BRP EVINDURE ICON II Instructions Manual
INSTRUCTIONS
Outboard Engines
EVINRUDE® ICON II MODE & RPM SWITCH KIT - P/N 766282
SAFETY INFORMATION
The following symbols and/or signal words may
be used in this document:
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious inj ury
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate personal injury.
NOTICE
Indicates an instruction which, if not followed, could
severely damage engine compon ents or other property.
These safety alert signal words mean:
ATTENTION!
BECOME ALERT!
YOUR SAFETY IS INVOLVED!
For safety reasons, this kit must be installed by
an authorized Evinrude dealer. This instruction
sheet is not a substitute for work experience. Additional helpful information may be found in other
service literature.
DO NOT perform any work until you have read
and understood these instructions completely.
Torque wrench tightening specifications must
strictly be adhered to.
Should removal of any locking fastener (lock
tabs, locknuts, or patch screws) be required, always replace with a new one.
When replacement parts are required, use Evin-
rude/Johnson
®
Genuine Parts or parts with
equivalent characteristics, including type,
strength and material. Use of substandard parts
could result in injury or product malfunction.
Always wear EYE PROTECTION AND APPROPRIATE GLOVES when using power tools.
Unless otherwise specified, engine must be OFF
(not running) when performing this work.
Always be aware of parts that can move, such as
flywheels, propellers, etc.
Some components may be HOT. Always wait for
engine to cool down before performing work.
If you use procedures or service tools that are
not recommended in this instruction sheet, YOU
ALONE must decide if your actions might injure
people or damage the outboard.
This instruction sheet may be translated into other languages. In the event of any discrepancy,
the English version shall prevail.
TO THE INSTALLER: Give this sheet and the
operating instructions to the owner. Advise the
owner of any special operation or maintenance
information contained in the instructions.
TO THE OWNER: Save these instructions in
your owner’s kit. This sheet contains important
information for the use and maintenance of your
engine.
Printed in the United States.
© 2014 BRP US Inc. All rights reserved.
TM, ® and the BRP logo are registered trademarks of Bombardier Recreational Products Inc. or its affiliates.
1 of 6
MODE & RPM SWITCH KIT - P/N 766282
y
–
–
g
356593-01
Use this switch kit with the ICON II Concealed Side Mount Control.
Ref P/N Name of Part Qt
766282SWITCH KIT, Mode & RPM 1
125308*SCREW, Mountin
INSTALLATION
Use the ICON II Concealed Side Mount Quick Connect Guide, P/N 766695.
1) Identify the mounting location. Allow for 6 in. (152.4 mm) of clearance behind the mounting
surface.
4
2) Cut/drill the mounting holes (use the template on page 4).
3) Install the switch and tighten the screws securely.
4) Connect the switch to the remote control harness MODE & RPM connector.
5) Test the operation of the switch.
2 of 6
WIRING DETAIL
11
10
356593-02
3 of 6
4 of 6
Loading...