LOCATION OF PARTS
AND CONTROLS
LITHIUM-ION BATTERY
WARNINGS
This device contains a non-removable
lithium-ion battery. The battery must be
recycled or disposed of properly.
Contact your local waste management
office for information on battery
recycling or disposal.
FCC IN FORMATION
This equipment has been tested
and found to comply with the
limits for a Class B Digital Device,
pursuant to Part 15 of the FC C
Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the distance between
the equipment and receiver.
• Connect the equipment to an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
This equipment complies with
Part 15 of the FCC Rules.
Operation is subject to the
following two conditions:
1. This equipment may not cause
harmful interference.
2. This equipment must accept any
interference received, including
interference that may cause
undesired operation.
Modifications not authorized by the
manufacturer may void the user’s
authority to operate this device.
FCC ID: 2AF8E-WL-A106
1. Micro USB Charging Port
2. LED Indicator
3. Volume -/Track FWD Button
4. Volume +/Track Back Button
5. Power/ Play/Pause Button
6. Microphone
7. Micro USB Charging Cable
(not shown)
Swivel Mini Speaker
A SPEAKER WITH A TWIST!
Fold Fold Fold Fold Fold
311935 311937 311938 311939
Merrimack, New Hampshire, USA 03054
800-846-3000 • Brookstone.com
CHARGING THE SPEAKER
1. Connect the USB Cable (included) to
the Micro USB Port on the speaker.
2. With the speaker power off, plug the
other end of the USB Cable into a
USB Port on your computer or 5V
1A USB adapter (not included).
3. The LED Indicator light will illuminate
red while charging, and the light will
turn off when the speaker is fully
charged. Charges in approximately
4 hours for up to 6 hours of listening
enjoyment.
TURNING THE SPEAKER
ON/OFF
1. Press and hold the Power Button for
3 seconds. The speaker is turned on
and will play ascending tones.
2. Press and hold the Power Button
for 3 seconds again. The speaker
will play descending tones and
power off.
NOTE: You can twist the speaker up or
leave it down as it works in both
positions.
6 5 4 3
2 1
1. Volume may be adjusted on your
audio device or by pressing and
holding the Volume Down or
Volume Up buttons.
2. A single press of the Volume
Down or Volume Up buttons will
advance to the next track or go
back to the previous track.
3. To pause audio, press the Power
Button on the Swivel Speaker. To
resume audio playback, press the
same button again.
Fold Fold Fold Fold Fold
LISTENING TO YOUR
AUDIO DEVICE
SPECIFICATIONS
Power Supply: 5V, 1A (Input)
Total Output: 3W
Range: Class 2, up to 33 ft (10 m)
Li-ion Rechargeable Battery: 680mAh
Charging Time: Approx. 4 hours
Battery Life: Approx. 6 hours
Compatibility: Bluetooth
®
2.0 or above
device with A2DP/AVRCP/HFP/HSP
The Bluetooth
®
word mark and logos
are registered trademarks owned of
Bluetooth SIG, Inc. and any use of such
marks by Brookstone is under license.
CARE AND STORAGE
Store the speaker in a cool, dry place.
MOBILE PHONE OPERATION
1. When you have an incoming call,
the speaker sounds an incoming
call tone. Both the speaker and
your mobile phone may ring,
depending on your mobile phone
settings.
2. To answer an incoming call, short
press Power Button to answer the
call.
3. To end a call, short press Power
Button once.
4. When you receive a call, while
music is playing, the song will
pause. After ending the call, the
song will continue from where it
was paused.
RESET
To hard reset the speaker, connect
to the USB cable and plug into a
charging source.
PAIRING YOUR DEVICE
1. Prepare your device to pair using
Bluetooth
®
technology, making sure
you are within 33 feet of the
speaker. Refer to your device’s
owners manual for details if
necessary.
2. Turn on the speaker.
3. The LED Indicator will flash BLUE
and the speaker is ready to pair.
4. Once the speaker is in pairing mode
and your device is ready to pair,
select “Swivel Speaker”. If prompted,
use 0000 as a PIN for the
pairing code. Once the speaker is
selected, it will play two tones to
confirm pairing is complete.
NOTE: LED Indicator light will flash
blue when the battery is low.
Loading...