Label Description QTY
1 Table Top 1
2 Legs 2
3 Connecting Bar 1
Label Description QTY
A Screw (M6 *16MM) 25
B Spring washer (M6) 25
C Flat Washer(M6 *16MM) 17
D Flat Washer(M6*12MM) 9
E M6 Allen key 1
Assembly Instructions
Caution : You must read this before you proceed
Table
Part List
Hardware
Picture
Picture
Page 1 OF 4
OVERVIEW
Assembly Preparation
Before
Beginning
Assembly:
Assembly Steps
*Before beginning assembly of product, make sure all parts are present.
Compare parts withpackage contents list. If any parts is missing or
damaged,do not attempt to assemble the product.
This Table has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the Table parts, the above picture is to help you put the
various Table parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps
before assembly.
Page 2 OF 4
Step 3
Step 1
Hardware Used
A：M6 screw
B：Spring washer
D：Flat Washer(M6*12MM)
Put the two Legs(2) on the ground,then assembly Conecting Bar(3). From one end of the
Conecting Bar to start.
Insert the Connecting Bar(3) by using M6 Screw(A) ,and then Spring Washer(B), Flat
Washer (D), onto the Legs(2), tinghtening with Allen Key(E).Repeat the same process on
the other side.
Position the bottom of the Table top(1) as shown.
And then insert the Legs(2) into the mounting position of Table Top(1).
Attach the Legs(2) by using M6 Screw(A) + Spring Washer(B)+ Flat Washer (C), onto
metal plate of Legs(2), tinghtening with Allen Key(E).
Step 2
Hardware Used
A：M6 Screw
B：Spring Washer
C：Flat Washer(M6 *16MM)
Make sure all parts are connected and securely locked into position.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
2
1
2
3
Page 3 OF 4
Page 4 OF 4
Loading...