FX-3 TWIN PMR 446
8 Channel 2-Way Radios
Instruction manual
SCAN
mic
English manual
NOTE: MANUAL SIZE: L125 x W100mm
Content
Contents .............................................................. 2
Introduction......................................................... 3
Controls and displays....................................... 3
Component Guide .......................................... 4
Setting Up Your PMR Radio .............................. 5
Battery Installation ........................................... 5
Battery Meter ................................................... 6
Low Battery Indicator ....................................... 6
Operation............................................................ 7
Turning on your PMR ....................................... 7
Communication................................................ 7
Receiving communications............................... 7
Respond prompt tone ....................................... 8
Channel selection ............................................ 8
To speak directly to another radio..................... 9
Range .............................................................. 9
Calling (Paging) another radio......................... 10
Automatic Squelch ......................................... 10
Monitor........................................................... 10
Channel Lock ................................................. 11
Channel Scan ................................................ 11
Monitoring the current channel..................12
Automatic Battery Save ................................. 12
Channel Frequencies ......................................13
2
Introduction
Included InYour Package
When you unpack your PMR Radio, you should
find the following items enclosed in the package:
8-channel PMR unit-2PCS
Belt-Clip -2PCS
This manual
SCAN
mic
X 2pcs
Controls and Displays
1. Power Button
2. Menu Button
3. Call Button
4. PTT(Talk Button)
5. Antenna
6. LCD Panel
7. Up Button (Change Channel and Volume)
8. Down Button (Change Channel and Volume)
9. Belt clip
3
X 2pcs
5.A n t enna
Component Guide
Sca n
SCAN
Channel
number
Ba t t e ry
le v e l
Rx
Tx
Loc k
Volu m e
6.LC D panel
8.D own bu tt o n
3.C a ll b u tt on
SCAN
mic
9. B elt c li p
4.P T T( Ta lk but ton)
7. UP but t on
1.P owe r butt on
2.M enu butt on
4
Setting Up Your PMR Radio
Battery Installation
To use the radio, you must install 3 AAA size
batteries.
Caution: incorrect positioning of the batteries
can damage both the batteries and the unit.
To install the batteries:
Remove the belt clip by pulling the tab
on the top of the belt clip back, and
sliding it up and off of the unit.
Slide the battery door down to release
the battery cover.
lnsert three AAA batteries. Position the
batteries according to the polarity
markings on the plastic.
Replace the battery cover. Snap the
belt clip back into place.
WARNING
Do not mix old and new batteries.
Do not mix alkaline,standard(carbon-zinc),
or rechargeable batteries.
5
Loading...