Page 1
Label Picture Description QTY
A Seat 1
B Left Armrest 1
C Right Armrest 1
D
Backrest
1
E Seat Cushion 2
F Back Cushion 2
Caution : You must read this before you proceed
Loveseat
Page 1 OF 5
Page 2
Label Picture Description QTY
①
Bolt (M6*20MM) 5
②
Bolt (M6*25MM) 7
③
Allen Key 1
Overview
This Loveseat has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Loveseat parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps before
assembly.
Before
Beginning
Assembly:
FRONT FACING
Right Armrest（C）
Left Armrest(B)
Backrest(D)
Back Cushion(F)
Seat(A)
Seat Cushion(E)
Page 2 OF 5
Page 3
Step 1
Step 2
Step 3
Open the carton and place all the parts onto a clean, non-marring surface.,Take out the silders in the
four ends of the Seat(A ) using Allen Key( ③).
Place the Left Armrest(B) facedown.
Step2.1:Attach Seat(A) to Left Armrest(B) using Bolts(②) with Allen Key(③) as shown above.
Step2.2:Attach Seat(A) to Left Armrest(B) using Bolts(①)with Allen Key(③) as shown above.
Do not fully tighten the Bolts.
Attach Backrest(D) to Left Armrest(B) using Bolts(②) with Allen Key(③) as shown above.
Do not fully tighten the Bolts.
B
A
D
A
B
A
③
setp2.1
②
③
A
B
①
③
setp2.2
③
②
Page 3 OF 5
Page 4
Step4
Step 5
Step4.1:Attach Seat(A) and Backrest (D) to Right Armrest(C) using Bolts(②) with Allen Key(③) as
shown above.
Step4.2:Attach Seat(A) and Backrest (D) to Right Armrest(C) using Bolts(①) with Allen Key(③) as
shown above.
Step4.3:Attach seat(A) and Backrest (D) to Right Armrest(C) using Bolts(②) with Allen Key(③) as
shown above.
Do not fully tighten the Bolts.
Stand the Loveseat up
Put Back Cushion(F) and Seat Cushion(E) on the Chair, and stick the vercro.
Place the Loveseat on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully sit onto the Loveseat
This will help to align all parts at all joints.Then get off the Loveseat, and in a sequential manner,
proceed to tighten all Bolts. When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same process.
Note: This step is done best with the assistance of a second adult.
Your Loveseat is ready for use.
This Loveseat can only be used on a flat, level surface.
①
③
D
B
C
A
setp4.1
setp4.2
setp4.3
D
B
C
A
D
B
C
A
②
③
②
③
F
F
E
E
Page 4 OF 5
Page 5
Page 5 OF 5
Loading...