ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
WARNING:
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Mounting Plate (A)
Mounting Screw (B) Wire Connector (C)
FIG.1
Ball Nut (G)
Green Grounding Screw(E)
Installation Steps
Turn off the power at fuse or circuit box
1. Carefully unpack the fixture, lay out all parts on a
clean surface.
Headless screw (D)
Headless screw (D)
Mounting Screw(B)
Fixture Grounding Wire
Green Grounding
Screw (E)
Lock Nut (F)
Outlet Box
House Grounding Wire
Ball Nut (G)
Lock Nut(F)
Mounting Plate (A)
Wire Connector (C)
Fixture Canopy
2. Remove the glass assembly from the fixture canopy
by unscrew two set screws.
3. Before installing the fixture, then remove the foam /
bubble bag from the fixture.
4. Thread two headless screws through the mounting
plate, then secure them with four lock nuts (two on
each side of the mounting plate). Adjust the length
of the headless screws if necessary.
5. Attach the mounting plate to the outlet box by using
two mounting screws.
6. Pull out the source wires from the outlet box. Make
wire connections using wire connectors as follows:
Ball Nut (G)
Bulb Type T10 Max.60W
(not included)
Glass Assembly
Set Screw
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green
grounding screw, and then connect it to the house grounding wire with the wire connector.
Carefully put the wires back into the outlet box.
7. Attach fixture canopy to the wall by aligning headless screws on mounting strap with holes on fixture canopy. Slide
headless screws through holes, secure them with two ball nuts.
8. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
9. Attach the glass assembly onto the frame by aligning holes, secure the set screws from the bottom holes of the glass
assembly into the holes in the bottom of the frame.
Turn on the power at fuse or circuit box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Plate (A)
Green Grounding
Screw (E)
Mounting Screw (B) Wire
Lock Nut (F)
Assembly Kit (1SET)
Connector (C) Headless screw (D)
Ball Nut (G)
Glass
A
A: 12"
B
B: 5-3/4"
Loading...