Browning Security Door Owner's Manual

Security Door Installation Instructions

Tools Needed:

Tape Measure, Level, Drill, ¼” Bit, 9/16 Socket, 1 ¼” Forstner Bit

1. The rough opening height must be 83” and the rough opening width must be 36”.

2. Using a tape measure, check the rough opening. Measure diagonally across the

opening. Diagonal measurements need be equal within ¼”.

3. Referencing drawing above, drill a 3/8” thru hole in the proper location (3.75

from outer edge of sheet rock)

4. Referencing drawing above step three, create a 1.25” diameter cavity 3/8” deep ”

in the stud. Center of cavity should be centered at center of 3/8” thru hole.

5. Move security door and frame into location near rough opening. (Keep support

under security door until door and frame are completely installed.)

6. Feed electrical cable attached to security door frame through 3/8” hole in stud.

(Care should be taken to keep the electrical cable from being pinched or
damaged.)

7. Start moving hinge side of security door frame into place, allowing for electrical

connection to slide into place notched in stud.

8. Finish moving security door frame into rough opening.

9. Make sure the security door frame is tight against the wall.

10. Square and plum the hinge side of the security door frame using solid wood

shims.

11. Once the security door and frame are square and plum, drill 1/4” holes

corresponding with 3/8” holes on hinge side of frame.

12. Use 3/8” lag bolts to secure hinge side of frame.

13. Finish shimming the other two sides of the frame using solid wood shims and

anchor with lag bolts. (Total of ten lag bolts in frame.)

14. Recheck the hinge side of the frame to make sure that it is still square and plum.

(Adjust as needed)

15. Remove support from under security door.

16. Remove the temporary threshold.

17. Place trim and threshold in place as needed.

 “IMPORTANT, RECORD YOUR SERIAL NUMBER” located on

the inside top left corner of your security door and store in a safe place for future reference
otherwise your lock warranty is void.

 Manufacture recommends that you place wire running between lock and keypad

inside electrical conduit to minimize chances of damaging wire.