ASSEMBLING & INSTALLATION INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ATTENTION! COUPER LE COURANT AU FUSIBLE OU LE DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
1. Carefully unpack new fixture and lay all the parts on a clear surface.
2. Attach the center tube(H) to the coupling of lamp holder(F) and by
turning it clockwise until tight. Attach the cloth shade(D) onto the
tube(H) and lock it securely with the knurl nut(I).
3. Attach the center tube (B) and column (A) to the protruding pipe
nipple of the shade , by turning it clockwise until tight.
4. Hook in end of arm(C) to the column’s loop and steel shade’s
loop(G).
5．Place the candle sleeve (E) over the lamp holder.
HANGSSING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old fixture from
ceiling, including the old crossbar.
2. Thread nipple (C) into loop (F) until snug.
3. Thread other end of nipple (C) with loop attached into crossbar (D)
until snug.
4. Place lock washer (B) over end of nipple protruding through crossbar
and thread hex nut (A) onto nipple until tight.
5. Take this crossbar assembly and mount to ceiling junction box with
junction box screws (E). Tighten screws securely with screwdriver.
The junction box is not included.
6. Using proper chain pliers to open one end link of the chain provided
and connect to the fixture loop (I). Close the link. Lace the fixture
wires through the chain.
7. Lace the fixture wires through the chain.
8. By measuring, determine correct number of links needed for proper
hanging height. Using proper chain pliers disconnect and discard
remaining chain.
9. Slip loop collar (H) over the chain, then do the same with the canopy
(G).
10. Open the other end link of the chain and hang the fixture on the loop
at the ceiling. Close the link.
11. Feed the fixture wires through the loop (F) and nipple (C) and pull
until taut.
12. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
CONNECTING THE WIRES (Fig.3)
1. Take the black wire from the ceiling junction box and the smooth
wire leg from the fixture and twist bare ends together. Twist wire
connector onto end of wire until snug.
2. Repeat same process with white junction box wire and ribbed wire
leg of fixture wire. NOTE: Twist wires together in the same direction
you twist the wire connector onto wires.
3. If your junction box has a grounding wire (green or bare copper),
attach this wire and the bare copper wire from the fixture together as
step 1.If junction box has no ground wire, attach the bare copper
fixture wire to the green ground screw on the crossbar.
4. Tuck these wire connections neatly into the ceiling outlet box and
then raise the canopy (G) all the way to the ceiling. Raise the loop
(H) and thread onto ceiling loop protruding through canopy
Your installation is now complete. Return power to the junction box
and test the fixture.
Fig.3
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare Copper(Ground)
Fig.1
Fig.2
Loading...