B-Tech BTV511 operation manual

BTV511

LARGE FLAT SCREEN WALL MOUNT
WITH TILT
INSTALLATION GUIDE & PARTS LIST

This Pack Contains 1 Mount

PLEASE KEEP THIS PARTS LIST FOR FUTURE REFERENCE

INSTALLATION SAFETY INSTRUCTIONS

CAUTION:

This wall mount is intended

464mm

for use only with the maximum weights
indicated. Use with flat screens heavier than the maximum
indicated may result in instability causing possible injury.

Do not attempt to install this product until all instructions and wa rnings have been read and properly understood. Please keep
these instructions for fut
B-Tech International Limited, its distributors and dealers are not liable or responsible for damage or injury caused by improper
installation, improper use or failure to

General

B-Tech International Ltd recommends that a professional AV install er or other suitably qualified person install this product.
Great care must always be taken during installation as most AV equipment is o f a fragile nature, possibly heavy and easily
damaged if dropped. If you do n ot fully understand the instructions or are not sure how to inst all this product safely, then
please consult a professional for advice and/or to install this pr
Failure to mount this product correctly may ca
not mount any AV equipment that exceeds the specific weight limit of the product you are installing .
This weight limit will be clearly stated on each product and its pac kaging and will vary from product to product.

Product location

Please pay careful attention to where this product is located. Some walls are not suitable for installation.
If located in a public or frequently populated area ensure that the prod uct is out of the immediate reach of people. If any AV
equipment is to be suspended over the likely path or loc ation of people then great care should be taken to secure all parts of
the installation from falling. If you install th is p
other

permanent structure behind the drywall board . Installing on drywall boards alone will not support the weight of most AV
equipment. When drilling holes in walls i t is essential to avoid contact with electrical cables a nd water or gas pipes contained
within. Use of a good quality live wire detector and hidden object loc ator is ther
when you are sure it is safe to do so.

Fixing hardware

It is highly recommended that all wall fixing screws be used where supplied and that the purpose of all other fixing hardware is
fully understood. In some cases more AV equipment fixing hardware will be supplied to acco mmodate different models of
equipment and set up configurations. The installer must be satisfied that any su pplied fixing hardware is suitable for each
specific installation. If any fixing screws or
consu

lt a professional or your local hardware store.

Hazard limitation

When routing cables take advantage of any bui lt in cable management features that the product might provide and ensure that
all cables are tidy and secure. Check to see that any moving aspect of the product can do so unhind ered by any cabling.
Some products have moving parts and the pote ntial to cause injury through the crushing or trapping of fingers or other body
parts.
Particular attention to the nature of mo
Immediately after installations double-check that the work done is safe and secure. Double-check all necessary fixings are
present and are of ample tightness.
It is recommended that periodic inspections of the prod uct and its fixing points are made as frequently as possible to ensure
that safety is maintained. If in doubt c ons

CS
Společnost B-Tech International Ltd. doporučuje provést insta laci tohoto produktu prostřednictvím od
jinak způsobilé osoby. Společnost B-Tech International Ltd, její dist ributoři a prodejci nenesou odpovědnost za škody nebo
zranění způsobená nevhodnou instalací. Tento výrobek je nutno umístit do vhodné k onstrukce a používat
maximální výšku.

DE
B-Tech International Ltd. empfiehlt, dass dieses Produkt durc h einen qualifizierten AV-Techniker oder eine andere Person mit
geeigneter Qualifikation installiert wird. B-Tech International Ltd, ihre Distributoren und
fehlerhafte Montage verursachte Beschädigung oder Verletzung haftbar bzw. verantwortlich gemacht werden. Dieses Produkt
muss auf eine geeignetem Untergrund monti ert werden und darf nur bis zum angegebenen Höchstgewicht verwendet werden.

ES
B-Tech International Ltd. recomienda que un instalador de audio y video prof esional u otra persona debidamente cualificada
instalen este producto. B-Tech International Ltd, sus distribuidores y concesionarios no se hacen cargo ni s
de ningún daño o lesión prov ocad
adecuada y se debe utilizar sopor tando solamente hasta el peso máximo indicado.

FR
B-Tech International Ltd. recommande de confier l’inst allation de ce produit à un installateur AV professionnel ou à une autre
personne dûment qualifiée. B-Tech International Ltd, ses distributeu rs et ses revendeurs ne sauraient être tenus responsables

out dégât ou de tou

de t
et utilisé dans la limite du poids maximum indiqué.

IT
B-Tech International Ltd. consiglia d i affidare l’installazione di questo prodotto a un inst allatore specializzato o ad altra
persona adeguatamente qualificata. B-Tech International Ltd, i suoi distributori e rivenditori non accettano alcuna

esponsabilità nei riguardi di eventua li danni o infortuni causati d a un’errata instal

r
a una struttura idonea e utilizzato unicamente sino a l peso massimo indi

NL
B-Tech International Ltd. adviseert om dit product te laten insta lleren door een professionele AV-installateur of andere
hiervoor gekwalificeerde persoon. B-Tech International Ltd, haar di
verantwoordelijk voor schade of letsel die is veroorzaakt door onoord eelkundige installatie. Dit product moet worden
gemonteerd aan een gesch

PL
Firma B-Tech International Ltd. zaleca, aby ten pro dukt był instalowany przez profesjonalnych instalator ów AV lub inny
odpowiednio przeszkol
odpowiedzialności za uszkodzenia lub obrażenia ciała po wstałe w wyniku nieprawidłowej instalacji. Niniejszy produkt musi być

zamontowany na odpowiedniej powierzchni, a podczas uż ytkowania nie wolno przekraczać podanego maksymalnego
obciążenia.

PT
A B-Tech International Ltd. recomenda que a instalação deste pr oduto seja efectuada por um instalador de AV profissional ou
outra pessoa devidamente habilitada. A B-Tech International Ltd. e os seus distribuidores e concessionários n ão são
responsáveis por danos ou lesões causados por uma
adequada e utilizado somente até ao peso máximo indicado.

RU

Компания B-Tech International Ltd. рекомендует, чтобы установка данного изделия производилась инженером по
установке аудио-видеотехники или другим специал истом с соответствующей квалификацией. Компания B-Tech
International Ltd., ее дистрибьюторы и дилеры не нес ут ответствен
ре

зультате неправильной установки. Данное изделие должно крепиться к соответствующей конструкции и

использоваться для поддержания оборудования, вес кот орого не превышает указанный максимальный вес.

©2011 B-Te ch Interna tional Ltd. A ll rights reserved. B-T ech Audio V ideo Mounts i s a div ision of B-T ech Int ernational Ltd . B-Te ch, Bett er By Design & Ventry are registered trademarks of B-Tech International Ltd.

ure reference.

observe these safety instructions. In such cases, all g uarantees will expire.

use serious injury or death both during installation and at an y time thereafter. Do

roduct on drywall it must be securely fixed to a wooden stud, concrete bloc k or

included hardware are deemed not sufficient f or a safe installation then please

ving parts is required especially when assembling ins talling and adjusting during set

ult a professional AV installer or other suitably qualified person.

os por una ins talación inapropiada. Este producto se debe montar en una estructura

te blessure résultant d’une installation incorrecte. Ce produit doit être monté sur un support approprié

ikte constructie, waarbij het aangegeven maximum gewicht niet mag worden overschreden.

ony personel. Firma B-Tech Intern ational Ltd, jej dystrybutorzy i dealerzy nie ponos zą

oduct for you.

cato.

stribut

eurs en dealers zijn niet aansprak elijk of

instalaç ão incorrecta. Es

ности за повреждения или травмы, полученные в

All other bran

ds and produ ct names are trademarks o f their respe ctive owners. P hotographs are for illus trative purposes onl y. E&OE .

efore recommended. Only drill into structures

borného instalátora AV či

jen po uvedenou

Händler können nicht für durch

e responsabilizan

lazione. Questo prodotto deve essere fissato

te produto tem de ser montado numa estrutura

● Suitable for VESA and non-VESA screens up to 52"

up.

● Mounts screen only 45mm from the wall

● 5 fixed tilt positions up to 15°

● Su

● Includes locking bar for secure installation

● Post-installation screen alignment

● Simple hook-on installation with all mounting

13mm (1/2") spanner

+15°

455mm

70mm

430mm

MAX:

itable for concrete, brick or stud walls up to 16"

hardware included

TOOLS REQUIRED

or socket

10mm (7/16")

masonry bit or

screwdriver

Level

(optional)

6mm (1/4") wood bit

Crosshead

B-TECH AUDIO VIDEO MOUNTS

Bennett House, Long March, Daventry, Northants., NN11 4NR, UK

NORTH AMERIC

203 Eggert Road,

Buffalo, NY 14215, USA

Email: [e-mail]

Email: [e-mail]

BELGIUM

Brixtonlaan 32, Zaventem 1930,

Brussels, Belgium

Email: [e-mail]

IP-BTV511-V2-VT1BX-180811-03 MADE IN CHINA

HEAD OFFICE

EUROPE

SINGAPORE

Ruby Industrial Complex,

Singapore 347740

Email: [e-mail]

Drill

GERMANY

Dyrotzer Weg 26A, 14612 Falkensee,

Berlin, Germany

Email: [e-mail]

Stud finder

(optional)

ASIA PACIFIC

Unit 1109 Prosperity Millennia Plaza,

Quarry Bay, Hong Kong

Email: [e-mail]

MAX: 400mm

Pencil

BTV511

INSTALLATION INSTRUCTIONS

1. Attach wall plate to either a concrete or stud wall.

i. Concrete wall

1

A3

A2

A1

2. Attach interface arms to flat screen.

ii. Stud wall

16"

MAX

1

A2

A1

A-I

FLAT
SCREEN

J

K

L

M

T

O

P

2

B

O

T

T

O

M

3

MULTIWASHER

PART M

E/F

C/D

A/B

G/H/I

3. Adjust and lock tilt.

BOTTOM

TOP

ADJUST

TILT

4

7

4. Hook mount onto wall plate.

3

WALL

2

FLAT
SCREEN

MAXIMUM

TILT

15°

3

2

7

4

FLAT
SCREEN

1

5. Tilt adjustment.

+ 15°

FLAT
SCREEN

6. Lateral adjustment.

LATERAL
ADJUSTMENT

To adjust tilt,

repeat steps

3 & 4.

7. Insert locking bar.

6

5

7

FLAT SCREEN

3

Optional

Secure with padlock (not supplied)

HOLE FOR
PADLOCK

BTV511

PARTS LIST

PLEASE KEEP THIS PARTS LIST FOR FUTURE REFERENCE

C

A

B

3

E

F

D

7

HG

I

2

1

K

J

L

M

A1

A2

No. PART NAME QTY

1 WALL PLATE 1
2 INTERFACE ARM A 1
3 INTERFACE ARM B 1
4 M6 TILT ADJUSTMENT SCREW 2
5 LOCKING BAR 1
6 M6 SCREW 1
7 4mm HEX KEY (FOR PARTS 4 & 6) 1

A1 M8 X 50mm COACH SCREW 3
A2 M8 METAL WASHER 3
A3 NO.10 WALL PLUG 3

A3

FIXING KIT

Suitable for loads up to 50Kg (110lbs)

4

5

4

No. INTERFACE KIT QTY

A M4 X 12mm SCREW 4
B M4 X 25mm SCREW 4
C M5 X 16mm SCREW 4
D M5 X 25mm SCREW 4
E M6 X 16mm SCREW 4
F M6 X 25mm SCREW 4
G M8 X 1 6mm SCREW 4
H M8 X 25mm SCREW 4

I M8 X 40mm SCREW 4
J M6 X 12mm SPACER (FOR PARTS B, D & F) 4
K M8 X 13mm SPACER (FOR PART H) 4
L M8 X 24mm SPACER (FOR PART I) 4

M MULTIWASHER (FOR PARTS A – I) 4

6