60335-2-13:2003 +A1:04 EN 50366:2003 +A1:06
BUFFALO
Fourth Way Avonmouth Bristol BS11 8TB United Kingdom
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande Richtlijn(en) en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und Norm(en)
entspricht. Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati. El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y estándar(es) arriba
mencionadas. Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade com a(s) anterior(es) Directiva(s) e
Norma(s).
Date • Data • Date • Datum • Data • Fecha • Data • Dato • Päivämäärä: 16/06/2009
Signature • Handtekening • Signature • Unterschrift
Firma • Firma • Assinatura • Underskrift • Allekirjoitus:
Full Name • Volledige naam • Nom et prénom • Vollständiger Name • Nome completo • Nombre completo • Nome por extenso • Richard Cromwell Fullständigt namn • Fulde navn • Fullstendig navn • Täydellinen nimi:
Position • Functie • Fonction • Position • Qualifica • Posición • Função • Marketing Director Befattning • Stilling • Asema:
Page 8
CE223_ML_A5_v2
Loading...