Label Picture Description QTY
A Table 1
B Glass 1
C Foot 4
Label Picture Description QTY
① Allen Key (M4) 1
② Bolt (M6*45mm) 9
③ Washer 9
Assembly Instructions
Caution: You must read this before you proceed
Coffee Table
Part List
Hardware
1 OF 5
Before Beginning Assembly:
Assembly Preparation
2 OF 5
Overview
This Coffee Table has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Coffee Table parts, the above
picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise yourself with the parts and steps
before assembly.
Open the carton and place all the parts onto a clean, non-marring surface.
Attach Foot(C) onto the Table(A) using Bolts(②) and Washers(③) with Allen
Key(①) as shown above. Repeat this step with the remaining three Feet(C).
Do not fully tighten the Bolts.
ATTENTION: There may be some PE wicker that may have covered the
Bolt points. To ease assembly, guide and slide the PE wicker away from
the mounting positions.
DO NOT CUT AWAY any PE WICKER as this would cause the wicker to
unravel!
Assembly Steps
Step 1
FRONT FACING
3 OF 5
Stand the Coffee Table up. Place the Table on a LEVEL SURFACE to check
for wobbles.
If it wobbles, lift the Table some 20mm to 30mm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the table freely and vertically with all four feet, hitting the ground, at the
same time.
This Drop Test will help to ensure that all Bolts and gaps reach full alignment
status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, slowly and carefully, turn the CoffeeTable facedown.
Then, proceed to tighten all Bolts in a sequential manner.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then towards the next one.
If there are still wobbles, loosen the Bolts and execute the same drop
test.
Carefully place the Glass(B) onto the Table(A) with the assistance of your
adult partner.
Your Coffee Table is ready for use.
This Coffee Table can only be used on a flat, level surface.
Step 2
Step 3
4 OF 5
5 OF 5
Loading...