Page 1
Caution: You must read this before you proceed.
Dining Chair
Page 1 OF 6
Page 2
Label Picture Description QTY
A Chair Back 1
B Chair Seat 1
C Front Legs 2
Label Picture Description QTY
①
Dia. M8 Bolt:
90mm(L)
4
②
Dia. M8 Bolt:
65mm(L)
5
③
Flat Washer Ring 9
④
Spring Washer
Ring
9
⑤
Allen Key 1
Page 2 OF 6
Page 3
Unpack
all the
parts for
a clear
overview
Before Beginning Assembly:
Pack B for Locking the Front Legs
to the front corner blocks of the
seat：
Four Dia.M8 Bolt:65 mm(L)+four
Flat Washer+four Spring Washer
Allen Key
Pack A for locking the back panel
of the seat to the horizontal panel
of the backrest:
Four Dia.M8 Bolt:90mm(L)+one
Dia. M8 Blot:65mm(L)+five Flat
Washer+five Spring Washer
Page 3 OF 6
Page 4
Step 1
Chair Back
Step 2
Put the chair back( A) onto a flat table or panel,align the
positioning dowels on the chair seat with the holes located on
the chair back-panel and chair-seat panel.
Use your left hand to push the seat frame bottom horizontally
forwards and hold it for ensuring the chair seat is vertical to the
chair back without gap between them.
With your right hand,lock the middle hole & the corner holes by
using "PACK A" hardware with an Allen key provided.
WARNING !! DO NOT OVER TIGHTEN. OVER TIGHTENING
COULD LEAD TO DAMAGE OF THE PRODUCT. TIGHTEN
ONLY UNTIL SECURE.
Chair Seat
Place the chair back(A) on a soft surface to avoid any scratches
or damages to the product.
REMOVE the non-woven fabric from under the chair seat, take
out the front legs and hardware.
1
1
3
2
3
2
Page 4 OF 6
Page 5
Step 3
Step 4
With the chair bottom up, place the seat surface on a flat table
top as shown in picture 1 .
Insert each front leg completely vertically into each seat frame
corner,PRESS FIRMLY DOWN with your hand until there is no
gap between the front leg and the seat cushion.
WARNING!! DO NOT POSITION THE FRONT LEG AS
SHOWN IN PICTURE 2 ,WHICH SHOWS THE CHAIR BACK
STAYS AGAINST THE GROUND AND THE FRONT LEGS
LIES horizontally.
Now tighten the bottom bolt at first, then the blot on the top by
using pack B with your hands, please do not tighten the top bolt
first.
WARNING!! DO NOT OVER TIGHTEN. OVER TIGHTENING
COULD LEAD TO DAMAGE OF THE PRODUCT. TIGHTEN
ONLY UNTIL SECURE AND STABLE.
If wobble
Test again
30cm 50cm
Page 5 OF 6
Page 6
Step 5
Place the velcro non-woven fabric cover back underneath the
chair seat from where it was removed from originally.
Place the chair on a LEVEL SURFACE to see if it is wobbling.
If it is, hold the chair with your two hands and hang it at 30cm to
50cm height from the ground.
Drop it freely and vertically with the four legs falling on the
ground at the same time. Test again to see if the chair is
wobbling on the LEVEL SURFACE. Now tighten all the bolts
untill the chair is not wobbling on the LEVEL SURFACE.
WARNING IF CHAIR IS NOT STABLE ,IT COULD LEAD TO
DAMAGING THE PRODUCT.
Page 6 OF 6
Loading...