Page 1
Assembly Instructions
8-Light LED Bar Pendant
Important: Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.
This light should be installed by a licensed electrician
LAMP INSTALLATION AND ASSEMBLY
1. Shut off power to the outlet box. (fig. A)
2. Determine the height at which the fixture is to be hung. Feed the fixture wires through the stem
sections and canopy on one side. Screw together the stems and canopy to achieve desired length.
3. Using wire nuts, connect the black fixture wire to one of the red transformer output
wires, and connect the white fixture wire to the other red transformer output wire.
4. Attach the mounting plate to the outlet box, secure with outlet box screws.
Use anchors and wood screws for extra support (included)
5. Make appropriate electrical connections using wire nuts:
a. Connect the transformer’s live wire (black) to the live outlet box wire.
b. Connect the transformer’s neutral wire (white) to the neutral outlet box wire.
c. Connect fixture’s ground wire (green or uncoated) to the ground outlet
box wire. If no ground is present in outlet box, connect fixture’s ground
wire to the mounting plate using the green screw (included).
d. Carefully place connections in outlet box.
6. Attach the canopy to the mounting plate, secure with mounting screws.
7. Place the shades on the heat sinks, secure with socket rings.
8. Restore power to the fixture.
transformer
outlet box
mounting plate
anchor
wood screw
outlet box screw
canopy
CARE INSTRUCTIONS
Dusting – Use a clean, dry cloth.
Cleaning – To protect the finish,
avoid any harsh abrasives or chemicals.
Note: This fixture is dimmable with Electronic Low
Voltage (Trailing-Edge) type dimmers only.
wire nut
mounting screw
stem
socket ring
shade
heat sink
threaded stem
Loading...