Brinkmann 810-5010-0, 810-5100-0, 810-5100-1 Owner's Manual

OWNER’S MANUAL

ASSEMBLY AND OPERATING INSTRUCTIONS

WARNING

READ AND FOLLOW ALL WARNINGS AND

INSTRUCTIONS IN THIS MANUAL TO AVOID

PERSONAL INJURY OR PROPERTY DAMAGE.

D

R

A

U

•

G

G

IMPORTANT SAFETY WARNINGS

WE WANT YOU TO ASSEMBLE AND USE YOUR COOKER AS SAFELY AS POSSIBLE.

THE PURPOSE OF THIS SAFETY ALERT SYMBOL

IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR SMOKER.

WHEN YOU SEE THE SAFETY ALERT SYMBOL, PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS!

THE WARNINGS BELOW APPLY TO ALL USES OF THE ALL-IN-ONE. ADDITIONAL WARNINGS SPECIFIC TO EACH

USE OF THE ALL-IN-ONE MUST BE FOLLOWED IN CONJUNCTION WITH THESE WARNINGS.

1

WARNING

• Only use this cooker on a hard, level, noncombustible, stable surface (concrete, ground, etc.) capable of supporting the weight of the
cooker. Never use on wooden or other surfaces that could burn.

• Always use a drip pan/ash guard under cooker when using as a charcoal grill or charcoal smoker to protect surface from heat damage
and/or discoloration and to catch ashes, embers and drippings. Place a thin layer of water in drip pan/ash guard to help extinguish
falling ashes and embers. A drip pan/ash guard is designed for use with a smoker for easy clean up of drippings that can cause
discoloration of surface and to catch falling ashes and embers.

• Do not store or use smoker near gasoline or other flammable liquids, gases or where flammable vapors may be present.

• Proper clearance of 10 feet between the cooker and combustible material (bushes, trees, wooden decks, fences, buildings, etc.) or
construction should be maintained at all times when smoker is in use. Do not place cooker under a roof overhang or other enclosed
area.

• Do not leave cooker unattended when in use.

• Never move cooker when it is in use or when it contains hot coals or ashes. Do not move cooker when water pan contains hot liquids.

• For household use only. Do not use this cooker for other than its intended purpose.

• For outdoor use only. Do not operate cooker indoors or in an enclosed area.

• Use caution when assembling and operating your cooker to avoid scrapes or cuts from sharp edges of metal parts.

• Place cooker in an area where children and pets cannot come into contact with unit. Close supervision is necessary when cooker
is in use.

• Water pan should always be used when smoking. Do not allow liquid in water pan to completely evaporate. Check water pan every
2 hours and add water if level is low (a sizzling sound may indicate a need for water). Follow instructions in “Adding Water During
Cooking” section of this manual.

• Always keep water in water pan even after food is removed from smoker. Water will evaporate and grease in water pan can
catch on fire.

• Use caution when lifting or moving cooker to prevent strains and back injuries.

• In windy weather, cooker should be located in an outdoor area that is protected from the wind.

• Do not wear loose clothing or allow hair to hang freely while using cooker.

• Use caution when reaching into or under cooker. Always wear oven mitts/or gloves to protect your hands from burns. Avoid touching
hot surfaces.

• Always wear shoes when operating cooker.

• We advise that a fire extinguisher acceptable for use with gas products be on hand. Refer to your local authority to determine proper
size and type of fire extinguisher.

• Do not attempt to service cooker other than normal maintenance as explained in “After-Use Safety” and “Proper Care & Maintenance”
sections of this manual. Repairs should be performed by The Brinkmann Corporation only.

• Accessory attachments not manufactured by The Brinkmann Corporation for this particular product are not recommended and may
lead to personal injury or property damage.

• Properly dispose of all packaging material.

USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR SMOKER.

FAILURE TO ADHERE TO SAFETY WARNING AND GUIDELINES IN THIS MANUAL COULD RESULT

IN BODILY INJURY OR PROPERTY DAMAGE.

SAVE THIS MANUAL FOR FUTURE REFERENCE.

PARTS LIST:

1 Cooker with Burner Assembly
1 Hose and Regulator with Safety Tag
1 Vented Aluminized Base Pan
3 Aluminized Legs/Brackets
1 Smoker Body
1 Dome Lid
2152" Chrome Cooking Grills
1 Water Pan
1 Drip Pan/Ash Guard
3 Metal Brackets for Handles
6 Wooden Handle Halves
1 Heat Indicator
3 Lower Support Brackets (V Clip)
3 Upper Support Brackets (Single Clip)
1 Bag Lava Rocks
18 10-24 x s" Screws and Square Nuts
6 8-32 x w" Screws and Nuts (for Handles)

2

ASSEMBLY INSTRUCTIONS

READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY

BEFORE ASSEMBLING OR OPERATING YOUR COOKER.

FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-527-0717.

(Proof of purchase will be required.)

Inspect contents of the box to ensure all parts are
included and undamaged.

The following tools are required to assemble your
All-In-One:

• Flathead Screwdriver

• Adjustable Wrench

• d" Open End Wrench

• w" Open End Wrench

• f" Open End Wrench

NOTE: An additional adjustable wrench can be

substituted for the open end wrenches.

1

3

2

4

5

6

7

8

9

10

11

12

13

14

3

2

4

5

6

7

8

9

10

11

12

13

14

15

4

10

11

15

(Drip Pan/Ash Guard to be

used only with charcoal

smoker or charcoal grill.)

16

1

D
R

A

•

U

G

G

A

F

S

T

E

F

A

.

S
I

O

F

G

Y

H

D

.

L

A

D

R

T

E

P

N

.

N

S

O

E

R

L

O

V

A

F

S

T

O

I

T

N

E

N

M

H

N

N

V

O

O

E

T
L

E

A

E

S

R

A

M

E

V

T

T

A

V

T

S

L

O

G

R

S

L

U

A

N

.

U

O

V

N

O

O

J
K
R

R

G

P

D

D

N

T

U
N

•

I

A

A

N

T

M

S

T

I

E

O

U

C

M

A
L
F

3

STEP 1:

Remove nut from bottom of burner
assembly.

STEP 2:

Position the stand upside down as shown.

STEP 3:

Place burner assembly inside stand with
threaded bolt protruding through support
strap as shown.

STEP 4:

Thread nut onto bolt and securely tighten.
Do not overtighten.

STEP 5:

a. Set cooker with burner assembly upright

on flat surface. Make sure burner
assembly is securely attached to cooker.

b. Attach female SAE fitting on hose

assembly (using w" wrench) to the male
SAE fitting on the burner (using d"
wrench). Hold the male SAE fitting
securely with one wrench and turn the
female fitting with the other wrench until
they are tightly joined.

STEP 6:

a. Align the holes in the leg brackets with the

screw holes in the base pan and attach
using 10-24 x s" screws and nuts.
Tighten securely.

b. Place the base pan with attached legs on

the cooker. Align the three legs of the
base pan with legs of the cooker. Press
down firmly until there is no gap between
bottom of base pan and top of cooker.

Air Opening

Air Shutter Valve

Hold d" Wrench

Turn w" Wrench

Nut

Support Strap

Burner Assembly

Stand

NOTE: Make sure the male SAE fitting on the

cooker is screwed into the air shutter and
tightened securely. Do not over-tighten as
the air shutter needs to move freely in
order to adjust air intake. Check the
attachment for proper connection every
time propane tank is connected to cooker.

4

STEP 7:

a. Attach wooden handle halves to metal brackets

using 8-32 x w" screws and nuts as illustrated.

b. Attach two handle assemblies to side of smoker

body using 10-24 x s" screws and square nuts
as illustrated.

c. Attach the three lower support brackets (V clips)

to inside of smoker body through the three 4"
holes that are located about halfway down on
sides. Mount each bracket with notched side
facing up using 10-24 x s" screws and square
nuts. Tighten screws securely.

d. Attach the three upper support brackets (single

clips) to inside of smoker body through the three
4" holes located near the top edge. Mount each
bracket with notched side facing up using
10-24 x s" screws and square nuts. Tighten
screws securely.

STEP 8:

a. Place water pan inside smoker body on top of

lower support brackets. Position water pan so
the rim is resting securely on notched out step
of all three support brackets. Place smoker body
on base pan.

b. Place a 152" cooking grill on the lower support

brackets directly above water pan.

c. Place a 152" cooking grill on the upper support

brackets so the rim is resting securely on
notched out step of all three support brackets.

Lower support bracket

(V-clip) with notched side

facing up.

Upper support bracket

with notched side

facing up.

152" Cooking Grill

152" Cooking Grill

Water Pan

5

STEP 9:

a. Attach handle on top of dome lid using

10-24 x s" screws and square nuts.

b. Install heat indicator in dome lid by

aligning tabs on heat indicator with slots
in the opening on front of dome lid. Insert
and turn 4 revolution until the word
“IDEAL” on the heat indicator is at the top
of the dial.

c. Place dome lid on upper support brackets

of smoker body.

NOTE: The dome lid is not designed to fit

snugly in the smoker body. The gap
between the dome lid and smoker
body allows proper air draft.

d. Proceed to “Gas Leak Testing” section of

this manual.

Fully Assembled All-In-One

NOTE: Before first use and after cleaning,

apply a light coat of vegetable oil or
vegetable cooking spray to the
interior surface of the dome lid,
smoker body, cooking grills and
water pan. This simple process will
help reduce interior rusting. DO NOT
apply oil to the base pan or the
cooker portion of the All-In-One.