Page 1
5-Piece Grill Tool Set
WITH DIGITAL THERMOMETER
Page 2
1
TABLE OF CONTENTS
Warnings and Cautions ....................................................1
Location of Fork Parts and Controls.........................................3
Installing the Battery in the Fork............................................3
Using the Thermometer....................................................4
Temperature Guidelines ....................................................5
Using the Timer ...........................................................6
Using the LED Light.......................................................6
Care and Maintenance..................................................... 7
Specifications .............................................................7
Warranty..................................................................8
WARNING
• Examine brush before each use. Discontinue use if bristels are loose, damaged,
missing, or show excessive wear. Carefully examine cooking surface for loose
bristles before cooking.
• Close supervision is necessary when each unit of this set is used by or near
children or mentally disabled individuals. Adult supervision is required.
• Use this unit only for its intended use as described in this manual.
• The digital fork is not intended for use as an oven thermometer or grill surface
thermometer. The thermometer is designed to measure internal meat temperature
and has an operational range between 32°F to 266°F(0°C to 130°C). Exposing
the probe tip to temperatures above 266°F (130°C) could cause damage to the
temperature sensor.
• This set of tools has sharp blades and sharp tips. Use with caution.
• Stainless steel meat probe will become extremely hot during use. Remove probe
from meat and allow to cool.
BATTE RY PRECAUTIONS
• Dispose of used batteries properly. Do not dispose of batteries in a fire.
• Do not leave the batteries where a child or pet could play with or swallow them. If
the batteries are swallowed, contact a physician immediately.
• The batteries may explode if mistreated. Do not attempt to recharge or disassemble the batteries.
• Use only fresh batteries of the required size and type. Do not mix old and new batteries, different types of batteries, or rechargeable batteries of different capacities.
Page 3
2 3
FCC IN FORMATION
Caution: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This equipment may not cause harmful interference.
2. This equipment must accept any interference received, including interference that
may cause undesired operation.
LOCATION OF FORK PARTS AND CONTROLS
M
S
F
C
INSTALLING THE BATTERY IN THE FOR K
1. Remove the battery compartment cover from the back of the fork handle by
pressing the tab at the bottom of the battery compartment cover.
2. Insert 2 AAA 1.5V batteries (included), following the polarity indicators.
3. Replace the battery compartment cover.
Fork Probe LED Light On/Off
Timer Mode: Start/Stop
Thermo Mode: °C/°F
LCD Screen
Timer Mode: Minutes
Seconds
Thermo Mode: Temp Up
Temp Down
LED Light
Page 4
4 5
USING THE THERMOM ETER
1. Locate the switch on the back of the fork handle and slide it
to the THERMO position.
2. Press any button to turn on the digital display.
3. Press the °C/°F button to select Celsius or Fahrenheit
temperature readings.
4. Press the UP or DOWN arrow to set the target temperature. Refer to the chart
on Page 5 for temperature guidelines.
5. To test the temperature, remove the protective covering from the fork probe tips
and insert the fork probe tips into the thickest part of the meat. Avoid touching
bone or heavy fat areas. Wait a few seconds and view the meat temperature.
6. Repeat temperature readings periodically until the target temperature is reached.
For accurate temperature readings, make sure the probe tips do not protrude
through the meat.
7. An alarm sounds when the target temperature is reached. Shut off is automatic.
FOOD PREPARED TEMPERATURE
Beef Rare
Medium Rare
Medium
Medium Well
Well Done
120°F / 49°C
130°F / 55°C
140°F / 60°C
150°F / 66°C
160°F / 71°C
Lamb Medium
Well Done
145°F / 63°C
160°F / 71°C
Veal Medium
Well Done
145°F / 63°C
160°F / 71°C
Pork Medium
Well Done
145°F / 63°C
160°F / 71°C
Turkey Well Done 165°F / 74°C
Chicken Well Done 165°F / 74°C
Hamburger Medium
Medium Well
Well Done
140°F / 60°C
150°F / 66°C
160°F / 71°C
Fish Well Done 145°F / 63°C
TEMPERATURE GUIDELINES
Page 5
6 7
USING THE TIMER
1. Locate the switch on back of the fork handle and move to TIMER position.
2. To set a countdown time press the “M” (for minutes) and/or “S” (for seconds)
button(s).
3. Press the START/STOP button to begin countdown.
4. If no countdown time is set, press the START/STOP to count up.
5. To clear the timer, press the START/STOP button to pause countdown, then press
both the “M” and “S” button(s). at the same time to reset to zero.
6. Once a countdown has finished, the unit will beep.
7. To stop the alarm, press the START/STOP button again or move the switch on
the back of the fork handle to the “THERMO” position.
NOTE: The timer will count up or down from 99:59.
USING THE LED LIGHT
Locate the ON/OFF switch on the side of the fork. Slide down
to turn the light ON and slide up to turn the light OFF.
CARE AND MAI NTENANCE
• Not all parts of this set are diswasher safe. Hand wash tools and fork probes
using only mild soap and hot water. Rinse thoroughly. Dry completely with a soft
cloth. DO NOT splash or submerge LCD in water.
• Avoid long-term contact with corrosives.
• Do not use metallic brushes or sponges to clean.
• Examine the brush bristels after use. Discontinue use if bristels are loose,
damaged, missing, or show excessive wear.
SPECI FICATION S
Weight .............................................................................................................Approx. 3.13 lbs (Approx. 1.4 kg)
Batteries ............................................................................................................................................................2 AAA 1.5V
Temperature Measuring Range ........................................................ 32°F to 266°F (0°C to 130°C)
Timer ...........................................................................................................................Max 99 minutes 59 seconds
LED LIGHT
VOYANT À DEL
LUZ CON
BOMBILLA LED
ON/OFF SWITCH
INTERRUPTEUR ON/OFF
(marche/arrêt)
INTERRUPTOR DE
ENCENDIDO/APAGADO
Page 6
ONE (1) YEAR LIMITED WARRANTY
Brookstone® warrants this product against defects in materials and/or workmanship
under normal use for a period of ONE (1) YEAR from the date of purchase by the
original purchaser (“Warranty Period”). If a defect arises and a valid claim is received
within the Warranty Period, at its option, Brookstone will either 1) repair the defect
at no charge, using new or refurbished replacement parts, or 2) replace the product
with a new product that is at least functionally equivalent to the original product, or
3) provide a store credit in the amount of the purchase price of the original product.
A replacement product or part, including a user-installable part installed in accordance
with instructions provided by Brookstone, assumes the remaining warranty of the
original product. When a product or part is exchanged, any replacement item becomes
your property and the replaced item becomes Brookstone’s property. When a store
credit is given, the original product must be returned to Brookstone and becomes
Brookstone’s property.
Obtaining Service: To obtain warranty service, call Brookstone Limited Warranty Service
at 1-800-292-9819. Please be prepared to describe the product that needs service
and the nature of the problem. A purchase receipt is required. All repairs and
replacements must be authorized in advance. Service options, parts availability and
response times will vary. You are responsible for delivery and the cost of delivery of
the product or any parts to the authorized service center for replacement, per our
instructions.
Limits and Exclusions: Coverage under this Limited Warranty is limited to the United
States of America, including the District of Columbia and the U.S. Territories of
Guam, Puerto Rico, and the U.S. Virgin Islands. This Limited Warranty applies only
to products manufactured for Brookstone that can be identified by the “Brookstone”
trademark, trade name, or logo affixed to them or their packaging. The Limited
Warranty does not apply to any non-Brookstone products. Manufacturers or
suppliers other than Brookstone may provide their own warranties to the purchaser,
but Brookstone, in so far as permitted by law, provides these products “as is.”
This warranty does not apply to: a) damage caused by failure to follow instructions
relating to product’s use or the installation of components; b) damage caused by
accident, abuse, misuse, fire, floods, earthquake or other external causes; c) damage
caused by service performed by anyone who is not a representative of Brookstone;
d) accessories used in conjunction with a covered product; e) a product or part
that has been modified to alter functionality or capability; f) items intended to be
periodically replaced by the purchaser during the normal life of the product including,
without limitation, batteries or light bulbs; g) any product sold “as is” including, without
limitation, floor demonstration models and refurbished items; or h) a product that is
used commercially or for a commercial purpose.
BROO KSTONE S HALL NOT BE LIABLE FOR IN CIDENTAL OR CONSE QUENTIAL
DAMAGES RESULTING FROM THE USE OF THIS PRODUCT, OR ARISING
OUT OF ANY BR EACH OF THIS WARRANTY. TO THE EXTENT PERMITTED BY
APPLICABLE LAW, BROOKSTONE DISCLAIMS ANY AND ALL STATUTORY OR
IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, WARRANTIES
OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PU RPOSE AND
WARRANTIES AGAINST HIDDEN OR LATENT DEFECTS. IF BROOKSTONE
CANNOT LAWFULLY DISCLAIM STATUTORY OR IMPLIED WARRANTIES, THEN
TO THE EXTENT PERMITTED BY LAW, ALL SUCH WARRANTIES SHALL BE
LIMITE D IN DURATION TO THE DURATION OF THIS EXPRESS WARRANTY.
Some states disallow the exclusion or limitation of incidental or consequential damages
or how long an implied warranty lasts, so the above exclusions or limitations may not
apply to you. This warranty gives you specific legal rights and you may also have other
rights, which vary from state to state.
8 9
Page 7
322803
© Brookstone 2017
Find thousands more
great ideas online
Merrimack, New Hampshire USA 03054 • 800-846-3000 • Brookstone.com
Loading...