Bretford EPM, LAP16H B User Manual

LAPTOP 16H

Instruction Manual

LAP16H B/EPM; F/EPM, FN/EPM

16 Bay Horizontal laptop storage

& recharging trolley with

power management

Instruction Manual

Before proceeding check the contents and familiarise yourself with the internal layout of the cart.

Contents:-

2 sets x front and rear door keys (located on top of cart).

·

IEC adaptor leads - Quantity 16 x IEC to figure eight and clover leaf connectors located inside the

·

laptop storage area.

Mains lead = 13amp plug – IEC connector located inside the power and adaptor storage area.

·

Cart layout:-

IEC power strip

Area for mounting
a network switch
(network switch
not included)

Power pack

storage area

Laptop shelves

Timer module

1

LAPTOP 16H

The LAP16H is specifically designed for the storage and recharging of up to laptops. To assemble/configure your new
charging trolley, simply follow the steps below...

Ventilation:

All vents MUST be kept clear at all times, no posters etc. covering the perforations.
Also ensure there is a minimum of 50mm clearance between the back and sides of the
cabinet to ensure good air flow.

Fans

If fans are fitted: Whilst charging, if the temperature in the cabinet exceeds 30° the fans will
automatically initiate. The fan guards MUST be kept clear at all times, including allowing a
minimum of 75mm clearance between the back of the cabinet and the wall to ensure good
air flow. The fans will continue to run until the temperature drops below 30°.
However, if the room has a high ambient temperature this may cause the fans to remain on.

DO NOT CONNECT TO THE MAINS SUPPLY UNTIL STEPS 1-10 ARE COMPLETE

Step 1: Open the rear doors to reveal 16 power pack shelves and the IEC power strip.
As shown on page 1.

Step 2: Remove the mains/3pin plug lead (if fitted) from the laptop power pack and
store in a safe place.

Step 3: All LAP16H models are supplied with 16 x IEC to
figure of eight & 16 x IEC to cloverleaf cables to be connected into the
laptop power pack & the IEC power strips. Firstly select the leads with
corresponding connector for the power packs being used in the cart.

Step 4: Connect an IEC connector into the top IEC power strip. Continue this action

Clover leaf

Figure of eight

IEC

until all 16 IEC leads are connected.

Step 5: Starting with the top IEC lead plug the connector in to the laptops power pack.

2