
CHAIR
CAUTION: You must read this before you proceed
CAUTION : This Chair is NOT a TOY.
Keep your child / children at bay in the process of assembly.
For turning the Chair and to prevent damage to the Chair, 02 persons may be needed to
execute this action
1

No. Picture Description Qty
A1
A2
B Seat Panel 1
C Backrest Panel 1
Right Leg Panel
Left Leg Panel
1
1
D Backrest Cushion 1
E Seat Cushion 1
No. Picture Description Qty
①
②
Allen Wrench 1
Screw
9
(M7*70mm)
2 of 6

Before Beginning Assembly:
OVERVIEW
Backrest
Cushion (D)
Backrest
Panel (C)
Left Leg
Panel (A2)
Seat
Cushion (E)
Seat Panel
(B)
Right Leg
Panel (A1)
FRONT FACING
This Chair has multiple parts and may require up to some 30 minutes to assemble. To
give you an overview of the Chair, the above picture to assemble to help you put the
various parts into perspective. Please read through the instructions here below to
familiarise the parts and steps before assembly.
3 of 6

Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
2.1) Position Left Leg Panel (A2) to Seat Panel (B) as shown in picture above.
2.2) Attach Right Leg Panel (A1) to Seat Panel (B ), secure by using 2 Screws(②)+Allen
Wrench(①)
Do not fully tighten the Screws.
Step 3
A2
B
A1
With assistance from your adult partners, turn the Chair into the other side.
Repeat the same process of step 2.2 to secure Left Leg Panel (A2) with Seat Panel
(B)
Do not fully tighten the Screws.
4 of 6

Step 4
4.1 With assistance from your adult partners, turn the chair in right side up
4.2 Attach Backrest Panel (C) to Leg Panels by using 4 Screws(②) and Allen
Wrench(①)
Do not fully tighten the Screws.
Step 5
Inspect it and make sure all parts are adequately connected.
Ensure all screws are fully locked into position and secured.
Place Back Cushion (D) and Seat Cushion (E) on to the Chair
Lay down the Chair and tie the magic tape straps of Back Cushion (D) to Backrest
Panel (C) and Seat Cushion (E) to Seat Panel (B) and Backrest Panel (C) as shown
above.Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
5 of 6