Page 1
PEDESTAL & POST TABLES
SSEMBLY INSTRUCTIONS
A
COMPONENTS
Table Top Assembly
Quantity: 1
HARDWARE
Hex Nut
A
Quantity: 1
Locking Hex Nut
B
Quantity: 1
Pedestal Post
Quantity: 1
C
Flat Washer
Quantity: 1
3
Rod
Quantity: 1
D
Lock Washer
Quantity: 1
4
Pedestal Base
Quantity: 1
Stud
E
Quantity: 2
Plastic Grommet
F
Quantity: 1
NOTES
Table top, post and or base may vary from illustrations but the assembly is the same for all bar & bistro tables. 17”
base fits 24” table tops and 32” round bistro tables.
23” base fits 32” round and square bar tables and 36” round and square bar and bistro tables
Page 2
STEP 2 (detail)
Thread rod into table top snuggly until you feel it hit
the table top. NOTE: Do not over tighten in this step.
Once you feel the rod is snug, reverse the rod about one
half a turn. Tighten hex nut securely with wrench.
INSTRUCTIONS
STEP 1
Thread one of the hex nut onto one end of rod
about one inch.
STEP 4
Next, thread the studs into the base with the flat
head facing down and pointed head facing up.
NOTE: Thread the stud only until it is flush with the bottom
of the base.
STEP 5
Place plastic grommet over threaded rod aligning two
holes with the holes in the post. NOTE: Align small drain
with drain hole in base. Next, carefully place the pedestal
base over the post making sure to line up the studs with
the holes in the plate as shown.
STEP 3
Slide pedestal post over the rod and align notches with
small plate on bottom of table as shown.
2
E
Detail (inside Pole)
STEP 6
Insert flat washer , lock washer and locking hex nut
over the rod and secure tightly using wrench.
A
3
3
1
E
Base
Post
A
2
4
E
F
F
1
4
Drain Hole
C
D
B
C
D
B
Page 3
BAR STOOL
ASSEMBLY INSTRUCTIONS
COMPONENTS
Seat Assembly
Quantity: 1
HARDWARE
A
Quantity: 4
Leg Assembly
2
ltShort Machine Bo
18 mm Bolt
B
Quantity: 4
Washer
C
Quantity: 4
3
Stretcher
D
Allen Wrench
Quantity: 1
Page 4
STEP 2
Place washer on bolt . Next, hand tighten bolts
into the pre drilled holes in the corner. Repeat for all
corners.
STEP 3
Next, insert the Stretcher as shown and secure using
the 18 mm bolts provided.
STEP 4
Tighten all four bolts with the allen wrench provided
Step 3 Detail
INSTRUCTIONS
STEP 1
Line up Bar Stool Seat Assembly onto Leg Assembly
to the pre drilled holes on the seat assembly as shown.
Note: Curved part of leg assembly lines up with the back
of the chair.
STEP 5
Turn upright and enjoy
A
A
A
C
C
2
B
2
C
C
C
A
A
B
B
3
B
B
3
Loading...