BRK electronic ETL ADF Adapter User Manual

INSTALLATION OF THE

ADF ADAPTER PLUG

ELECTRICAL SHOCK HAZARD. T will install this unit at the cir installation. Failure to turn off the power before installation may result in serious electrical shock, injury or death. Do not restore power until all Smoke Alar

For all other Smoke Alarm information, instructions and warnings, refer to the Smoke Alarm User’s Manual.

ms are completely installed.

•

Installation of this unit must conform to the electrical codes in your

ea; Article 760 of NFPA 70 (NEC), NFPA 72, NFPA 101; SBC (SBCCI);

ar UBC (ICBO); NBC (BOCA); OTFDC (CABO), and any other local or building codes that may apply. Wiring and installation must be performed by a licensed electrician. Failure to follow these guidelines

esult in injury or property damage.

may r

•

This unit must be powered by a 24-hour, 120VAC

cuit. Be sure the circuit cannot be turned off by a switch, dimmer,

cir

ound fault circuit interrupter. Failure to connect this unit to a

or gr 24-hour circuit may prevent it from providing constant protection.

urn off power to the area where you

cuit breaker or fuse box before beginning

pure sine wave

60Hz

COMPATIBLE BRK®MODELS

All of the listed BRK®and First Aler FIREX®Alarms and will work with the enclosed Adapter Plugs.

e compatible with the listed

Alarms ar

BRK®Alarms 4120, 9120 Series – AC, AC/DC Ion, Silence

5919 – AC Photo 2002RAC – AC/DC Photo 7010 Series – AC, AC/DC Photo, Silence SC6120B, SC9120B – AC/DC Smoke/CO Combo HD6135FB – Heat Alarm RM3 – Auxiliary Relay

FIREX 406 (Model #G-6) – AC Ion

4518 (Model #ADC) – AC/DC Ion, Battery in Rear 4618 (Model #FADC) – AC/DC Ion 5000 (Model #FADC) – AC/DC Ion, Latching LED 484 (Model #PG-40) – AC Photo 4480 (Model #PAD) – AC/DC Photo 5700 (Model #ADH) – Heat Alarm 499 – Auxiliary Relay

Maximum of only 12 units (except model G-6) may be interconnected.

•

Check for model numbers above.

Adapter Plug (ADF) Diagram for FIREX®Models:

Plug Pin

iew

NOTE: T

Side View

wist tie should not be r

emoved.

White Orange

Black

INSTALLATION INSTRUCTIONS

erify which

1. V

compatible with the ADF Adapter Plug (see part C below).

urn off AC power.

2. T

MODELS ar

3. Remove unit. Remove old mounting bracket.

4. Install new mounting bracket (see part A below).

5. Connect the black end of the ADF Adapter Plug to the existing power

connector (connect part C to part D as shown below).

NOTE: There may not be enough room for the Adapter Plug and additional wiring to fit in the junction box. If not, the old power connector must be

emoved and r

Connect the other end of the Adapter Plug to the appr

(connect part C to part B as shown below).

7. Check all connections. Make sure all plugs are completely connected and

snapped together existing Power Connector

eplaced with a First Alert

8. Install the base of the Smoke Alarm to the mounting bracket.

9. Restore power to the junction box.

10. Test each Smoke Alarm. Press and hold the test button until the unit alarms.

When testing a series of interconnected units you must test each unit individually. Make sure all units alarm when each one is tested.

e installed in your system to determine if they are

Power Connector

opriate Smoke Alarm

. Ensure the Adapter Plug is securely connected to the

The Parts of This Installation

A Mounting Bracket B

BRK® 4120, 9120 Series

Smoke Alarm C ADF Adapter D Existing compatible

power connector

Electrical Rating: 120V AC, 100mA Maximum

Not for Current Interruption

NOTE: ADAPTER PLUG CANNOT BE USED TO CONNECT MONOXIDE ALARMS.

THE ABOVE MODELS OF FIREX INTERCONNECTED USING ONE OF THE ADAPTER PLUGS INCLUDED. IF THE MODEL IS NOT LISTED, IT MUST BE REMOVED FROM THE SYSTEM.

ARE THE ONLY MODELS THAT MAY BE

FIREX® CARBON

NOTE:

TIBLE POWER CONNECTORS:

INCOMP

DO NOT A

TTEMPT

INSTALLATION

FIREX

NOTE: Adapter Plug can be used on FIREX® Models manufactured on or

before January 1, 2004.

Independent evaluation of the Adapter Plug and inter compatibility was performed by Intertek, a division of ETL SEMKO.

connect

RECOGNIZED COMPONENT

CONFORMS TO

ANDARD 1977

UL ST

3055574

US Patent No.: 6,641,433 B2 BRK First Alert Firex

fairs: (800) 323-9005 • www

is a registered trademark of BRK Brands, Inc.

is a registered trademark of the First Alert Trust.

is a registered trademark of Maple Chase Company.

.firstalert.com • www

.brkelectronics.com

Printed in Mexico M08-0125-001 H 06/07