B-Tech BTV501 operation manual

BTV501

j

MEDIUM FLAT SCREEN WALL MOUNT
WITH TILT
INSTALLATION GUIDE & PARTS LIST

This Pack Contains 1 Mount

PLEASE KEEP THIS PARTS LIST FOR FUTURE REFERENCE

INSTALLATION SAFETY INSTRUCTIONS

CAUTION:

for use only with the maximum weights

This wall mount is intended

+15°

264mm

indicated. Use with flat screens heavier than the maximum
indicated may result in instability causing possible injury.

Do not attempt to install this product until all instructions and wa rnings have been read and properly understood. Please keep
these instructions for future reference.
B-Tech International Limited, its distributors and dealers are not liable or responsible for damage or injury caused by improper
installation, improper use or failure to

General

B-Tech International Ltd recommends that a professional AV installe r or other suitably qualified person install this product.
Great care must always be taken during installation as most AV equipment is o f a fragile nature, possibly heavy and easily
damaged if dropped. If you do n ot fully understand the instructions or are not sure how to inst all this product safely, then
please consult a professional for advice and/or to install this pr
Failure to mount this product correctly may ca
not mount any AV equipment that exceeds the specific weight limit of the product you are installing .
This weight limit will be clearly stated on each product and its pac kaging and will vary from product to product.

Product location

Please pay careful attention to where this product is located. Some walls are not suitable for installation.
If located in a public or frequently populated area ensure that the product is out of the immediate reach of people. If any AV
equipment is to be suspended over the likely path or loca tion of people then great care should be taken to secure all parts of
the installation from falling. If you install this product on drywall it must be sec
other

permanent structure behind the drywall board . Installing on drywall boards alone will n ot support the weight of most AV
equipment. When drilling holes in walls i t is essential to avoid contact with electrical cables and water or gas pipes contained
within. Use of a good quality live wire detector and hidden object loc ator is ther
when you are sure it is safe to do so.

Fixing hardware

It is highly recommended that all wall fixing screws be used where supplied and that the purpose of all other fixing hardware is
fully understood. In some cases more AV equipment fixing hardware will be supplied to accom modate different models of
equipment and set up configurations. The installer must be satisfied that any su pplied fixing hardware is suitable for each
specific installation. If any fixing screws or
consu

lt a professional or your local hardware store.

Hazard limitation

When routing cables take advantage of any built in cable management features that the product might provide and ensure that
all cables are tidy and secure. Check to see that any moving aspect of the product can do so unhind ered by any cabling.
Some products have moving parts and the pote ntial to cause injury through the crushing or trapping of fingers or other body
parts.
Particular attention to the nature of mo
Immediately after installations double-check that the work done is safe and secure. Double-check all necessary fixings are
present and are of ample tightness.
It is recommended that periodic inspections of the prod uct and its fixing points are made as frequently as possible to ensure
that safety is maintained. If in doubt c onsult a professional A

CS
Společnost B-Tech International Ltd. doporučuje provést insta laci tohoto produktu prostřednictvím od

inak způsobilé osoby. Společnost B-Tech International Ltd, její dist ributoři a prodejci nenesou odpovědnost za škody nebo

zranění způsobená nevhodnou instalací. Tento výrobek je nutno umístit do vhodné k onstrukce a používat jen po uvedenou
maximální výšku.

DE
B-Tech International Ltd. empfiehlt, dass dieses Produkt durc h einen qualifizierten AV-Techniker oder eine andere Person mit
geeigneter Qualifikation installiert wird. B-Tech International Lt
fehlerhafte Montage verursachte Beschädigung oder Verletzung haftbar bzw. verantwortlich gemacht werden. Dieses Produkt
muss auf eine geeignetem Untergrund monti ert werden und darf nur bis zum angegebenen Höchstgewicht verwendet werden.

ES
B-Tech International Ltd. recomienda que un instalador de audio y video prof esional u otra perso
instalen este producto. B-Tech International Ltd, sus distribuidores y concesionarios no se hacen cargo ni s
de ningún daño o lesión prov ocados por una instalación i napropiada. Este producto se debe montar en una estructura
adecuada y se debe utilizar sopor tando solamente hasta el peso máximo indicado.

FR
B-Tech International Ltd. recommande de conf ier
personne dûment qualifiée. B-Tech International Ltd, ses distributeu rs et ses revendeurs ne sauraient être tenus responsables
de tout dégât ou de tou
et utilisé dans la limite du poids maximum indiqué.

IT
B-Tech International Ltd.
persona adeguatamente qualificata. B-Tech International Ltd, i suoi distributori e rivenditori non accettano alcuna
responsabilità nei riguardi di eventua li danni o infortuni causati d a un’errata instal
a una struttura idonea e utilizzato unicamente sino a l peso massimo indi

NL
B-Tech International Ltd. adviseert om dit product te laten insta lleren door een professionele AV-installateur of andere
hiervoor gekwalificeerde persoon. B-Tech International Ltd, haar distributeurs en de alers zijn niet aansprakelijk of
verantwoordelijk voor schade of letsel die is veroorzaakt door onoord eelkundige installatie. Dit product moet worden
gemonteerd aan een gesch

PL
Firma B-Tech International Ltd. zaleca, aby ten pro dukt był instalowany przez profesjonalnych instalator ów AV lub inny
odpowiednio przeszkolony personel. Firma B-Tech International Ltd, jej dystrybutorzy i dealerzy nie ponoszą
odpowiedzialności za uszkodzenia lub obrażenia ciała po wstałe w wyniku nieprawid łowej instalacji. Niniejszy produk t musi być

zamontowany na odpowiedniej powierzchni, a podczas uż ytkowania nie wolno przekraczać podanego maksymalnego
obciążenia.

PT
A B-Tech International Ltd. recomenda que a instalação deste pr oduto seja efectuada por um instalador de AV profissional ou
outra pessoa devidamente habilitada. A B-Tech International Ltd. e os seus distribuidores e concessionários n ão são
responsáveis por danos ou lesões causados por uma
adequada e utilizado somente até ao peso máximo indicado.

RU

Компания B-Tech International Ltd. рекомендует, чтобы установка данного изделия производилась инженером по
установке аудио-видеотехники или другим специал истом с соответствующей квалификацией. Компани я B-Tech
International Ltd., ее дистрибьюторы и дилеры не нес ут ответственнос
ре

зультате неправильной установки. Данное изделие должно крепиться к соответствующей конструкции и

использоваться для поддержания оборудования, вес кот орого не превышает указанный максимальный вес.

©2011 B-Te ch Interna tional Ltd . All rights reserved. B -Tech Audio Video Mounts is a d ivision of B -Tech I nternational Ltd. B- Tech, Better B y Design & Ven try are regi stered trademark s of B- Tech In ternational Lt d.

observe these safety instructions. In such cases, all g uarantees will expi

use serious injury or death both during installation and at any time thereafter. Do

included hardware are deemed not sufficient for a sa fe installation then please

ving parts is required especially when assembling ins talling and adjusting during set

te blessure résultant d’une installation incorrecte. Ce produit doit être monté sur un support approprié

consigl

ia di affidare l’installazione di questo prodotto a un installatore specializ zato o ad altra

ikte constructie,

waarbij het aangegeve

oduct for you.

urely fixed to a wooden stud, concrete block or

efore recommended. Only drill into structures

V installer or other suitably qualified person.

d, ihre Distributoren und

l’installation de ce produit à un installateur AV professionnel ou à une autre

ca

n maximum gewicht niet mag worden overschreden.

instalaç ão incorrecta. Es

All other bran

ds and produ ct names are trademarks of their resp ective owner s. Photographs are for illustrati ve purposes only. E&OE.

Händler können nicht für durch

lazione. Questo prodotto deve essere fissato

to.

te produto tem de ser montado numa estrutura

ти за повреждения или травмы, полученные в

re.

borného instalátora AV či

na debidamente cualificada

e responsabilizan

70mm

255mm

MAX: 225mm

up.

● Suitable for VESA and non-VESA screens up to 42"

● Mounts screen only 45mm from the wall

● 5 fixed tilt positions up to 15°

● Suitable for concrete, brick or stud walls up to 10"

● Includes locking bar for secure installation

● Post-installation screen alignment

● Simple hook-on installation with all mounting

hardware included

TOOLS REQUIRED

13mm (1/2") spanner

or socket

6mm (1/4") wood bit

Email: [e-mail]

Crosshead

screwdriver

10mm (7/16")

masonry bit or

B-TECH AUDIO VIDEO MOUNTS

Bennett House, Long March, Daventry, Northants., NN11 4NR, UK

NORTH AMERIC

203 Eggert Road,

Buffalo, NY 14215, USA

Email: [e-mail]

BELGIUM

Brixtonlaan 32, Zaventem 1930,

Brussels, Belgium

Email: [e-mail]

Email: [e-mail]

IP-BTV501-V2-VT1BX-180811-03 MADE IN CHINA

Level

(optional)

HEAD OFFICE

EUROPE

Dyrotzer Weg 26A, 14612 Falkensee,

SINGAPORE

Ruby Industrial Complex,

Singapore 347740

Drill

Stud finder

GERMANY

Berlin, Germany

Email: [e-mail]

Unit 1109 Prosperity Millennia Plaza,

Email: [e-mail]

(optional)

ASIA PACIFIC

Quarry Bay, Hong Kong

MAX: 200mm

Pencil

BTV501

INSTALLATION INSTRUCTIONS

1. Attach wall plate to either a concrete or stud wall.

i. Concrete wall

1

A3

A2

A1

2. Attach interface arms to flat screen.

ii. Stud wall

10"

MAX

1

A2

A1

A-I

FLAT

SCREEN

J

K

L

M

T

O

P

MULTIWASHER

PART M

2

B

O

T

T

O

M

3

E/F

C/D

A/B

G/H/I

3. Adjust and lock tilt.

BOTTOM

TOP

ADJUST

TILT

4

5

4. Hook mount onto wall plate.

3

WALL

2

MAXIMUM

TILT

FLAT
SCREEN

IMPORTANT

Must be tilted to attach
the arms to the wall plate

15°

2

3

7

4

FLAT
SCREEN

1

5. Tilt adjustment.

+ 15°

FLAT
SCREEN

6. Lateral adjustment.

LATERAL
ADJUSTMENT

To adjust tilt,

repeat steps

3 & 4.

7. Insert locking bar.

4

3

5

FLAT SCREEN

1

Optional

Secure with padlock (not supplied)

HOLE FOR
PADLOCK

BTV501

PARTS LIST

PLEASE KEEP THIS PARTS LIST FOR FUTURE REFERENCE

C

A

D

E

B

F

1

5

HG

I

3

K

J

L

4

M

A1

A2

No. PART NAME QTY

1 WALL PLATE 1
2 INTERFACE ARM A 1
3 INTERFACE ARM B 1
4 M6 L45 HEX SCREW 2
5 4mm ALLEN KEY (358MM LONG) 1

A1 M8 X 50mm COACH SCREW 3
A2 M8 METAL WASHER 3
A3 NO.10 WALL PLUG 3

A3

FIXING KIT

Suitable for loads up to

2

No. INTERFACE KIT QTY

A M4 X 12mm SCREW 4

B M4 X 25mm SCREW 4
C M5 X 16mm SCREW 4
D M5 X 25mm SCREW 4

E M6 X 16mm SCREW 4

F M6 X 25mm SCREW 4
G M8 X 16mm SCREW 4
H M8 X 25mm SCREW 4

I M8 X 40mm SCREW 4
J M6 X 12mm SPACER (FOR PARTS B, D & F) 4
K M8 X 13mm SPACER (FOR PART H) 4
L M8 X 24mm SPACER (FOR PART I) 4

M MULTIWASHER (FOR PARTS A – I) 4

4

40Kg (88lbs)