11 Declaration of conformity................................................................................................. 18
Directions for use 12
Outdoor multiple socket outlet with spike
1 Introduction
This handbook must be carefully read in its entirety.
It forms an essential part of your newly acquired product and contains important instructions for
its operation and use.
Always follow all the safety instructions when using the product. If you have any queries
concerning the use of the outdoor socket outlet, contact your dealer or our service centre. This
handbook should be kept in a safe place and, if applicable, passed on to the next user.
2 Pack contents
Immediately on unpacking your outdoor socket outlet, check the contents for completeness and
inspect the product to ensure that it is in perfect condition.
1 x Outdoor multiple socket outlet
1 x Spike
1 x User's handbook
3 Specified use
The multiple socket outlet with spike is designed for outdoor use. It is not suitable for use on
building sites or under other extreme conditions. It can easily be driven into the ground by hand.
Any use other than as specified in this handbook is specifically disallowed and will lead to its
becoming damaged. Potential hazards must also be taken into account; misuse could result in an
electric shock, short circuit, fire, etc.
4 Safety precautions
NOTE: To prevent physical injury or material damage, follow the instructions below without
fail.
Operating conditions: Although the socket outlet is protected against moisture and water, it is
not watertight and must not, therefore, be operated in water or near running water.
DANGER: Failure to observe this instruction could lead to an electric shock, possibly fatal.
Any damage resulting from a failure to observe the directions in this handbook, particularly the
safety precautions and the instructions on the use of the product, will invalidate the guarantee.
Similarly, no liability will be accepted for consequential damage.
This handbook should be kept in a safe place and, if applicable, passed on to the next user.
Directions for use 13
Outdoor multiple socket outlet with spike
The keywords and symbols used in this handbook signify the following:
Symbol Keyword/meaning Symbol Keyword/meaning
DANGER:
Failure to observe will give
IMPORTANT:
What you should do
rise to a high risk of physical
injury, possibly fatal.
ARNING:
W
Failure to observe will result
NOTE:
Detailed explanation
in a moderate risk of
physical injury.
CAUTION:
Slight risk of physical injury,
TIP:
Useful tips
material damage or product
damage.
- Do not place the socket outlet in a position where it is likely to be exposed to heat, e.g. in
direct sunlight, and keep it uncovered when in use.
- The socket outlet is to be connected only to an earthed three-pin socket.
- If in any way faulty, the socket outlet must not be used. Do not, under any circumstances,
continue to use the rubber-insulated cable if the insulation is damaged. If this occurs, it must
be replaced by an approved cable and plug complying with the same specification.
- Care must be taken to ensure that the socket outlet is positioned vertically in well consolidated
soil (the spike should be driven into compacted earth to an adequate depth).
- The socket outlet may only be used in areas where there is no possibility of water collecting.
To prevent live parts from coming into contact with water, it must be set up at least 0.5 m from
ponds, streams, etc.
- Before it is moved to another position, it must be disconnected from the mains power supply.
In addition, all the connected electrical appliances must be unplugged.
- If the socket outlet falls over, it must be inspected to ensure that no water has got into the
sockets before it is used again.
- The sockets may only be opened up by a qualified technician. Interventions of this nature
entail a risk of injury, possibly fatal, through an electric shock.
- If the socket outlet falls from a moderate height, it must be inspected for any obvious defects.
Before it is used again, contact a qualified technician and have it inspected by him.
- Never leave children unattended in the vicinity of the socket outlet. Children underestimate the
potential dangers of electrical appliances.
- If thunderstorms occur, disconnect the socket outlet from the mains power supply immediately,
otherwise it could be damaged.
- Take care to ensure that the mains cable does not present a trip hazard.
- The socket outlet contains no components requiring maintenance by the user.
- A waterproof effect with a connected plug will only be achieved if the plug itself is likewise
waterproof (IP 44).
Directions for use 14
Outdoor multiple socket outlet with spike
- The socket outlet may only be connected to a socket which is protected by an earth leakage
circuit breaker with a maximum tripping current of 30 mA.
- If an additional extension lead is needed, use a lead approved for use out of doors with a plug
connector complying with type of protection IP 44. This will reduce the risk of an electric shock.
- Do not plug one extension socket into another.
- If two, three or more sockets are used at the same time, take care to ensure that the current
rating of 16 A is not exceeded.
5 Technical data
Multiple socket GS 2 DE
GS 4 DE
Type of protection: IP 44 (waterproof)
Voltage rating: 250 V ~ 50 Hz
Current rating: 16 A
Max. output: 3680 W
Cable: Rubber-insulated cable H07RN-F 3G1.5
Length: 1.5 m/10 m
Directions for use 15
Outdoor multiple socket outlet with spike
6 Product guide
An illustration showing the major components and indicators of the product is given below,
together with a brief description of their functions.
5
4
(Illustration: GS 4 DE)
No. Description Function
1 2 or 4 sockets with
hinged covers
2 Connecting lead Power supply
3 Plug (IP 44) For connection to a socket outlet with earthing contact
4 Spike Secures the product in the ground
5 Handle Permits removal from the ground
Connecting sockets for electrical appliances
(IP 44)
1
2
3
7 Installation and use
The basic functions of the socket outlet are explained in this section.
Read it through carefully so that you are able to understand and make use of it to the full.
IMPORTANT: Observe the following instructions, particularly the safety precautions, in order
to avoid operating errors and possible defects.
If problems arise, refer to the list of faults (Section 9) or contact our service centre (for contact
details, see Section 10).
Directions for use 16
Outdoor multiple socket outlet with spike
7.1 Entry into service
Step Description
1
For the GS 2 DE and GS 4 DE models, the spike is separate and must be screwed
to the garden outlet prior to use.
2
Secure the socket outlet in the ground with the pointed spike.
WARNING: Observe the safety precautions, particularly those relating to the
location of the product.
3
Pulling out the socket outlet
WARNING: Before pulling the socket outlet out of the ground, disconnect it
from the mains power supply. In addition, unplug all the electrical appliances
connected to it.
Only use the handle to remove socket outlet from the ground.
8 Cleaning
Before cleaning the socket outlet, disconnect it from the mains power supply. For reasons of
electrical safety, clean the product with a dry or moist cloth. Do not use any sharp cleaning
utensils or chemicals (solvents, petrol, etc.) or a scouring sponge. Never immerse the socket
outlet in water.
9 List of faults
Fault Possible cause(s) Remedy
Socket outlet will not work - No mains power supply - Check mains power supply
Socket outlet will not work - Mains cable/ plug faulty
- Internal wiring faulty
IMPORTANT:No other repairs may be carried out except by a qualified technician.
- Check connecting lead
- Check housing for external
damage
10 Adress
Hugo Brennenstuhl GmbH & Co. KG
Seestraße 1-3 · 72074 Tübingen · Germany
H. Brennenstuhl S.A.S. · 5 rue de l'Artisanat · F-67460 Souffelweyersheim
lectra-t ag · Blegistrasse 13 · CH-6340 Baar
For further information please see our Service/FAQ section at www.brennenstuhl.com
Directions for use 17
Outdoor multiple socket outlet with spike
11 Declaration of conformity
The product qualifies for the CE mark by complying with the following European Directives:
2006/95/EC Low Voltage Directive
2004/108/EC EMC-Directive
The Declaration of Conformity is in the possession of the manufacturer.
Manufacturer:
Hugo Brennenstuhl GmbH & Co. KG, 72074 Tübingen, Germany