Label Picture Description QTY
A Left Leg 1
B Right Leg 1
C
Table Top Frame (with
Suction Cups)
1
D Glass Top 1
Label Picture Description QTY
①
Bolt (M6*20mm) 5
②
Bolt (M6*25mm) 5
③
Allen Key 1
Assembly Instructions
Caution: You must read this before you proceed
Table
Part List
Hardware
Page 1 OF 6
This Table has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the Table parts, the above picture is to help you
put the various parts into perspective. Please read through the instructions
below to familiarise yourself with the parts and steps before assembly.
Assembly Preparation
Assembly Steps
Before Beginning Assembly:
FRONT FACING
Left Leg (A)
Right Leg (B)
Table Top (C)
Glass Top (D)
Page 2 OF 6
Step 2
Step 1
Take out the guards in the four ends of Table Top Frame(C) using Allen
Key(③).
Step2.1：Attach the Table Top Frame(C) to the Left Leg(A) using Bolts(②)
with Allen Key(③) as shown in the picture.
Step2.2：Attach the Table Top Frame(C) to the Left Leg(A) using Bolts(①)
with Allen Key(③) as shown in the picture.
Do not fully tighten the Bolts.
C
③
①
②
③
A
A
C
C
C
③
setp2.1
setp2.2
Page 3 OF 6
Step 3
Stand the Table up.
Firmly press down on the Table with both hands, this pressure will help align
all parts at all joints fully.
Then tighten all Bolts at all joints in a sequential manner.
DO NOT fully tighten a BOLT in one go and then move on to the next.
Rather, In a sequential manner, gradually tighten each Bolt until all
Bolts are evenly secured. This methodology will ensure maximum
evenness once all Bolts are fully tightened.
Attach Table Top Frame(C) to Right Leg(B) using Bolts(①) and Bolts(②)with
Allen Key(③) as shown in the picture.
Do not fully tighten the Bolts.
Step 4
A
C
B
②
③
①
③
Page 4 OF 6
Step 5
Place the Glass Top(D) on the assembled Table Frame.
Caution: The Table and its Parts are Heavy. Two adults are required for
lifting and moving them.
Step 6
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Stand the Ottoman up.
Put Cushion(C) on the Ottoman
Your Ottoman is ready for use.
Place the Ottoman on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully sit onto the Ottoman
This will help to align all parts at all joints.Then get off the Ottoman, and
in a sequential manner, proceed to tighten all Bolts. When tightening the
Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same
process.
Note: This step is done best with the assistance of a second adult.
Your Ottoman is ready for use.
This Ottoman can only be used on a flat, level surface.
Page 5 OF 6
Page 6 OF 6
Loading...