Broadata 4890-SP-D-4S User Manual

4890-SP-D-4S

DVI SPLITTER

BCI reserves the right to make changes to the products described herein without

prior notice or consent. No liability is assumed as a result of their use or

application. All rights reserved.

©2010 Broadata Communications, Inc.

BCI 4890-SP-D-4S User’s Manual

DVI Splitter

Broadata Technical Support, [e-mail]

3

SAFETY INSTRUCTIONS AND

COMPLIANCE DECLARA TIONS

PLEASE OBSERVE THE FOLLOWING SAFETY

PRECAUTIONS AS OUR PRODUCTS CONT AIN

CLASS I LASER PRODUCTS

WARNING

Do not disconnect the fiber optic connector while the unit is powered
up. Exposure to laser radiation is possible when the laser fiber optic
connector is disconnected while the unit is powered up.

Although the fiber optic connectors in this product emit only Class 1
energy that is below the levels considered to be hazardous, one should
never stare directly into a fiber optic connector or an unconnected fiber
end unless one can be certain that no exposure to laser energy could
occur.

CAUTION

This manual is intended for use by trained service personnel. The use
of controls, making adjustments, or performing operations other than
those specified may result in hazardous radiation exposure.

The following label or equivalent is located on the surface of laser products.
This label indicates that the product is classified as a CLASS 1 LASER
PRODUCT.

SURGE PROTECTION DEVICE RECOMMENDED

This product contains sensitive electrical components that may be
damaged by electrical spikes, surges, electric shock, lightning strikes,
etc. Use of surge protection systems is highly recommended in order
to protect and extend the life of your equipment.

CLASS 1 LASER PRODUCT

BCI 4890-SP-D-4S User’s Manual
DVI Splitter

Broadata Technical Support, [phone]

4

TABLE OF CONTENTS

1.0 PRODUCT DESCRIPTION .............................................5

2.0 OPERATION CONTROLS AND FUNCTIONS ............... 5

3.0 CONNECTION AND INSTALLATION..............................6

4.0 SPECIFICATIONS ............................................................ 7

5.0 SERVICE PROCEDURE .................................................8

5.1 REPLACEMENT POLICY ...............................................8

5.2 RETURN AND REPAIR SERVICE ................................... 8

6.0 LIMITED WARRANTY......................................................9

BCI 4890-SP-D-4S User’s Manual

DVI Splitter

Broadata Technical Support, [e-mail]

5

1.0 PRODUCT DESCRIPTION

BCI’s 4890-SP-D-4S is a high performance HDCP compliant DVI
distribution amplifier. It allows same DVI or HDMI signal source to split
up to four identical and buffered displays for multi-viewing purposes. The
4890-SP-D-4S has a built-in EDID and HDCP bypass that ensures
each output can be displayed. HDMI source and display are compatible
by using the HDMI to DVI adaptor cable. It supports a wide range of
PC and HDTV resolutions from VGA to UXGA and 480p to 1080p. This
4890-SP-D-4S can be cascaded up to 3 layers. Each of the buffered
output can run up to 15 meters.

2.0 OPERATION CONTROLS AND FUNCTIONS

Front Panel

1. DVI input: Connect to the DVI or HDMI output of your source
equipment such as DVD player or PC graphic card.

2. DVI output 1: Connect to the digital input of your first display .

3. Sync LED: The LED will illuminate when the source signal is
connected.

4. Power input: Plug the supplied 5VDC power supply into the unit
and the LED will illuminate when connected.

BCI 4890-SP-D-4S User’s Manual
DVI Splitter

Broadata Technical Support, [phone]

6

Rear Panel

1. DVI output 2/3/4: Connect these ports to the digital input of
each output display .

3.0 CONNECTION AND INSTALLATION

BCI 4890-SP-D-4S User’s Manual

DVI Splitter

Broadata Technical Support, [e-mail]

7

4.0 SPECIFICATIONS

Frequency Bandwidth 1.5Gbps (single link)
Input/Output 1-in/4-out DVI female port
Power Consumption 6W max.
Power 5VDC Universal Power Supply

Physical

Dimension (H x W x D) 1.49” x 4.02” x 5.55”
Operating Temperature 0 to +40oC

Humidity 30 to 80% RH, non-condensing

BCI 4890-SP-D-4S User’s Manual
DVI Splitter

Broadata Technical Support, [phone]

8

5.0 SERVICE PROCEDURE

5.1 Replacement Policy

Standard products found defective on arrival (DOA) will be
replaced, based on availability , within 24 to 48 hours anywhere
in the U.S. Please call Customer Service at 800-214-0222 for
information.

5.2 Return/Repair Service

The BCI 4890-SP-D-4S System contains no user serviceable
components. If you have a problem with your unit, please contact
the Customer Service Department. To facilitate our return/repair
processing please contact Broadata Communications, Inc. to
obtain a Return Material Authorization (RMA). Please include
the following information:

• Product model number

• Serial Number

• Complete description of problem

• Hardware installation description

Broadata Communications, Inc.

2545 West 237th Street, Suite K

T orrance, CA 90505

1-800-214-0222

[phone]

[phone] (Facsimile)

e-mail: [e-mail]

Website: www .broadatacom.com

BCI 4890-SP-D-4S User’s Manual

DVI Splitter

Broadata Technical Support, [e-mail]

9

6.0 LIMITED WARRANTY

Broadata Communications, Inc. (BCI) warrants, for a period of one year
from date of shipment, each product sold shall be free from defects in
material and workmanship. BCI will correct, either by repair, or at BCI’ s
election, by replacement, any said products that in our sole discretion
prove to be defective and are returned to the manufacturing location
within 30 days after such defect is ascertained. All warranties are limited
to defects arising under normal use and do not include malfunctions or
failure resulting from misuse, abuse, neglect, alterations, electrical power
problems, usage not in accordance with product instructions, improper
installation, or damage determined by BCI to have been caused by the
Buyer or repair made by a third party. Limited warranties granted on
products are to the initial customer end-user and are not transferable.
OUR LIABILITY UNDER THIS WARRANTY SHALL IN ANY CASE BE
LIMITED TO THE INVOICE VALUE OF THE PRODUCT SOLD AND BCI
SHALL NOT BE LIABLE TO ANYONE FOR CONSEQUENTIAL OR
INCIDENT AL DAMAGES ARISING FROM THE USE OF ITS PRODUCTS
OR THE SALE THEREOF. We make NO WARRANTY AS TO THE
MERCHANT ABILITY OF ANY GOODS, OR THA T THEY ARE FIT FOR
ANY P ARTICULAR PURPOSE OR END APPLICATION NOR DO WE
MAKE ANY WARRANTY, EXPRESSED OR IMPLIED OTHER THAN
AS ST A TED ABOVE.

Broadata Communications, Inc.

2545 West 237th Street, Suite K

Torrance, CA 90505

1-800-214-0222

[phone]

[phone] (Facsimile)

e-mail: [e-mail]

Website: www.broadatacom.com

60000-4890-SP-D-4S