Page 1
TECHNICAL SPECIFICATION
HOW TO USE HOW TO USE
W speaker
Light Source
Transmission Type
Dimensions
Weight
Charging Interface
Power Consumption
Frequency Response
Battery
Battery Charge Time
Normal Volume Playing Time
Transmission Distance
HOW TO USE
Charging
: Dimmable LED
: Bluetooth V4.1
: 75 x 110mm
: 250g
: DC 5V-1A Micro USB
: 5W
: 200 Hz～20 kHz
Li-ion Rechargeable
:
Battery 3.7V 1700mAh
: 3 hours
: 5 hours
(Transmission distance
: < 10M
depend on the environmental
factors with your phone or
Bluetooth device differs.)
3hrs
Dimmable switch
30%
Press
once
X1
Speaker ON/OFF
pairing
100% OFF
Press
once
X1
Press
once
X1
TWS pairing
A B
1.
A&B
2.
A or B
3.
X1
Press
once
Turn on BT
select
W speaker
Press
&Hold
Flashing blue
and red light
forpairing mode
2s
Flashing blue light is Master
red light is Satellite
blue light
W
red
light
green
light
Press
Turn on BT
select
W speaker
Press
&Hold
&Hold
2s
2s
1.
2.
Flashing blue
and red light
for pairing mode
blue light
Page 2
FCC ID: 2AJ8KSP1701
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter
Loading...