Brickcom MD-500Ap-360p, MD-500Ap-360, MD-300Np-360p, MD-300Np-360 Installation Manual

Easy Installation Guide

High Megapixel 360° Panomorph

Mini Dome IP Network Camera

MD-500Ap-360P Series
MD-300Np-360P Series

- 1 -

a. Camera

b. Product CD

c. Allen Key for The Lens
d. Allen Key for The Cover

e. Warranty Card

f. Screw Bags x 2

g. Dry Bag & Double-Sided Tape

h. Alignment Sticker

i. Easy Installation Guide

j. Mounting Adapter

k. TV-Out Connector Cable (Optional)

l. M12 Ethernet Connector
(for M12 Ethernet Models Only)

M. Waterproof RJ45 Ethernet Connector
(for RJ45 Ethernet Models Only )

Package Contents

- 2 -

Hardware Installation

Step 1. Check The Product Package

Please make sure that the product package contains all the accessories listed above.

Step 2. Hardware Installation

Do not mount the camera on a soft material. The camera may fall and be damaged.

When removing the cover, please be aware of the microphone line.

1. Use the enclosed Allen Key to detach the cover from the camera.

2. Take the dry bag out of its package. Use the double-sided tape to stick the dry bag onto
the designated position inside the cover.

- 3 -

3. Choose the location on the wall or ceiling to place the camera. Attach the location sticker

to the desired spot.

4. Drill three holes through the center of the three location holes on the sticker.

5. Hammer the three plastic anchors which are provided in the product package into the

three location holes.

6. It is recommended that the waterproof RJ45 Ethernet connector (for the RJ45 Ethernet models
only) be used, and then the waterproof tape be used to wrap around the Ethernet connector and
the DC12V connector, in order to prevent water from going into the connectors.

- 4 -

7.

a. If you don't use the Mounting Adapter, please use the three shorter screws which are

included in the product package. Mount the camera on the wall or ceiling and position
the three screw slots over the plastic anchors. Insert the screws into the holes and
use the screwdriver to tighten the screws clockwise until they are secure.

b. If you do use the Mounting Adapter, please use the three longer screws which are

included in the product package. Mount the camera on the wall or ceiling and position
the three screw slots over the plastic anchors. Insert the screws into the holes and
use the screwdriver to tighten the screws clockwise until they are secure. You can use
one of the remaining screws to fix the Mounting Adapter.

- 5 -