INSTALLATION INSTRUCTIONS FOR FIXTURE
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (FIG. 1)
1. Shut off the power supply at the fuse box or circuit breaker. If
necessary, remove the o l d fixture from ceiling including the
mounting hardware.
2. Carefully remove the new fixture from the packaging and
check that all parts are included as shown in the illustration.
3. Determine the desired hanging height and thread tube (H & I)
to the tube (J). Pass the wires carefully through each tube as
you assemble.
4. Thread the loop (F) to top of the tube (H).
5. Using quick link (G) hang fixture via loops (F) on bottom of
canopy (D) and top of the tube (H).
6. Place the glass shade (L) over the socket (K), then secure
with large spacer (M), small spacer (N) and socket ring (O)
tightly, the plastic wrench (P) provided in the box.
7. Install the bulb (Q) (bulb included) in accordance with the
fixture’s specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!).
MOUNTING THE FIXTURE (Fig. 1)
8. Attach the mounting plate (A) to the outlet box using the outlet
box screws (B). The side of the mounting plate (A) marked
“GND” must face out.
9. Connect the electrical wires as shown in Fig. 2, making sure
that all wire connectors a re secured. If your outlet box has a
ground wire (green or bare copper), c onnect the gro und wire
from the fixture to it. Otherwise, connect the fixture’s ground
wire directly to the mounting plate using the green screw
provided.
10. After wires are connected, tuck them carefully into the ceiling
junction box.
11. Attach the canopy (D) onto the mounting plate (A) by
protruding 2 mounting screws (C) through the mounting holes
of the canopy (D) and secure with the finials (E).
Your installation is now complete. Return power to the outlet box
and test the fixture.
Fig.2
Loading...