Brennenstuhl L801, L801 PIR User guide

L801 IP 55 / L801 PIR IP 55

Directions for use..........................................

5

User Manual

High Performance LED Light
L801 IP 55
L801 PIR IP 55 (Incl. Motion Detector)

Carefully read this instruction manual before installing the system.
Keep the user manual in a safe place and pass it on together with the
product.

Important:
Installation only by trained technical staff observing all standards
and technical requirements for correct installation.

LED lights are extremely bright. Do not look into the light beam,
since this can cause permanent eye damage.

Select Location

• For best results install the light on a solid surface approx. 2 m above
ground level.

• Select a location under the roof overhang for installation.

L801 PIR IP 55 only:

• Do not direct the motion detector towards a swimming pool, heating
ducts, air conditioners or objects with extreme temperature changes.

• Do not direct the motion detector towards trees or bushes or places
where pets could stay.

• Remember before installing the light that the motion detector is
most sensitive to motion across the covered area and least sensitive
to motion towards the sensor.

5

User Manual L801 IP 55 / L801 PIR IP 55

Installation / Wiring

• Loosen the screws to remove the base plate.

• Use the base plate to mark the drill holes in the desired location.
Drill the marked holes and ensure not damaging hidden pipes or cables.

• Feed the mains power cable through the rubber grommet.

• Secure the base plate with suitable wall plugs and fasteners in the
desired location.

• Observe the cable diagram for wiring and ensure proper connection
of cables and screws.

Power supply

Earth

(green/yellow)

Neutral

(blue)
Phase

(black or brown)

This light must be earthed!

• Replace the light with the two cap screws on the base plate.

Maintenance instructions:

Do not open the LED unit. The LEDs cannot be replaced.
Any contact can damage the LEDs.
Immediately replace a damaged protective cover. Do not use the light
without flawless protective cover. Clean light and motion detector with
a damp cloth, if necessary.

Do not use any chemicals or aggressive

agents for cleaning the device.

L801 PIR IP 55 only:
Light system setting

At the bottom there are 2 control knobs.

To fitting

Earth
(green/yellow)

Neutral
(blue)

Phase
(black or brown)

6