1.Basic knowledge of ............................................................................................................................................... 1
1.1 Introduction to the ......................................................................... 1
2.Mobile phone appearance and buttons ............................................................................................................. 2
2.1 Keys on mobile phones ..................................................................... 2
3.Begin to use .......................................................................................................................................................... 2
3.1 Install the USIM/SIM card and battery ...................................................... 2
5.The basic function ................................................................................................................................................ 5
5.24 Play store ........................................................................................................................................................ 12
6.2 fast light charger .......................................................................... 13
6.3 use and maintenance ...................................................................... 13
1
1.Basic knowledge
Near the gas station, chemical plants, or perform explosive operations must be shut down, because the mobile
phone will affect technical installation procedures.
In hospital should be shut down, because the cell phone may affect certain functions of medical equipment, such
When driving, be sure to use headphones, avoid traffic accidents caused by driving single hand.
Disused batteries according to local conditions to properly handle, please.
Mobile phone may interfere with television, radio, or personal computers and other electrical equipment.
In flying any moment must be turned off, lest mobile electronic system, caused the plane accident.
USIM/SIM card can be unloaded, please pay attention to avoid children swallowed such widgets.
Do not exceed the specified voltage power supply system, and please use the provided external devices.
In any case, it shall not be cracked open the phone or battery, and it is strictly prohibited to change the
equipment.Mobile phone tamper label if there is damage, the warranty service failure.
1.1 Introduction
In order to make best use of your mobile phone, please read this manual carefully.
The phone is our company newly launched a based on Android platform of wcdma/GSM dual mode of
smart phones. It is the perfect crystallization of humanized design and exquisite technology, with exquisite
fuselage streamline, feels comfortable. Function, it has a stereo sound, powerful file management
function (support T - FLASH card), slide play function, MP3, MP4 functions, tape recorder, pictures,
support MMS (MMS), length of the letter, WAP surfing the Internet and other commonly used functions;
With the help of the 3 g technology to bring high-speed broadband connection, you can free to swim in
the online world, can also be convenient and quick to download and install what you need all kinds of files
and applications. Convenience of your work and life, bring you endless fun.
1.2 Safety precautions
(警告:使用不当会导致保修失效!)
2
2.Mobile phone appearance and buttons
2.1 Keys on mobile phones
¨ menu: in the standby interface, press this button to display Settings wallpaper, the application of management and system
Settings
¨ Home button: the standby mode, press this button to return to the interface of standby
¨ return button: click this button to return to the interface of at the next higher level
¨ open key: short press the lock screen functions; Long press boot and shutdown
¨ volume button: adjust the volume
3.Begin to use
3.1 Install the USIM/SIM card and battery
USIM/SIM card with your private information.Holds your phone number and PIN (personal identification
number), PIN2, PUK (PIN unlock password), PUK2 (PIN2 unlock password) and IMSI (international mobile
subscriber identification), contact number and the network information data and information data, and so
on.
Note:
1. Please make sure that the user note: this phone only support 3 v SIM/USIM card support GSM SIM card
3
2. In China at present the domestic various operators do not provide PIN2 and PUK2 code.The need to use the above password
function in the cell phone may not be able to use, please the user attention.
3. Turn off the phone and in a few seconds, and then pull out or insert SIM/USIM card, do not dial out in the process of cell
phone use normally or insert SIM/USIM card.
4. Please be careful operation USIM/SIM card, friction or bent easy to damage the SIM/USIM card.
5. Please note that the SIM/USIM card in the mobile phone and its accessories such as keep small parts, and in the place out of
reach of children, normal temperature to room temperature is 25 degrees, the highest working environment temperature of 40
degrees, the minimum temperature of 0 degrees in work environment.
3.1.1 Installation steps
Steps as follows:
1. Turn off the phone and remove the battery.
2. Select USIM/SIM card place holder.According to the direction of the slot icon to push the SIM/USIM card carefully into the
slot of a SIM/USIM gets stuck.
3. Make sure that a SIM/USIM card after making the proper installation and battery assembly, close the back cover.
3.1.2 Use the password
Your mobile phone and USIM/SIM CARDS have many passwords.These password helps prevent cell phones and USIM/SIM card
stolen.When entering the following mention any password, enter the correct password and press the virtual keyboard keys.If
an error occurred when the input, please first press the virtual keyboard clear button to delete the incorrect input, and then
input the correct number.Can use a function table "security - > set SIM card lock/screen lock" to modify or open the PIN
number and mobile phone password.
* PIN code
PIN (personal identification number, 4 to 8 bits) used to prevent your SIM/USIM card has been unauthorized use.PIN usually
SIM/USIM card provided by the network operator.If launched the PIN test function, each time will be asked to input PIN when
the phone is switched on.If you lose the wrong PIN number three times, SIM/USIM card will be locked and unlock method is as
follows:
1. Press the screen prompt enter the correct PUK code, to unlock the SIM/USIM card.
2. Then enter the new PIN.
3. When prompted heavy lose new PIN number, enter the new PIN again.
4. If PUK code is correct, then unlock SIM/USIM card, PIN has been reset.
Note: lose the wrong PIN number three times, SIM/USIM card will be locked, need the PUK code to unlock it.PUK code
generally stored in the network operators.
* PIN code
PUK code (PIN unlock password, 8) for solution of lock PIN.PUK code with USIM/SIM card provided by the manufacturer.If did
not provide, please contact to provide you with services of network operators.If you input wrong PUK code ten times, the
SIM/USIM card fails, contact network operators need to change the new card.
* PIN2 code
PIN2 code (4 to 8) provide with a SIM/USIM card is used to set the "call" and "f ixed dialing", etc. Please contact the network
operator to determine whether your USIM/SIM card support these functions.If you lose three times wrong PIN2 code, PIN2
code will be locked, only after the input the correct PUK2 code can make PIN2 code to unlock.Unlock method is as follows:
1. According to the screen prompts for correct PUK2 code, to unlock.
2. Then enter the new PIN2 code.
4
3. When prompted heavy lose new PIN2 code, enter new PIN2 code again.
* PUK2 code
PUK2 code (PIN2 code unlock password, 8 bits) used to unlock live PIN2 code.PUK2 code with USIM/SIM card provided by the
manufacturer.If did not provide, please contact to provide you with services of network operators.If you input the wrong PUK2
code ten times, you will not be able to use need PIN2 code function, if use these features, contact network operators need to
change the new card.
* password ban
Using a call limit function, will be used password is prohibited.You when applying for the network function, can be obtained
from network operators to the password.
* phone password
Is mainly used to protect users' privacy is being violated, can be in the menu "Settings - > security - >" screen lock into the set.
Not that all users can enter to the main interface.
Slide: users only need to gently slipped to enter to the main interface.
Face unlock: users can through the face is to unlock screen to the main interface
Voice to unlock: the user can unlock by voice commands to the main interface
Design: the user can in the rectangle icon by using a 3 X 3 consecutive connection after at least four buttons, a design can set
the password.
PIN: the user can enter at least four Numbers can complete set.
Password: the user must enter at least four and contains at least one letter can complete set of characters.
After completion of the above Settings, the user each time all needs to input the corresponding password to enter the system
boot, except the slide to unlock, if password input error number for more than f ive times, will be locked for 30 seconds, 30
seconds to enter again.
3.2 Storage device
T - FLASH card is located in the internal pluggable mobile phone memory card, when the mobile phone function and enable
USB storage and computer connected after transmission from the computer to the phone in the data files can be stored in the
T - FLASH card, or T - file transfer of data in the FLASH card into the computer.
Mobile phones with USB data cable connected to the computer USB interface is correct, the screen will pop up box "USB
mass storage device", below open "USB storage devices" can set the phone to mobile hard disk storage device that can upload
download function.
Note: remove and insert T - before the FLASH card, please confirm whether the phone was turned off.
3.3 battery charge
This machine with lithium ion batteries apart can be used after packaging.The first three time charge in electricity
thoroughly after use, please fully filled again, to give the best state of battery.
3.3.1 battery indicator
Your mobile phone can monitor and display the information of the battery.
1. Normally you can see the battery from the display battery icon in the top right corner of the remaining power.
2. When the battery is insufficient, the screen shows "please connect your charger.
3. When the battery is charging, charging status animation, stop charging animation and the lock screen interface display
"is full of" charging is complete.
4. For other related parameters of battery and charger, please see the material object.
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.