In many countries, there are laws prohibiting or restricting the use of surveillance
devices. This Network Camera is a high-performance, web-ready camera which can be
part of a flexible surveillance system. It is the user’s responsibility to ensure that the
operation of this camera is legal before installing this unit for its intended use.
Upon opening the product’s package, verify that all the accessories listed on the
“Package Contents” are included. Before installing the Network Camera, read the
warnings in the “Quick Installation Guide” to avoid misuse. When installing the
Network Camera, carefully read and follow the instructions in the “Installation” chapters
to avoid damages due to faulty assembly or installation.
1
Regulatory Information
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The availability of some specific channels and/or operational frequency bands are country
dependent and are firmware programmed at the factory to match the intended destination.
The firmware setting is not accessible by the end user.
- -
a. MD Series/ MD-300Np-360 Series
b. Product CD
c. Adjusting Lens Tool (MD Series only)
d. Allen Key
e. Warranty Card
f. Screw Bags(2pcs)
g. Dry Bag / Double-Sided Tape
h. Alignment Sticker
i. Easy Installation Guide
j. Mounting Adapter
k. TV out Connector Cable (Optional)
l. M12/RJ45 Connector(Optional)
Chapter 1 - Package Contents
Please check to make sure that the product package contains all the accessories listed below.
- 3 -
Chapter 2 - Mini Dome Network Camera
Overview
The Brickcom Mini Dome Network Camera designed for outdoor use. MD series has a
compact and stylish design, also provides Full HDTV video (1080p @ 30fps). IP67 certified,
IK10 vandal-proof and EN50155 Anti Vibration and Shock, it is perfect for outdoor surveillance,
and surveillance in buses, trains, subway cars and emergency vehicles.
The Mini Dome Network Camera series is designed to provide end users with high quality
video feed for an easily accessible security system. By offering H.264/M-JPEG/MPEG-4 triple
codec compression, it is able to offer a flexible system which does not require high bandwidth
and storage capabilities. The internal micro SD/SDHC/SDXC memory card slot allows for local
storage, which prevents data loss if the data connection is lost. The Mini Dome Network
Camera 360 Series comes with a wide-angle lens and 360° Immervision Panoramic Lens and
Pan 35°/ Tilt 0-90° / Rotation 180° wide angle adjustment, allowing a wide open view for
maximum coverage.
Different from other dome cameras, Mini Dome Network Camera Series supports
exchangeable lenses for different conditions.
The Mini Dome Network Camera series is designed for easy installation. With the BNC
TV-Out Connector, the camera can be connected to a monitor which makes it easier for
installers to adjust the picture focus while setting up the camera. The MD-500A series/
MD-300N series is equipped with a special designed mounting adapter and can be installed
on a curved surface. The camera supports different power inputs such as PoE 802.3af, M12
and DC12Vs
- 4 -
Chapter 3 - Device Appearance Description
(*) These are optional features. Please refer to the Product List for the full list of
optional features that are available for this product (About MD-500Ap-360P-AL/
MD-300Np-360P-AL, please kindly refer to datasheet).
- 5 -
Function
LED Behavior
Description
Remark
Status
Steady On
Normal Operation
Blue
Status
Unlit
1. Power off
2. Power on till System
setup
Blue
Status
Upgrading F/W
Blue
Internet
Blinking
Blinking while network
connection in progress
Blue
Internet
Unlit
No connection
Blue
Power
Unlit
Power off
Blue
Chapter 4 - LED Behavior
- 6 -
Chapter 5 - Installation
5.1 Hardware Installation
WARNING: Do not mount the camera on a soft material. The camera may fall and be damaged.
1. Use the enclosed Allen key to detach the dome cover from the camera device.
As remove the cover, please be aware of the Microphone Line.
2. Remove the dry bag from its package. Use the double-sided tape to stick the dry bag
onto the designate position inside of the dome cover.
3. Choose the location on the wall or ceiling to place the camera. Attach the location sticker
to the desired spot. For ceiling installation, the best place to mount the camera is into a
ceiling stud.
- 7 -
4. Drill three holes through the center of the three location holes on the sticker.
5. Hammer the three plastic anchors which are provided in the product package into the
three location holes.
6. Please use the “Waterproof Tape” to wrap around the RJ45 connector, DC12V connector, USB
connector (*), in order to prevent water to seep in to the connectors.
- 8 -
Loading...
+ 23 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.