1
1
CERTIFICATION: UL WET
INSTALLATION INSTRUCTIONS
IMPORTANT
Before assembling your fixture, please make sure thatyou carefully read
through these instruction sheets. Consider having
your fixture installed by a qualified licensed electrician.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations
that may occur. It must be understood that common sense, caution and
care, are factors that can’t be built into any product. These factors must
be supplied by the person(s) caring for and operating the fixture.
GENERAL INFORMATION
All electrical connections must be in accordance with all ordinances,
Local and National Electrical Codes. These fixtures are intended for
mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box
must be directly supported by the building structure and U.L. Recognized.
STEP BY STEP INSTRUCTIONS
Before starting your installation disconnect the Power by turning off the
Circuit Breaker or by removing the fuse at the fuse box. Just turning the
light off at the light switch is not sufficient to prevent electrical shock.
WHAT WE PROVIDE
Mounting Hardware
•
• Crossbar Plate
• 1 x Frosted glass shade
MOUNT STRAIGHT BAR AND WIRE
CONNECTIONS
If there is an existing fixture remove it. Expose the supply
wire from the J-box.
APPLICATION
Wall Fixture
WHAT YOU NEED
Screwdriver
•
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
• 1 x 60W A19 E26
Mount the straight bar to the J-box with
the supplied screws. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts. Connect the
white supply wires to the white fixture wire. Secure with the
supplied wire nuts. Either wrap the green wire around one of
the protruding screws or connect it to the supply ground wire.
Secure all wire with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
2
4
2
CERTIFICATION: UL WET
3
MOUNT FIXTURE TO STRAIGHT BAR
AND INSERT THE BULB
Position the fixture plate over the straight bar.
Align the centre hole of the plate and secure with the
supplied screw knob.
Insert the bulb. MAXIMUM WATTAGE 60W.
DO NOT EXCEED THE WATTAGE AS STATED
ON THE WARNING LABEL AND IN THE INSTRUCTION
SHEETS
SECURE THE GLASS SHADE AND METAL
FRAME
Position the glass shade and metal frame over the
fixture plate. Align the holes of the plate and
secure with the supplied screws.
* This fixture is wet location rated. In order to ensure
that moisture does not enter the outlet box and cause
a short circuit, clear caulking should be used to seal the
space between the fixture mounting bracket and the
wall. Ensure that a space is left at the bottom to allow
for the escape of moisture. It is recommended that
Indoor/Outdoor Silicon Sealant be used for that purpose**
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW FIXTURE
Please ensure that the fitting is cool and
switched off before replacing the bulb.
CAUTION
DO NOT use bulbs that might exceed the
maximum wattage, stated on caution label.
Loading...