Assembly Instructions
Caution : You must read this before you proceed
DINING TABLE
Parts list
Label Picture Description QTY
A Table Top 1
B Leg 4
Hardware
Label Picture Description QTY
JCBC Bolt
①
( M8 x 60mm )
9
Page 1 OF 5
② Allen Key ( M5mm ) 1
③ Spring Washer 9
④ Flat Washer 9
Assembly Preparation
Before
Beginning
Assembly:
• Read instructions, cover to cover-
• Have 2 adults on hand for assembly-
• Do not assemble on flooring or carpet-
• Assemble on a clean non-marring surface (packing foam)-
• Save all packaging untill finished-
Assembly Steps
Overview
(A)
(B)
FRONT FACING
Page 2 OF 5
This table has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the parts, the above picture is to help you put the various
parts into perspective. Please read through the instructions herebelow to
familiarise the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean,non-marring surface.
Step 2
(B
(A
Place the table (A) onto a clean, soft surface to avoid any scratches or
to the product.
Align the Leg (B) into the mortise Table Top (A) as shown above.
Then insert Flat Washer (④), Spring Washer (③) and JCBC Bolt (①)
into hole coner with Alley Key(②).
Do not fully tighten the Bolts.
Page 3 OF 5
Step 3
Turn the table side up.
inspect it and make sure all parts are adequated connected.
Place the Table on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Table some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the product freely and vertically with the four legs, hitting the
ground, at the same time.
This Drop Test will help to ensure that all parts and gaps reach full
alignment status.
Test again for evenness on a LEVEL SUCFACE.
If no wobbles found, proceed to tighten all the Bolt and Screws at all
joints.
When tightening the Bolts and Screws, tighten sequentially.
DO NOT tighten any Bolt or Screw fully and then move on
towards the next one.
This would couse the frame to warp.
If there is still wobbles, loosen the Bolts and execute this same
drop test.
Page 4 OF 5
Step 4
Your Dining Table ready for use.
This Dining Table can only be used on a flat, level surface.
Care & Maintenance
Page 5 OF 5
Loading...