Breville HotCup VKJ367 User Manual
HotCup
™
water dispenser
boils water in seconds
®
2
PRODUCT SAFETY
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children unless they are
older than 8 and supervised. Keep the appliance and its cord
out of the reach of children aged less than 8 years.
Never use a power base other than the one supplied with the
appliance.
Never ll the kettle above the MAX marking. If the kettle is
overlled, boiling water may be ejected.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied persons
in order to avoid a hazard.
3
! This appliance generates heat during use. Adequate precaution must be taken to
prevent the risk of burns, scalds, res or other damage to persons or property caused
by touching the exterior whilst in use or during cooling.
! Never use this appliance for anything other than its intended use. This appliance is for
household use only. Do not use this appliance outdoors.
! Always ensure that hands are dry before handling the plug or switching on the
appliance.
! Always use the appliance on a stable, secure, dry and level surface.
! Never use a power base other than the one supplied with the appliance.
! This appliance must not be placed on or near any potentially hot surfaces (such as a
gas or electric hob).
! Do not use the appliance if it has been dropped, if there are any visible signs of
damage or if it is leaking.
! Ensure the appliance is switched off and unplugged from the supply socket after use
and before cleaning.
! Always allow the appliance to cool before cleaning or storing.
! Never immerse any part of the appliance or power cord and plug in water or any other
liquid.
! Never let the power cord hang over the edge of a work top, touch hot surfaces or
become knotted, trapped or pinched.
! Never leave the appliance unattended when in use.
! Beware of steam coming from the spout or lid especially during relling. Never open
the lid during the boiling cycle.
! Never ll the appliance when it is positioned on the power base.
! Never use the appliance without sufcient water in it for it to operate correctly.
! Never allow the appliance to boil dry.
! Always operate the appliance with a cup or suitable container placed below the
dispensing nozzle.
4
IDENTIFYING THE PARTS
1. Removeable drip tray
No mess, just lift it off the power base and rinse under the tap. Holds over 1 cup of
water before it needs emptying.
2. Removable stainless steel drip tray cover
3. Dispensing nozzle
4. Stop button
Press to immediately stop the boil sequence or to stop water that is being dispensed.
5. Start button
Press to start the boil sequence.
6. Dispensing control
This control allows you to select the amount of water dispensed by your HotCup
™
.
Move it towards for less water or for more water.
7. Lid ap release button
Press to open the lid ap only and ll the water tank.
8. BRITA
®
Memo
Shows you when you need to change the BRITA® MAXTRA® water lter cartridge.
9. Removable lid
The complete lid can be lifted off your HotCup
™
to access the lter and lter funnel.
10. Filter funnel and lter cartridge (inside water chamber)
11. Water chamber
12. Power base
13. BRITA
®
MAXTRA® water lter cartridge
5
6
PREPARING THE BRITA® MAXTRA® CARTRIDGE
1. Remove the cartridge from its wrapping (it is normal for the
cartridge to appear moist during storage).
2. Immerse the cartridge in cold tap water and shake gently to
remove any air bubbles. There is no need to pre-soak this
cartridge before use.
3. Lift the complete lid off your HotCup
™
and remove the lter
funnel. Insert the cartridge into the lter funnel and push it
rmly into place. When correctly tted, the cartridge should
remain in place when the funnel is turned upside-down.
4. Fill the lter funnel with cold tap water up to the MAX mark
and allow it to lter through discarding the water. Repeat
this process, again discarding the water.
5. The BRITA
®
MAXTRA® cartridge is now ready for use. You
do not need to keep the lter cartridge immersed in water.
Ret the lter funnel and lter into your HotCup™. Replace
the lid.
6. Always make sure that you have spare MAXTRA
®
cartridges to hand. When buying new cartridges look for
the BRITA® MAXTRA® logo on the cartridge packaging.
7. When it is time to replace the BRITA
®
MAXTRA® lter
cartridge after 4 weeks use, simply lift the handle on top
of the cartridge and pull upwards to remove. BRITA®
cartridges are 100% recyclable. Visit www.brita.co.uk or
call the BRITA® Care team on 0844 742 4800 for further
information on participating retailers.
8. Repeat steps 1-5 with a new cartridge.
Loading...