BriskHeat SRP18181P, SRP18181PADJB, SRP18182P, SRP12362PADJB, SRP12361P Instruction Manual

Silicone Rubber Heating
Blankets

Specially designed for Cole-Parmer and Davis Instruments

Cole-Parmer

625 E. Bunker Court
Vernon Hills, IL 60061
Phone: [phone]

Fax: [phone]

PN: 11661-02 Rev B

Instruction Manual

Read and understand this material before operating or
servicing these heaters. Failure to understand how to
safely operate these heaters could result in an accident
causing serious injury or death. These heaters should
only be operated by qualifi ed personnel.

Silicone Rubber Heating Blankets

Silicone Rubber Heating Blankets

TABLE OF CONTENTS

Introduction...................................................................

Safety Alert Symbol.......................................................

Important Safety Instructions……………......................

Prior to Installation........................................................

Mounting Your Heating Blanket…………......................

Connecting Your Heating Blanket to a Power Source...

Troubleshooting Guide……………………………..........

Warranty........................................................................

INTRODUCTION

Thank you for purchasing a
BriskHeat® Silicone Rubber Heating
Blanket. Your heater is designed
to provide a long and effi cient
service life with function, reliability,
and safety in mind. For additional
information concerning this, or other
Cole-Parmer products, please
contact us toll free at
1-800-323-4340.

SAFETY ALERT SYMBOL

The symbol above is used to call your attention
to instructions concerning your personal safety. It
points out important safety precautions. It means
“ATTENTION! Become Alert! Your Personal
Safety is involved!” Read the message that
follows and be alert to the possibility of personal
injury or death.

2
2
3
4
5
6
7
BACK

TROUBLESHOOTING GUIDE

Please read this guide prior to contacting Cole-Parmer. This guide is designed
to answer the most commonly asked questions. If you are unable to identify the
problem or need additional assistance, please contact Cole-Parmer at
1-800-323-4340.

PROBLEM SOLUTION(S)

Does not heat Verify heater is connected to proper voltage.

Check to see if there is a resistance reading (not an
open circuit) in heater using an ohm meter.

Pressure sensitive adhesive is not
adhering

Circuit breaker is tripping Validate that the circuit breaker is capable of handling

Ensure there are no air gaps and heater is making
intimate contact with surface being heated. Use a
medium to hard rubber roller.

the amp requirement of heater. The identifi cation
label located on the power cord displays the heater’s
amperage requirement.

Examine heater and cord for any damage.
Check to see if there is a resistance reading between

power leads and the ground lead.

Immediate hazards which WILL result in severe
personal injury or death

Hazards or unsafe practices which COULD result in
severe personal injury or death

Hazards or unsafe practices which COULD result in
minor personal injury or property damage.

SAVE THESE INSTRUCTIONS!

Additional copies of this manual are available upon request.

2

7