Page 1
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJ ON CTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to lose any small parts necessary for
installation.
2. Slide the electrical wires through the pipe thread(G) and tube(E)/(D)/(C)/
(B)/coupling(A). Raise the pipe thread(G) to the coupling of lamp body(F), by
turn it clockwise until tight. Raise the tube(E) insert to the pipe thread, lock it
securely with the tube(D), raise the tube(C)/(B) and coupling(A) to the screw
pipe nipple in order, then by turning it clockwise until tight. Attach the fixture
canopy, fixture plate onto the pipe nipple of the coupling(A), lock it securely
with the lock washer and hex nut.
3. Thread the two mounting screws into the pre-drilled holes in the Mounting
plate spaced the same distance apart as the holes in the canopy.
4. By measuring, determine correct distance hole in mounting plate, then drilled
two holes(by measuring distance hole) in the ceiling at junction box of side;
raise the plastic anchor insert the hole. Attach the mounting plate to the
junction box with two junction box screws and two wood screws, tighten
screws securely with screwdriver. The side of the mounting plate marked
"GND" must face out. The junction box is not included.
5. While holding the fixture body towards the ceiling, connect the electrical wires
as Shown in Fig.2, making sure that all wire nuts are secured. You may have
to wrap the connections with electrical tape. If your outlet has a ground wire
(green or bare copper), connect the fixture ground wire to it. Otherwise
connect fixture’s ground wire directly to the Mounting plate with the green
screw provided. After wires are connected, tuck them carefully inside the
Junction Box.
6. Raise the canopy onto the Junction box, aligning the mounting screws with
mounting hole in canopy and lock it securely with the finial(I) until tight.
7. Install the light bulbs(Not included) in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
Your installation is now complete. Return power to the junction
box and test the fixture.
Green
Screw
(GND)
anchor
washer
A
B
C
D
E
F
Thank you for purchasing our product.
Need assistance with parts or assembly? Please call customer service
©COPYRIGHT ALL RIGHTS RESERVED.
FIG.2
FIXTURE
WIRES
Black or
Smooth
Screw
FIG.1
Wood
Mounting
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
I
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or Bare
Copper(Ground)
G
Loading...