BST XS300, XS600, XS800 Instruction Manual

© Copyright LOTRONIC 2014 XS300 - XS600 - XS800 Page 1

POWER AMPLIFIER

AMPLIFICATEUR

XS300 ( 15-2715 )
XS600 ( 15-2716 )
XS800 ( 15-2717 )

GB - INSTRUCTION MANUAL

F - MANUEL D’UTILISATION

© Copyright LOTRONIC 2014 XS300 - XS600 - XS800 Page 2

ENGLISH

Thank you for having chosen our power amplifier. For your own safety, please read this user manual carefully before installing the
device.

SAFETY INTRODUCTION

 If the device has been exposed to temperature changes due to environmental changes, do not s witch it on immediately. The

arising condensation could damage the device. Leave the device switched off until it has reached room temperature.

 It is essential that the device is earthed. A qualified person must carry out the electric connection.
 Make sure that the available voltage is not higher than stated at the end of this manual.
 Make sure the power cord is never crimped or damaged. If it is damaged, ask your dealer or authorized agent to replace the

power cord.

 Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power cord by plug. Never

pull out the plug by tugging the power cord.

 DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device

shall remain readily operable.

CAUTION:

1. Please be aware that damages caused by manual modifications to the device are not subject to warranty. Keep away from
children and non-professionals.

2. The light doesn’t include any spare parts for repair, please check if all the parts are well installed and screws are fitted tightly
before operating. Do not use the light when the cover is open.

GENERAL GUIDELINES

 This device is only allowed to be operated wit h an alternating current of max. 110-120VAC / 220-240VAC / 50-60Hz and was

designed for indoor use only.

 Operate the device only after having fam iliarized yourself with its functions. Do not permit operation by person not qu alified for

operating the device. Most damages are the result of unprofessional operation.

 Please use the original packaging if the device is to be transported.
 For safety reasons, please be aware that all modifications on the device are forbidden. Furthermore, any other operation may

lead to short-circuit, burns, electric shock, crash, etc. If this device will be operated in any way different to the one descr ibed in
this manual, the product may suffer damages and the guarantee becomes void.

© Copyright LOTRONIC 2014 XS300 - XS600 - XS800 Page 3

DESCRIPTION

1) POWER SWITCH

Used to switch the power amplifier on or off

2) VOLUME CONTROL

In stereo mode, these two controls are used to adjust volume of the channel
In bridge mode, only the A volume control adjust the level of the bridge output

3) CLIP LED

The clip led lights on when the level is too high. in this case, decrease the level

4) PROT LED

This led lights on when the power amplifier is on protection mode. in this case, check the speaker and connection

5) POWER LED

This led lights on when you switch the power amplifier on or off

6) COOLING VENTS

These holes are using to refresh power amplifier. don't obstruct this part

7) INPUTS

Connect on these sockets ( Jack or cinch ) the output of your mixer ( or of the cd player )

8) POWER SUPPLY SOCKET

The main power supply is different between country ( in france :220V ). Select the good value with the switch ( 110V or 220V )

9) OUTPUTS

Connect these sockets ( Turnlock, jack or binding post ) to your speakers
Note : in bridge mode, connect binding post + of channel 1 and binding post + of channel B to the speaker