Fold Fold Fold Fold Fold
Bop Wireless Speaker
WIRELESS SPEAKER THAT STICKS
LITHIU M-ION BATTERY
WARNINGS
This device contains a non-removable
lithium-ion battery. The battery must be
recycled or disposed of properly.
Contact your local waste management
office for information on battery
recycling or disposal.
FCC IN FORMATION
This equipment has been tested
and found to comply with the
limits for a Class B Digital Device,
pursuant to Part 15 of the FCC
Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the distance between
the equipment and receiver.
• Connect the equipment to an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
This equipment complies with
Part 15 of the FCC Rules.
Operation is subject to the
following two conditions:
1. This equipment may not cause
harmful interference.
2. This equipment must accept any
interference received, including
interference that may cause
undesired operation.
Modifications not authorized by the
manufacturer may void the user’s
authority to operate this device.
RSS IN FORMATION
This device complies with RSS-210
of the IC Rules; Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Cet appareil est conforme à la norme
RSS-210 de la règlementation
d'Industrie Canada ; son utilisation
est soumise aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de
brouillage, et
(2) l'utilisateur de l'appareil
doit accepter tout brouillage
radioélectrique subi, même si le
brouillage est susceptible d'en
compromettre le fonctionnement.
The device meets the exemption from
the routine evaluation limits in section
2.5 of RSS 102 and compliance with
RSS-102 RF exposure, users can
obtain Canadian information on RF
exposure and compliance.
Le dispositif rencontre l'exemption
des limites courantes d'évaluation
dans la section 2.5 de RSS 102
et la conformité à l'exposition
de RSS-102 rf, utilisateurs peut
obtenir l'information canadienne sur
l'exposition et la conformité de rf.
This Class B digital apparatus
complies with Canadian ICES-003.
Cet appareil numérique de la classe
B est conforme à la norme NMB-003
du Canada
LOCATION OF PARTS
AND CONTROLS
1. Dust Cover
2. Power Switch
3. Micro USB Port
4. Volume Up Button
5. Volume Down Button
6. Play/Pause Button
7. Mic
8. Suction Cup
LED indicator
9.
10. Micro USB Charging Cable
(not shown)
1
4
6
9
3
USB
5
2
OFF
ON
7
Merrimack, New Hampshire, USA 03054
8
800-846-3000 • Brookstone.com
840042; 840043; 840044
840045; 840046
Fold Fold Fold Fold Fold
CHARGING TH E SPEAK ER
1. Connect the USB Cable
(included) to the Micro USB
Port on the speaker.
2. With the speaker’s Power Switch
off, plug the other end of the
USB Cable into a USB Port on
your computer.
3. The LED Indicator will illuminate
red while charging, and the light
will go out when the speaker
is fully charged. Charges in
approximately 2.5 hours for up to
9.5 hours of listening enjoyment.
PAIRING YOUR DEVICE
1. Prepare your device to pair using
2. Slide the Power Switch to ON.
3.
4. Once the speaker is in pairing
mode and your device is ready to
®
Bluetooth
within 33 feet of the speaker.
Refer to your device’s owners
manual for details if necessary.
The LED Indicator light will flash
quickly and the speaker will sound
beeps to enter auto-pairing mode.
The speaker will wait for a
connection in pairing mode for
4 minutes. If it does not pair with a
device, it goes into sleep mode. To
enter pairing mode again, power
the speaker off and then on.
, making sure you are
pair, select “Bop”. If prompted,
use 0000 as a PIN for the
pairing code. Once the
speaker is selected, the LED
Indicator will flash slowly and
beeps will sound to confirm
pairing complete.
LISTENING TO YOUR
AUDIO DEVICE
1. Play your audio device as you
normally would,
2. Volume may be adjusted on your
audio device or by pressing and
holding the '+' or '-' buttons.
3. A single press of the '+' or '-'
button will advance to the next
track or go back to the previous
track.
4. To pause audio, press the '>'
button on the Bop Speaker. To
resume audio playback press
the '>' button again.
5. Slide the Power Switch to OFF.
The LED will go out.
BASIC CELLPHONE OPERATION
1.
When you have an incoming call,
the speaker sounds an incoming
call tone. Both the speaker and
your cellphone may ring, depending
on your cellphone settings.
2.
To answer an incoming call,
short press Play/Pause Button to
answer the call.
3.
To reject an incoming call,
long press Play/Pause Button to
reject the call.
To end a call, short press
4.
Play/Pause Button once.
If, while you are listening to music,
5.
your phone rings and you answer
the call, the music selection will then
continue from where it had stopped.
SPECI FICATIONS
Power Supply: 5V, 500mA
Total Output: 3W
Range: Class 2, up to 33 ft (10 m)
Li-ion Rechargeable Battery: 400mAh
Speaker: 1.50 inch, 4 Ohm
Charging Time: Approx. 2.5 hours
Battery Life: Approx. 9.5 hours
Compatibility: Bluetooth
device with A2DP/AVRCP/HFP/HSP
®
2.0 or above
CARE AND STORAGE
1. Store the speaker in its compact
form in a cool, dry place.
®
The Bluetooth
are registered trademarks owned of
Bluetooth SIG, Inc. and any use
of such marks by Brookstone is under
license.
word mark and logos