Breckwell SPG9000 Owner's Operation And Instruction Manual

Owner’s Operation and Instruction Manual
Exceptional Heat, Outstanding Value
®
BRECKWELL
This appliance is Certied for instal-
lation in the USA and Canada.
Tested per UL 1482-2010, and
ULC-S627-2000.
This appliance may be installed in a
MODEL:
SPG9000
PATENT PENDING
CAUTION! Please read this entire manual before you install or use your new room heater. Failure
to follow instructions may result in property
damage, bodily injury, or even death.
Improper Installation Could Void
Your Warranty!
SAVE THESE INSTRUCTIONS
THIS MANUAL WILL HELP YOU TO OBTAIN EFFICIENT, DEPENDABLE SERVICE FROM THE HEATER, AND ENABLE YOU TO
ORDER REPAIR PARTS CORRECTLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
If this heater is not properly installed, a house re
may result. For your safety, follow the installation instructions. Never use make-shift compromises during the installation of this heater. Contact local building or re ofcials about permits, restric­tions and installation requirements in your area.
manufactured or mobile home.
Refer to markings on the appliance
for additional information.
SAFETY NOTICE:
Breckwell Hearth Products
P.O. Box 750
Bridgeport, AL 35740
852016 rev A
CONGRATULATIONS!
You’ve purchased a heater from North America’s oldest manufacturer of wood burning products.
By heating with wood pellets, you’re helping to CONSERVE ENERGY!
Wood is our only Renewable Energy Resource. Please do your part to preserve our wood supply. Plant at least one
tree each year. Future generations will thank you.
The instructions pertaining to the installation of your pellet heater complies with UL 1482-2010 & ULC-S627-2000 standards.
Combustible : Premium Hardwood Pellets
Colors : Black
Flue Pipe Diameter : 6” (152.5mm)
Flue Pipe Type: (Standard Single Wall or Double Wall): Black or Blued Steel 2100°F (650°C)
Minimum Chimney Height : 12’ (3.7m)
Dimensions
1
/
/
2
” x 43” (635mm x 596.9mm x 1092.2mm)
1
/
2
” (558.8mm x 495.3mm)
1
8
x 10
/
4
(327mm x 5410.2mm)
Overall : Depth x Width x Height : 25” x 23
Door Opening : Width x Height: 22” x 19
Pyroceramic Glass Door : (Viewing) Width x Height: 12
7
FUEL CONSIDERATIONS
Your pellet stove is designed to burn premium hardwood pellets that comply with Association of Pellet Fuel Industries standards. (Minimum of 40 lbs density per cubic ft, 1/4” to 5/16” diameter, length no greater than 1.5”, not less than
8,200 BTU/lb, moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million). Pellets
that are soft, contain excessive amounts of loose sawdust, have been, or are wet, will result in reduced performance.
Store your pellets in a dry place. DO NOT store the fuel within the installation clearances of the unit or within the space
required for refueling and ash removal. Doing so could result in a house re.
OPTIONAL ACCESSORIES
DESCRIPTION PART #
150 CFM Blower Assembly SPGB
Louver Set - Stainless Steel SPGLS
CAUTIONS:
• HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY.
CONTACT MAY CAUSE SKIN BURNS.
• DO NOT USE CHEMICALS OR FLUIDS TO IGNITE THE FIRE.
• DO NOT BURN GARBAGE, FLAMMABLE FLUID SUCH AS GASOLINE, NAPHTHA OR
MOTOR OIL.
• DO NOT CONNECT TO OR USE IN CONJUNCTION WITH ANY AIR DISTRIBUTION
DUCTWORK OR SYSTEM.
• ALWAYS CLOSE THE DOOR AFTER THE IGNITION. NEVER OPERATE HEATER WITH DOOR LEFT OPEN (AJAR).
2 Breckwell
WARRANTY INFORMATION CARD
Name__________________________________________ Telephone #: (_____)_____________
City____________________________________________ State_______ Zip_________________
Email Address __________________________________________________________________
Model # of Unit________________________________ Serial #___________________________
Fuel Type: qWood qCoal qPellet qGas qOther _________________________
Place of Purchase (Retailer)______________________________________________________
City____________________________________________ State_______ Zip_________________
If internet purchase, please list website address___________________________________
Date of Purchase _______________________________________________________________
Reason for Purchase: qAlternative Heat qMain Heat Source
qDecoration qCost qOther _________________________
What was the determining factor for purchasing your new appliance?_______
I have read the owner’s manual that accompanies this unit and fully understand the:
Installation
Print Name Signature Date
Please attach a copy of your purchase receipt.
Warranty not valid without a Proof of Purchase.
Warranty information must be received within 30 days of original purchase.
Detach this page from this manual, fold in half with this page to the inside and tape together. Apply a stamp and mail to the address provided. You may use an envelope if you choose.
q
Operation q and Maintenance q of my new appliance.
You may register online by going to Breckwell.com
All information submitted will be kept strictly condential. Information provided will not be sold for advertising purposes.
Contact information will be used solely for the purpose of product notications.
" CUT HERE " CUT HERE
Breckwell 3
Fold Here
Fold Here
Ê É
Fold Here
PLACE STAMP
HERE
Breckwell Hearth Products P.O. Box 750 Bridgeport, AL 35740
4 Breckwell
" CUT HERE " CUT HERE
Safety Precautions
IMPORTANT: Read this entire manual before
installing and operating this product. Failure to do so may result in property damage, bodily injury, or even death. Proper installation of this stove is
crucial for safe and efcient operation.
Contact your local building officials or
authorities having jurisdiction to obtain a permit and information on any additional installation restrictions or inspection requirements in your area.
Do not throw this manual away. This manual has
important operating and maintenance instructions that you will need at a later time. Always follow the instructions in this manual.
This appliance is designed for the use of pelletized fuel
that meet or exceed the standard set by the Pellet Fuel
Institute(PFI), The use of other fuels will void warranty.
This appliance is a freestanding heater. It is not in-
tended to be attached to any type of ducting. It is not a furnace.
HOT WHILE IN OPERATION. Do not touch the hot
surfaces of the stove. Educate all children on the dangers of a high-temperature stove. Young children should be supervised when they are in the same room as the stove.
Never use gasoline, gasoline-type lantern fuel,
kerosene, charcoal lighter uid, or similar liquids to start or ’freshen up’ a re in this stove. Keep all such
liquids well away from the stove while it is in use.
Do not place clothing or other ammable items on or
near this stove.
The fuel loading lid and stove top will be hot during
operation; therefore, you should always use the provided tool or some type of hand protection when refueling your stove.
WARNING! DO NOT INSTALL IN SLEEPING ROOM.
THE STRUCTURAL INTEGRITY OF THE MOBILE
HOME FLOOR, WALL, AND CEILING/ROOF MUST BE MAINTAINED.
Allow the stove to cool before performing any
maintenance or cleaning. Ashes must be disposed
in a steel container with a tight tting lid, and moved
outside immediately. The closed container of ashes should be placed on a non-combustible surface or on the ground, well away from all combustible materials,
pending nal disposal.
Never try to repair or replace any part of the stove un-
less instructions for doing so are given in this manual. All other work should be done by a trained technician.
The exhaust system should be checked monthly during
the burning season for any build-up of soot or creosote.
Use of outside air is required for Canadian installations
on this unit, and may be used for tightly constructed homes in the USA.
Do not operate your stove with the viewing door open.
A safety concern may arise from sparks or fumes entering the room.
Never block free airow through the open vents of the
unit.
Keep foreign objects out of the fuel chamber.
This appliance is not intended for commercial use.
CARBON MONOXIDE (CO) HAZARD. A buildup of CO
fumes is toxic and can be fatal. Carbon Monoxide is a colorless, odorless gas produced during combustion of wood, coal, oil, gas and by other fuel burning appliances. It is important to have a proper draft and adequate replacement air ventilation so fumes are drawn out the chimney. Installed as instructed this stove is designed to be as safe as possible yet it is recommended to install a CO detector. Follow the manufacturer’s recommendations for proper installation and use. It is recommended to be placed
at table-top level (not near the ceiling) to avoid false
alarms. Realize that devices other than a stove (i.e.
motor exhaust) can trigger CO alarms.
If alarm sounds:
• Recognize the symptoms of CO poisoning (headaches, nausea & drowsiness).
A working smoke detector must be installed in the same
room as this product.
Install vent at clearances specified by the vent
manufacturer.
Do not connect the vent to a vent serving any other
appliance or stove.
Do not install a ue damper in the exhaust venting
system of this unit.
Your stove requires periodic maintenance and cleaning
(see ”MAINTENANCE ”). Failure to maintain your stove
may lead to improper and/or unsafe operation.
Breckwell 5
• Increase ventilation (open windows & doors).
• Make sure stove doors and/or lids are closed and
secured.
• Check stove for smoking or puffing (open airflow controls).
• Check chimney & connector pipe for leaks, blockage or
down-draft conditions.
• Check CO device for false alarm.
TOOLS AND MATERIALS NEEDED FOR INSTALLATION
Chimney Connector
You will need a drill with a 1/8” bit to install sheet metal screws
into connector pipe. A non-combustible oor protector as specied in this manual. All chimney and chimney connector
components required for your particular chimney installation.
Mobile Home Installations
Manufactured or Mobile home installations require that the
a solid fuel burning appliance be attached to the oor of the
mbile home. For this appliance, means are provided within
the pedestal area for such. You must rst remove the two
plugs to expose the mounting holes. You can then use the
means necessary to attach the appliance to the oor.
Never remove these plugs except for attaching purposes.
Floor Protection (Ember Protection)
This heater must have a non-combustible oor protector (ember protection) installed beneath it if the oor is of combustible material. If a oor pad is used, it should be UL listed or equal. The oor pad or non-combustible surface
should be large enough to extend a minimum of 6-inches [152mm] in front and 2-inches [51mm] on each side of the heater. The area under a horizontal run of the chimney
connector must also be protected; extending two (2) inched
beyond the outer dimension of the horizontal connector.
Remove Plug for Floor Attachment
Canadian installations require a minimum of 18-inches [450mm] beyond the front of the unit and 8-inches[200mm] beyond each side of the unit
A Floor Protector of ¼ inch thick is recommended for this installation.
FLOOR PROTECTOR
The minimum sized oor protector for this stove is 26-
1/2” x 33” [673mm x 838mm] . Consult local building
codes and re protection ordinances.
Front Sides Rear
6”
(152mm)2”(51mm)
2”
(51mm)
REAR
SIDE
SIDE
FRONT
6 Breckwell
Loading...
+ 14 hidden pages