Page 1
Label Picture Description QTY
A Seat 1
B Left Armrest 1
C Right Armrest 1
D Backrest 1
E Seat Cushion 1
F Back Cushion 1
Caution : You must read this before you proceed
Single Chair
Page 1 OF 5
Page 2
Label Picture Description QTY
①
Bolt (M6*20MM) 5
②
Bolt (M6*25MM) 7
③
Allen Key 1
Before
Beginning
Assembly:
Overview
This Single Chair has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the Single Chair parts, the above picture is to help you put the
various parts into perspective. Please read through the instructions below to familiarise
yourself with the parts and steps before assembly.
FRONT FACING
Right Armrest（C）
Left Armrest（B）
Backrest（D）
Back Cushion（F）
Seat（A）
Seat Cushion（E）
Page 2 OF 5
Page 3
Step 1
Step 2
Step3
Open the carton and place all the parts onto a clean, non-marring surface. Take out the
silders in the four ends of the Seat(A ) using Allen Key( ③).
Place the Left Armrest (B) facedown.
Step2.1:Attach Seat(A) to Left Armrest(B) using Bolts(②) with Allen Key(③) as shown
above.
Step2.2:Attach Seat(A) to Left Armrest(B) using Bolts(①)with Allen Key(③) as shown
above.
Do not fully tighten the Bolts.
Attach Backrest(D) to Left Armrest(B) using Bolts(②) with Allen Key(③) as shown above.
Do not fully tighten the Bolts.
B
D
A
③
②
A
③
A
B
A
B
①
③
setp2.2
setp2.1
②
③
Page 3 OF 5
Page 4
Step4
Step5
Step4.1:Attach Seat(A) and Backrest (D)to Right Armrest(C) using Bolts(②) with Allen
Key(③) as shown above.
Step4.2:Attach Seat(A) and Backrest (D)to Right Armrest(C) using Bolts(①) with Allen
Key(③) as shown above.
Step4.3:Attach Seat(A) and Backrest (D)to Right Armrest(C) using Bolts(②) with Allen
Key(③) as shown above.
Do not fully tighten the Bolts.
Stand the Single Chair up.
Put Back Cushion(F) and Seat Cushion(E) on the Single Chair, and stick the vercro.
Place the Single Chair on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully sit onto the Single Chair
This will help to align all parts at all joints.Then get off the Single Chair, and in a
sequential manner, proceed to tighten all Bolts. When tightening the Bolts, tighten
sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same process.
Note: This step is done best with the assistance of a second adult.
Your Single Chair is ready for use.
This Single Chair can only be used on a flat, level surface.
D
A
B
C
D
A
B
C
①
③
setp4.1
setp4.2
②
③
D
A
B
C
setp4.3
②
③
Page 4 OF 5
Page 5
Page 5 OF 5
Loading...