Bryant TSTATCCPB101, TSTATBBPB101, P474-1010 Installation Instructions Manual

Installation Instructions

TSTATCCPB101
TSTATBBPB101
P474-1010

NOTE: Read the entire instruciton manual before starting the installation.

Digital Thermostat

HEAT

AUTO

72

COOL

74

HEAT

72

COOL

&

HEAT

PUMP

MULTI-STAGE SINGLE DAY PROGRAMMABLE

Form: IM-TSTAT-07

Cancels: Printed in U.S.A.

Catalog No. 13TS-TA43

Table Of Contents

PREPARATION
REMOVE OLD THERMOSTAT
INSTALL BACKPLATE & WIRE
WIRING DIAGRAMS
CALIBRATION
TEST OPERATION
TROUBLESHOOTING

CAUTION

Replacement Components Division Carrier Corporation 4/01

This device complies with Part 15 of the FCC rules.
Operation is subject to the following 2 conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.

Follow Installation Instructions carefully.

DISCONNECT POWER TO THE HEATER ­AIR CONDITIONER BEFORE REMOVING
THE OLD THERMOSTAT AND INSTALLING
THE NEW THERMOSTAT.

WARNING

2
3
4
5
8
9

10

Page 1

STEP #1

Flat Blade
Screwdriver

Make sure your Heater/Air Conditioner
is working properly before beginning
installation of the thermostat.

PREPARATION

Proper installation of the thermostat will be
accomplished by following these step
by step instructions. If you are unsure
about any of these steps, call a qualified
technician for assistance.

Assemble tools as shown below.

Drill with 3/16

inch Drill Bit
Wire cutter
& Stripper

(when not using

j-box)

Carefully unpack the thermostat.
Save the screws, wall anchors, and
instructions.

Page 2

STEP #2

REMOVE OLD THERMOSTAT

Turn off the power to the Heating/Air
Conditioning system at the main fuse
panel. Most residential systems have
a separate breaker for disconnecting
power to the furnace.

Remove the cover of the old thermostat.
If it does not come off easily check for
screws.

Loosen the screws holding the thermostat
base or subbase to the wall, and lift away.

Disconnect the wires from the old
thermostat. Tape the ends of the wires
as you disconnect them, and mark them
with the letter of the terminal for easy
reconnection to the new thermostat.

Keep the old thermostat for reference
purposes, until your new thermostat is
functioning properly.

Page 3