This bench assimilates the shape of Tree Trunk at the long sides of the bench.
Therefore, the long sides of the bench is irregular in shape and is the intended design.
BENCH
CAUTION: You must read this before you proceed.
Page 1 of 5
Read instructions, cover to cover.
Have 2 adults on hand for assembly.
Do not assemble on flooring or carpet.
Assemble on a clean non-marring surface (packing foam).
Save all packaging until finished.
No.
Picture
This Bench has multiple parts and may require up to some 15 minutes to assemble. To give you an
overview of the Bench parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions here below to familiarise the parts and steps before assembly.
Support Bar
1
1
Description
13
B
No.
1
Before Beginning Assembly:
Qty
Bench
( with Folded Leg Panels)
A
Description
Picture
Washer
(M8.5/16x2mm)
Qty
OVERVIEW
Support Bar (B)
Bench (A)
FRONT VIEW
C
D 13
E Spanner Wrench
Bolt
(M8x25mm)
Page 2 of 5
Step 1
Step 2
Step 3
Attach the Support Bar (B) to the Bench (A)
You may need to apply a little pressure to the Legs - pushing outwards, so as to enable the Support
Bar (B) to be slotted into position.
Using Bolts (C) with Flat Washers (D), tighten the Bolts by using Spanner Wrench(E), as shown in
Pic.1
Loosely tighten the Bolts, up to 80%.
Place the Bench (A) facedown, onto a clean, soft surface to avoid any scratches or damages to the
product.
Lift legs upwards and outwards until the braces are met at position to the base of the bench, as
shown in the above pictures.
Unpack and place all parts on a clean non marring flat surface .
Pic.1
Page 3 of 5
Step 4
Step 5
Secure Legs to Bench by using Bolts (C) and Flat Washers (D) with Spanner Wrench(E) as shown
in Pic.2 at all 8 positions.
Loosely tighten the Bolts, up to 80%. Turn it over and Sit on it.
Then turn it over again, in a sequential manner, gradually tighten each Bolt until all bolts are
evenly secured.
CAUTION: When tightening these screws, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one. This would cause the frame to
warp.
If there is still wobbles, loosen the screws and execute this same drop tests.
WARNING ! IF CHAIR IS NOT STABLE , IT COULD LEAD TO DAMAGING THE PRODUCT.
You are now at the FINAL stage of this assembly.
In a sequential manner, drive in and fully tighten all bolts.
Thereafter, turn the Bench right way up.
The Bench now is ready to be used
Pic.2
Page 4 of 5
Page 5 of 5
Loading...