Page 1
LED OUTDOOR
LIGHTING
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
!
SAVE THESE INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED:
Wiring supplies
Phillips
Screwdriver
Pliers Wrench
Wire Cutters
as required by
the Canadian
Electrical Code
and/or the
Electrical code
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
4. NOT FOR USE IN LUMINAIRES CONTROLLED BY A DIMMER.
NOTE: Product May Not Look Exactly As Shown In Figures.
INSTALLATION:
Style #1
Screws
4. Note: Refer to the style of
assembly that matches the style
of your fixture.
Style #1
mounting bracket by
tightening the 4 screws.
Attached fixture to
Outlet
Box
Mounting
Bracket
1. Mount the mounting
bracket to outlet box using outlet
box screws (not included). Make
sure the studs on the mounting
bracket are facing out from the
outlet box.
Quebec
Box Screws
(not included)
Black
House supply
Ground wire
Fixture
Ground wire
Star
Washer
Studs
Outlet
White
Cap Nut
2. Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground
screw in the electrical outlet box.
Connect black wire from fixture
to black wire in outlet box and
connect the white wire from
fixture to white wire in outlet
box.
NOTE: Do not disconnect any
pre-wired connections.
3. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
outlet box making sure no bare
wire is visible at the wire nuts.
Install the light fixture to the wall
by aligning the hole(s) in the
fixture with the studs on the
mounting bracket. Secure in
place with cap nut(s) and star
washer (s).
Style #2
Screws
Weather
Resistant
Caulking
(not included)
Style #2
mounting bracket by
tightening the 2 screws.
Attached fixture to
5. After Installation, seal around
the top and side perimeter
between the fixture and the wall
surface with weather resistant
caulking. The bottom should be
left un-caulked to prevent
moisture build-up. Apply a small
amount of weather resistant
caulking around the side
perimeter between the cap nut
and mounting plate.
Loading...